FORD ESF-M99J345-A-2012 COATING CONFORMAL SILICATE TO BE USED WITH FORD WSS-M99P1111-A 《保形硅酸盐涂层 与福特WSS-M99P1111-A 一起使用》.pdf

《FORD ESF-M99J345-A-2012 COATING CONFORMAL SILICATE TO BE USED WITH FORD WSS-M99P1111-A 《保形硅酸盐涂层 与福特WSS-M99P1111-A 一起使用》.pdf》由会员分享，可在线阅读，更多相关《FORD ESF-M99J345-A-2012 COATING CONFORMAL SILICATE TO BE USED WITH FORD WSS-M99P1111-A 《保形硅酸盐涂层 与福特WSS-M99P1111-A 一起使用》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 03 2012 02 16 N Status No replacement named N. Benipal, NA 2006 03 09 Revised Inserted 3.0; Deleted 3.1, 3.5, 4 1987 12 01 Released Controlled document at www.MATS Copyright 2012, Ford Global Technologies, LLC Page 1 of 1 COATING, CONFORM

2、AL, SILICATE ESF-M99J345-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is applied as a varnish which reverts to a silicate when cured. 2. APPLICATION This material was released originally as a coating for resistors in instrument clusters. 3. REQUIREMENTS Materia

3、l specification requirements are to be used for initial qualification of materials. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 Thickness, min 0.10 mm (FLTM BI 117-01) 3.3 Adhesion Grade 0 (FLTM BI 106-01, Method B) 3.4 Dielectric Strength, min 20 KV/mm (ASTM D 149) All above tests are to be run on aluminum panels approximately 102 x 152 mm coated with the material on one side.