FORD ESB-M1C105-A-2008 GREASE - REDUCED POLYETHYLENE - TO BE USED WITH FORD WSS-M99P1111-A 《低聚乙烯含量的润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P12-A FORD WSS-M13P12-A FORD W.pdf

《FORD ESB-M1C105-A-2008 GREASE - REDUCED POLYETHYLENE - TO BE USED WITH FORD WSS-M99P1111-A 《低聚乙烯含量的润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P12-A FORD WSS-M13P12-A FORD W.pdf》由会员分享，可在线阅读，更多相关《FORD ESB-M1C105-A-2008 GREASE - REDUCED POLYETHYLENE - TO BE USED WITH FORD WSS-M99P1111-A 《低聚乙烯含量的润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P12-A FORD WSS-M13P12-A FORD W.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 10 09 N-STATUS Replaced by WSS-M13P12-A L. Schmalz, FNA 2003 10 24 Revised Para 3.0 inserted; paras 3.6 and 4 deleted 1964 03 16 Released AT1 #1112 Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, Inc. Page 1 of 1

2、 GREASE - REDUCED POLYETHYLENE ESB-M1C105-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is an NLGI No. 2 grade of polyethylene grease (ESB-M1C93) reduced 1-20 parts by weight with M-5B58, Inhibited Methyl Chloroform. 2. APPLICATION This specification was release

3、d originally for grease used to lubricate door and glove compartment locks. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 COMPOSITION 3.1.1 Vol

4、atile, as M-5B58 95 +/- 0.5% (10 g, 24 h at 100 +/- 2 C) 3.1.2 Non-Volatile 5 +/- 0.5% Soap Identification Lithium 3.2 FILLER Polyethylene (ASTM D 128) 3.3 SPECIFIC GRAVITY AT 15.6 C 1.260 - 1.320 3.4 WATER RESISTANCE 3.4.1 The material, when applied to metal strips and solvent evaporated, shall wit

5、hstand 168 h at 38 +/- 2 C in a 98 +/- 2% relative humidity atmosphere without breaking. 3.4.2 The material, when applied to metal strips and solvent evaporated, shall withstand 16 h immersion in a bath of running cold water without breaking per ASTM D 1264. 3.5 QUALITY The material shall be free from dirt, lumps, abrasive material, or other impurities and shall be uniform in appearance.