ETSI EN 302 500-2-2010 Electromagnetic compatibility and Radio spectrum Matters (ERM) Short Range Devices (SRD) using Ultra WideBand (UWB) technology Location Tracking equipment op.pdf

《ETSI EN 302 500-2-2010 Electromagnetic compatibility and Radio spectrum Matters (ERM) Short Range Devices (SRD) using Ultra WideBand (UWB) technology Location Tracking equipment op.pdf》由会员分享，可在线阅读，更多相关《ETSI EN 302 500-2-2010 Electromagnetic compatibility and Radio spectrum Matters (ERM) Short Range Devices (SRD) using Ultra WideBand (UWB) technology Location Tracking equipment op.pdf（13页珍藏版）》请在麦多课文档分享上搜索。

1、 ETSI EN 302 500-2 V2.1.1 (2010-10)Harmonized European Standard (Telecommunications series) Electromagnetic compatibilityand Radio spectrum Matters (ERM);Short Range Devices (SRD) usingUltra WideBand (UWB) technology;Location Tracking equipment operating inthe frequency range from 6 GHz to 9 GHz;Par

2、t 2: Harmonized EN covering the essential requirementsof article 3.2 of the R Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.as

3、p). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the pre

4、sent document. Foreword This Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document is part 2 of a multi-part deliverable covering Short Range Devices (SRD) using Ultr

5、a WideBand (UWB) technology; Location Tracking equipment operating in the frequency range from 6 GHz to 9 GHz, as identified below: Part 1: “Technical characteristics and methods of measurement“; Part 2: “Harmonized EN covering the essential requirements of article 3.2 of the R Short Range Devices (

6、SRD) using Ultra WideBand (UWB) technology; Location Tracking equipment operating in the frequency range from 6 GHz to 9 GHz; Part 1: Technical characteristics and methods of measurement“. 2.2 Informative references The following referenced documents are not necessary for the application of the pres

7、ent document but they assist the user with regard to a particular subject area. i.1 Directive 98/34/EC of the European Parliament and of the Council of 22 June 1998 laying down a procedure for the provision of information in the field of technical standards and regulations. i.2 Directive 1999/5/EC o

8、f the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity (R it provides a statement of all the test procedures corresponding to those requirements by cross reference to (a) specific clause

9、(s) in the present document or to (a) specific clause(s) in (a) specific referenced document(s); it qualifies each requirement to be either: - Unconditional: meaning that the requirement applies in all circumstances; or - Conditional: meaning that the requirement is dependent on the manufacturer hav

10、ing chosen to support optional functionality defined within the schedule. in the case of Conditional requirements, it associates the requirement with the particular optional service or functionality; it qualifies each test procedure to be either: - Essential: meaning that it is included with the Ess

11、ential Radio Test Suite and therefore the requirement shall be demonstrated to be met in accordance with the referenced procedures; - Other: meaning that the test procedure is illustrative but other means of demonstrating compliance with the requirement are permitted. Table A.1: HS Requirements and

12、conformance Test specifications Table (HS-RTT) Harmonized Standard EN 302 500-2 The following requirements and test specifications are relevant to the presumption of conformity under the article 3.2 of the R those designated “O“ make up the Other Test Suite; for those designated “X“ there is no test

13、 specified corresponding to the requirement. The completion of all tests classified “E“ as specified with satisfactory outcomes is a necessary condition for a presumption of conformity. Compliance with requirements associated with tests classified “O“ is a necessary condition for presumption of conf

14、ormity, although conformance with the requirement may be claimed by an equivalent test or by manufacturers assertion supported by appropriate entries in the technical construction file. Clause Number Identification of clause(s) defining the test specification in the present document unless another d

15、ocument is referenced explicitly. Where no test is specified (that is, where the previous field is “X“) this field remains blank. ETSI ETSI EN 302 500-2 V2.1.1 (2010-10) 11Annex B (informative): The EN title in the official languages The enlargement of the European Union (EU) resulted in a requireme

16、nt from the EU for a larger number of languages for the translation of the titles of Harmonized Standards and mandated ENs that are to be listed in the Official Journal to support the implementation of this legislation. For this reason the title translation concerning the present document can be con

17、sulted via the e-approval application. ETSI ETSI EN 302 500-2 V2.1.1 (2010-10) 12Annex C (informative): Bibliography ECC/DEC/(06)04: “ECC Decision of 24 March 2006 on the harmonized conditions for devices using. Ultra-Wideband (UWB) technology in bands below 10.6 GHz“. ETSI TR 102 495-3: “Electromag

18、netic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Technical characteristics for SRD equipment using Ultra Wide Band Sensor technology (UWB); Part 3: Location tracking applications type 1 operating in the frequency band from 6 GHz to 9 GHz for indoor and outdoor usage“. ETSI ETSI EN 302 500-2 V2.1.1 (2010-10) 13History Document history V1.1.1 February 2007 Publication V1.2.1 June 2008 Publication V2.1.1 January 2010 Public Enquiry PE 20100511: 2010-01-11 to 2010-05-11 V2.1.1 August 2010 Vote V 20101005: 2010-08-06 to 2010-10-05 V2.1.1 October 2010 Publication