FORD ESB-M99J215-A-2012 INK VINYL MARKING TO BE USED WITH FORD WSS-M99P1111-A 《油墨乙烯基标识 与福特WSS-M99P1111-A 一起使用》.pdf

《FORD ESB-M99J215-A-2012 INK VINYL MARKING TO BE USED WITH FORD WSS-M99P1111-A 《油墨乙烯基标识 与福特WSS-M99P1111-A 一起使用》.pdf》由会员分享，可在线阅读，更多相关《FORD ESB-M99J215-A-2012 INK VINYL MARKING TO BE USED WITH FORD WSS-M99P1111-A 《油墨乙烯基标识 与福特WSS-M99P1111-A 一起使用》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 03 2012 02 12 N Status No Replacement named N. Benipal, NA 2005 09 13 Revised Inserted 3.0; deleted 3.9 and 4 1963 07 03 Released AS1 #971 Orig./s/D.Jones/N.L.Controlled document at www.MATS Copyright 2012, Ford Global Technologies, LLC P

2、age 1 of 2 INK, VINYL MARKING ESB-M99J215-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is an ink for marking vinyl materials. 2. APPLICATION This specification was released originally for ink used to mark white ESB-M3G37-A, vinyl tape, as an identification on m

3、ain wiring harnesses for light and medium trucks. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 COMPOSITION Infra red analysis indicates this m

4、aterial consists essentially of an alcoholic phosphate ester, such as, tri-hexyl-phosphate as the carrier for the non-volatile constituents, comprised of approximately 50 - 50 resin and black pigment. 3.2 VOLATILES, max 60% 3.3 NON-VOLATILES, min 40% (Evaporate to constant weight at 70 +/- 1 C) 3.3.

5、1 Resin 50% of non-volatiles min 3.3.2 Carbon Black and Graphite 50 +/- 2% of non-volatiles 3.4 CHLORINE CONTENT 9 - 11% (ASTM D 1156) 3.5 PHOSPHORUS PENTOXIDE 10 - 12% 3.6 COLOR Black 3.7 ODOR Neutral 3.8 CONSISTENCY Thick paste ENGINEERING MATERIAL SPECIFICATION ESB-M99J215-A Copyright 2012, Ford

6、Global Technologies, LLC Page 2 of 2 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 TOXICITY Under certain conditions of use, this material could be considered toxic. The Manufacturing Engineering Department shall notify both the Plant Security and the Safety Units of its presence in the Plant. Company activities shall use this material only as recommended by the Security and Safety Units, and using activities shall insure that protective devices are available and used.