ETSI ES 202 336-10-2011 Environmental Engineering (EE) Monitoring and Control Interface for Infrastructure Equipment (Power Cooling and Building Environment Systems used in Telecom.pdf

《ETSI ES 202 336-10-2011 Environmental Engineering (EE) Monitoring and Control Interface for Infrastructure Equipment (Power Cooling and Building Environment Systems used in Telecom.pdf》由会员分享，可在线阅读，更多相关《ETSI ES 202 336-10-2011 Environmental Engineering (EE) Monitoring and Control Interface for Infrastructure Equipment (Power Cooling and Building Environment Systems used in Telecom.pdf（18页珍藏版）》请在麦多课文档分享上搜索。

1、 ETSI ES 202 336-10 V1.1.1 (2011-09) Environmental Engineering (EE); Monitoring and Control Interface for Infrastructure Equipment (Power, Cooling and Building Environment Systems used in Telecommunication Networks); Part 10: AC inverter power system control and monitoring information model ETSI Sta

2、ndard ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)2Reference DES/EE-02037-10 Keywords control, interface, management, power, system ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non

3、 lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived diffe

4、rence in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware th

5、at the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/p

6、ortal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2011. All rights reserved. DECTTM, PL

7、UGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Associa

8、tion. ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)3Contents Intellectual Property Rights 4g3Foreword . 4g31 Scope 5g32 References 5g32.1 Normative references . 5g32.2 Informative references 5g33 Definitions and abbreviations . 6g33.1 Definitions 6g33.2 Abbreviations . 8g34 AC inverter power system 9g3An

9、nex A (normative): Summary of mandatory monitoring/supervision information and functions 12g3Annex B (informative): Summary of non-mandatory monitoring/supervision information and functions 14g3B.1 AC inverter power system 14g3B.2 AC inverter module 15g3Annex C (normative): Mandatory XML structure a

10、nd elements 16g3C.1 Structure of an XML document for a AC inverter power system 16g3C.2 The specific XML elements of an AC inverter power system . 17g3History 18g3ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)4Intellectual Property Rights IPRs essential or potentially essential to the present document may

11、 have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI st

12、andards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/ipr.etsi.org). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not r

13、eferenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This ETSI Standard (ES) has been produced by ETSI Technical Committee Environmental Engineering (EE). The present document is part 10 of a multi-part

14、deliverable. Full details of the entire series can be found in part 1 1. ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)51 Scope The present document applies to monitoring and control of AC inverter power systems for telecommunication equipment supply using 48 Vdc or 400 Vdc input. The present document doe

15、s not apply to inverters included in UPS which are covered in ES 202 336-3 i.8. The back-up battery connected to the inverter power system is outside the scope of the present document; they are covered in the standard dealing with the control and monitoring of DC system (ES 202 336-2 i.7). The prese

16、nt document defines: The monitored and controlled AC inverter power system architectures. The minimum set of exchanged information required at the interface, described in “natural language“ in text tables. The XML files with tags and variables corresponding to the data in the tables. 2 References Re

17、ferences are either specific (identified by date of publication and/or edition number or version number) or non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the reference document (including any amendments) applies. Referenced

18、documents which are not found to be publicly available in the expected location might be found at http:/docbox.etsi.org/Reference. NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. 2.1 Normative references The fo

19、llowing referenced documents are necessary for the application of the present document. 1 ETSI ES 202 336-1: “Environmental Engineering (EE); Monitoring and Control Interface for Infrastructure Equipment (Power, Cooling and Building Environment Systems used in Telecommunication Networks) Part 1: Gen

20、eric Interface“. 2 ETSI ETS 300 132-1: “Environmental Engineering (EE); Power supply interface at the input to telecommunications equipment; Part 1: Operated by alternating current (ac) derived from direct current (dc) sources“. 2.2 Informative references The following referenced documents are not n

21、ecessary for the application of the present document but they assist the user with regard to a particular subject area. i.1 IEEE 802.1 to 802.11: “IEEE Standard for Local Power supply interface at the input to telecommunications and datacom (ICT) equipment; Part 2: Operated by -48 V direct current (

22、dc)“. ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)6i.5 ETSI EN 300 132-3-1: “Environmental Engineering (EE); Power supply interface at the input to telecommunications and datacom (ICT) equipment; Part 3-1: Operated by rectified current source, alternating current source or direct current (DC) source up

23、to 400 V solution“. i.6 ETSI EN 302 099: “Environmental Engineering (EE); Powering of equipment in access network“. i.7 ETSI ES 202 336-2: “Environmental Engineering (EE); Monitoring and control interface for infrastructure equipment (Power, Cooling and environment systems used in telecommunication

24、networks); Part 2: DC power system control and monitoring information model“. i.8 ETSI ES 202 336-3: “Environmental Engineering (EE); Monitoring and Control Interface for Infrastructure Equipment (Power, Cooling and Building Environment Systems used in Telecommunication Networks); Part 3: AC UPS pow

25、er system control and monitoring information model“. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present document, the following terms and definitions apply: NOTE: Terms referring to energy interface, equipment and distribution are described in power distribution standard

26、s ETS 300 132-1 2, EN 300 132-2 i.4, EN 300 132-3-1 i.5 for ac and dc interface and EN 302 099 i.6 for access network equipment powering. AC inverter power system: device or system that convert DC voltage to AC voltage and provides electrical power without interruption in the event that commercial p

27、ower drops to un unacceptable voltage level alarm: any information signalling abnormal state, i.e. different to specified normal state of hardware, software, environment condition (temperature, humidity, etc.) NOTE: The alarm signal should be understood by itself by an operator and should always hav

28、e at least one severity qualification or codification (colour, level, etc.). EXAMPLE: Rectifier failure, battery low voltage, etc. alarm loop: electrical loop which open or closed state correspond to alarm start (set) or end (clear) state alarm message: text parts of the alarm structure alarm struct

29、ure: organized set of information fields in an alarm data frame (time stamp, set/clear, text, etc.) battery: complete arrangement of battery cells or blocks in one string or more in parallel battery cell: basic electrochemical element (e.g. a 2 V nominal cell for a high capacity lead acid battery) b

30、attery string: number of serially interconnected battery blocks or cells client post: any device (laptop, PDA, console, etc.) connected to servers via the operation system networks to perform maintenance or supervision operations Control form Style Sheet (CSS): simple mechanism for adding style (e.g

31、. fonts, colours, spacing) to Web documents, tutorials, books, mailing lists for users, etc. Control Unit (CU): integrated unit in an equipment to monitor and control this equipment through sensors and actuators ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)7Data Gathering Unit (DGU): functional unit used

32、 for several functions: collect serial, digital, and analog data from several equipment; option to send (output) serial or digital commands; forward/receive information to/from the Local/Remote Management Application via agreed protocols; mediation between interfaces and protocols. NOTE: This functi

33、on may be integrated as part of specific equipment. Dynamic Host Control Protocol (DHCP): protocol used for self configuration of TCP/IP parameters of a workstation assigning IP address and a subnetwork mask NOTE: DHCP may also configure DNS. Dynamic Name Server (DNS): associates a single domain nam

34、e to an IP address dynamic synoptic: dynamic display of geographical maps, networks, installations and equipment ethernet: LAN protocol NOTE: Equivalent to IEEE 802.1 to IEEE 802.11 i.1. event: any information signalling a change of state which is not an alarm: e.g. battery test, change of state of

35、battery charge NOTE: The event signal should be understood by itself by an operator and should always have at least one severity qualification or codification (colour, level, etc.). It should be transmitted in a formatted structure with text message and other fields like for alarm, e.g. an event can

36、 be coded as an alarm with severity “0“. eXtensible Style sheet Language (XSL): language for expressing style sheets NOTE: It consists of two parts, a language for transforming XML documents, and an XML vocabulary for specifying formatting semantics. An XSL style sheet specifies the presentation of

37、a class of XML documents by describing how an instance of the class is transformed into an XML document that uses the formatting vocabulary. infrastructure equipment: power, cooling and building environment systems used in telecommunications centres and Access Networks locations EXAMPLE: Cabinets, s

38、helters, underground locations, etc. intranet: internal company network generally using Ethernet protocol and extended IP addresses logbook: chronological file that contains alarm and event messages may be paper or electronic Management Information Base (MIB): dynamic data base that gathers all obje

39、cts and should evolve to include automatic and manual configuration tools with self coherence tests menu: list of possible input command choices that may be presented in different ways on a display NOTE: Selection is normally made by a keyboard, a pointing device, a mouse or directly by finger on a

40、sensitive screen. object: class description of items that accept a set of properties or functions NOTE: Generic objects can include more specific items and inherit from their properties. If correctly structured, object programming can allow the system to evolve, i.e. be more future-proof. The code s

41、hould intrinsically be open and structured. PHP: powerful tool for making dynamic and interactive Web pages pop-up: information or command screen that appears when a menu choice is selected EXAMPLE: This may be a pop-up menu when the pointer is on a title button. ETSI ETSI ES 202 336-10 V1.1.1 (2011

42、-09)8REpresentational State Transfer (REST): way to build an application for distributed system as www Simple Object Access Protocol (SOAP): way to communicate between applications running on different operating systems, with different technologies and programming languages NOTE: SOAP communicates o

43、ver HTTP, because HTTP is supported by all Internet browsers and servers, SOAP traffic is not blocked by firewalls and proxy servers (see W3C). Systems Management Function (SMF): object properties or classes with projection on CMIS application context communication NOTE: Set of ISO system management

44、 functions according to ISO/IEC 10164 i.2. warning: low severity alarm web: common name for the Internet or Intranet windows: virtual area on the display that corresponds to a specific application World Wide Web Consortium (W3C): consortium founded in October 1994 to develop common interoperable pro

45、tocols and promote World Wide Web NOTE: See http:/www.w3c.org. XCU: CU enabled to communicate using XML interface as defined in the present document XHTML: stricter and cleaner version of HTML. XHTML consists of all the elements in HTML 4.01 combined with the syntax of XML. It can be read by all XML

46、 browser (see W3C) eXtensible Mark-up Language (XML): application profile or restricted form of SGML NOTE: By construction, XML documents are conforming SGML the Standard Generalized Markup Language (ISO/IEC 8879 i.3). documents.XML is designed to describe data and focus on what data is. XML should

47、be discerned from the well known Hypertext Transfer Mark-up Language (HTML) which was designed to display data and to focus on how data looks. XML Schema Definition (XSD): new more detailed XML description compared to the previous one, the DTD 3.2 Abbreviations For the purposes of the present docume

48、nt, the following abbreviations apply: AC Alternating Current CMIS Common Management Information Service CSS Control form Style Sheet CU Control Unit of an equipment DC Direct Current DGU Data Gathering Unit DHCP Dynamic Host Control Protocol DNS Dynamic Name Server HTML Hypertext Transfer Make-up L

49、anguage HTTP HyperText Transfer Protocol IP Internet Protocol LAN Local Array Network MIB Management Information Base PF Power Factor REST REpresentational State Transfer RMA Remote Management Application SBS Static Bypass SwitchSGML Standard Generalized Markup Language SMF Systems Management Function SOAP Simple Object Access Protocol TCP Transmission Control Protocol for IP W3C World Wide Web Consortium ETSI ETSI ES 202 336-10 V1.1.1 (2011-09)9XCU XML enabled CU XML eXtensible Mark-up Language (see W3C) XSD XML Schema Definit