FORD FLTM BO 013-2-2000 INDENTATION TEST FOR FLEXIBLE POLYURETHANE FOAM.pdf

《FORD FLTM BO 013-2-2000 INDENTATION TEST FOR FLEXIBLE POLYURETHANE FOAM.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM BO 013-2-2000 INDENTATION TEST FOR FLEXIBLE POLYURETHANE FOAM.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD BO 013-02 Date Action Revisions 2000 11 0 9 Revised Editorial no technical change A. Cockman 1992 07 16 Printed copies are uncontrolled Page 1 of 3 Copyright 2000, Ford Global Technologies, Inc. INDENTATION TEST FOR FLEXIBLE POLYURETHANE FOAM Application This procedure i

2、s used to measure the load necessary to produce a specified indentation in polyurethane foam (slab and/or molded) used for seat padding applications. Apparatus Required Indenter An apparatus having a flat circular indenter foot 50 square inches in area, connected to a load measuring device, and moun

3、ted in such a manner that the specimen can be deflected at a specified rate is required for this test. The apparatus shall be arr anged to support the specimen on a level horizontal plate which is perforated with 0.25 inch holes on 0.75 inch centers to allow for rapid escape of air during the test.

4、Test Specimens Complete assemblies of slab and molded polyurethane foam shall be ut ilized for the test. Conditioning and Test Conditions All test values indicated herein are based on material conditioned in a controlled atmosphere of 23 +/ - 2 C and 50 +/ - 5 % relative humidity for not less than 2

5、4 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Condition all test specimens for 24 h at 72 +/ - 5 F and a relative humidity of 50 +/ - 2 %. 2. Place the test specimen on the supporting plate of the indenter. The specimen position shall be such that

6、 the indentation will be made in the area shown on the Engineering drawing. 3. Bring the indenter foot into contact with the test specimen, apply a preload of 1 lb and determine the height of the test specimen. FORD LABORATORY TEST METHOD BO 013-02 Page 2 of 3 Copyright 2000, Ford Global Technologie

7、s, Inc. 4. The specimen shall then be tw ice deflected 75 +/ - 5 % of the original height, using either rollers or plates as a means of obtaining the deflection. The specimen shall then be allowed to rest for a period of 10 +/ - 5 minutes. 5. Indent the specimen 25 % of the recorded height. Afte r 1

8、 minute (during which time the load is permitted to drift while the dial indicator is maintained at precisely 25 % deflection) read and record the load. Advance the indenter foot to 50 % of the recorded height, allow the load to drift while maintaining the 50 % deflection for 1 minute, and read and

9、record the load. 6. Report the load required to deflect the test specimen at 25 and 50 % deflection. The 1 lb preload is part of the final load and should not be deducted from the final load value. Chemic als, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BO 013-02 Page 3 of 3 Copyright 2000, Ford Global Technologies, Inc. INDENTATION TEST FOR FLEXIBLE POLYURETHANE FOAM SPONGE RUBBER TESTER