EN 61434-1996 en Secondary Cells and Batteries Containing Alkaline or Other Non-Acid Electrolytes Guide to the Designation of Current in Alkaline Secondary Cell and Battery Standar.pdf

《EN 61434-1996 en Secondary Cells and Batteries Containing Alkaline or Other Non-Acid Electrolytes Guide to the Designation of Current in Alkaline Secondary Cell and Battery Standar.pdf》由会员分享，可在线阅读，更多相关《EN 61434-1996 en Secondary Cells and Batteries Containing Alkaline or Other Non-Acid Electrolytes Guide to the Designation of Current in Alkaline Secondary Cell and Battery Standar.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD Secondary cells and batteries containing alkaline or non-acidic electrolytes - Guide to the designation of current in alkaline secondary cell and battery standards The European Standard EN 61434 : 1996 has the status of a British Standard ICs 29.320.30 BS EN 61434 : 1997 IEC 61434 :

2、 1996 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW STD=BSI BS EN bL434-ENGL 1777 m Lb29bb7 Ob40730 T93 m Amd. No. Date BS EN 61434 : 1997 Text affected This British Standard, having been prepared under the direction of the Electrokchnicai Sector Board, was published under t

3、he authority of the Standards Board and comes into effect on 15 Septeniber 1997 C3 BSI 1997 ISBN O 680 28461 1 National foreword This British Standard is the English language version of EN 61434 : 1996. It is identical with IEC 61434 : 1996. The UK participation in its preparation was entrusted by T

4、echnical Committee PEYZl, Secondary cells and batteries, to Subcommittee PEL - present to the responsible internationalEuropean committee any enquiries on the interpretation, or proposals for change, and keep the UK interests informed - monitor related international and European developments and pro

5、mulgate them in the UK. A list of organizations, represented on this Subcommittee can be obtained on request to its secretary. From 1 January 1997, ali IEC publications have the number 60000 added to the old number. For instance, IEC 27-1 has been renumbered as IEC 60027-1. For a period of time duri

6、ng the change over from one numbering system to the other, publications may contain identifiers from both systems. Cross-references Attention is dram to the fact that CEN and CENELEC Standards normally include an annex which lists normative references to international publications with their corresp

7、onding European publications. The British Standards which implement these international or European publications may be found in the BSI Standards Catalogue under the section entitled International Standards Correspondence Index or using the Find facility of the BSI Standards Electronic Catalogue. C

8、ompliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, the EN title page, pages 2 to 4, an inside back cover and a back cover. - STD*BSI BS EN b1434-ENGL 1997 lbZLibb9 ObLi073L 72T EU

9、ROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 61434 December 1996 ICs 29.220.30 Descriptors: Alkaline batteries, current. designation English version Secondary cells and batteries containing alkaline or other non-acid electrolytes Guide to the designation of current in alkaline secondary cell a

10、nd battery standards (IEC 1434: 1 996) Accumulateurs alcalins et autres accumulateurs lectrolyte non acide Guide pour lexpression des courants dans les normes daccumulateurs (CE1 1434: 1996) und Batterien Sekundrzellen und Batterien mit alkalischem oder anderen nicht surehaltigen Elektrolyten - Rich

11、tlinien fr die Bestimmung des Stromes in I alcalins Normen fr alkalische Sekundrzellen - - (IEC 1434: 1996) This European Standard was approved by CENELEC on 1996-10-01. CENELEC members are bound to comply with the CENICENELEC Internal Regulations which stipulate the conditions for giving this Europ

12、ean Standard the status of a national standard without any alteration. Up-todate lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC member. This Eropean Standard exists in three official versions (Englis

13、h, French, Germanl. A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Be

14、lgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardization Comit Europen de Normalisation Electrotechnique Europisches Komitee fr

15、Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B - 1050 Brussels (o I996 Copyright reserved to CENELEC members Ref. No. EN 61434:1996 E Page 2 EN 61434 : 1996 Foreword The text of document 21A/188/FDIS, future edition 1 of IEC 1434, prepared by SC 21A, Alkaline secondary cells an

16、d batteries, of IEC TC 21, Secondary cells and batteries, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as EN 61 434 on 1996-1 0-01. The following dates were fixed: - latest date by which the EN has to be implemented at national level by publication of an identical natio

17、nal standard or by endorsement - latest date by which the national standards conflicting with the EN have to be withdrawn Endorsement notice The text of the International Standard IEC 1434: 1996 European Standard without any modification. (dop) 1997-07-01 (daw) 1997-07-01 was approved by CENELEC as

18、a STD.BSI BS EN bL434-ENGL I777 m Lb24bb7 Ob40733 7T2 m Page 3 EN 61434 : 1996 INTRODUCTION In alkaline secondary cell and battery standards and in the industry in general, charge and discharge currents have traditionally been expressed as fractions or multiples of C, where C is the rated capacity o

19、f the cell or battery in ampere hours (Ah). Objections have been raised that to divide or multiply C results in a fraction or multiple of Ah and it is therefore mathematically incorrect to express current (amperes (A) in this way. STD-BSI BS EN bL434-ENGL 1777 LbZLibbS Ob4073Li b37 Page 4 EN 61434 :

20、 1996 SECONDARY CELLS AND BATTERIES CONTAINING ALKALINE OR OTHER NON-ACID ELECTROLYTES - Guide to the designation of current in alkaline secondary cell and battery standards 1 Scope This International Standard applies to secondary cells and batteries containing alkaline or other non-acid electrolyte

21、s. It proposes a mathematically correct method of current designation which shall be used in future secondary cell and battery standards. 2 Method of designation The reference test current as specified in the various test methods detailed in a standard shall be expressed as: C,Ah lh /,A=- where i, i

22、s the reference test current, in amperes; C, is the rated capacity of the cell or battery as declared by the manufacturer, in ampere-hours; n is the time base (hours) for which the rated capacity is declared. All charge and discharge currents shall then be expressed as fractions or multiples of 1,.

23、The value of n used in the standard determines only the fraction or multiple of /, used fdr the various specified purposes in that standard. For example, if n = 5, then the discharge current used to verify the rated capacity shall be 0,2 /,A. If n = 1, the discharge current used to verify the rated

24、capacity shall be 1 ,O /,A. Note that the value of n used in the standard has no effect on the value of value of /, will always be equal to the numerical value of C, regardless of the value of n. The numerical STD-BSI BS EN bL434-ENGL I777 LbZL(bb7 Ob40735 575 W IEC 61434 : 1996 I BS EN 61434 : 1997

25、 3SI - British Standards Institution ;SI is the independent national body responsible for preparing British Standards. It resents the UK view on standards in Europe and at the intrnational level. It is zcorporated by Royal Charter. :ontract requirements L British Standard does not purport to include

26、 ail the necessary provisions of a ontract. Users of British Standards are responsible for their correct application. tevisions hitish Standards are updated by amendment or revision. Users of British Standards hould make sure that they possess the latest amendments or editions. t is the constant aim

27、 of BSI to improve the quality of our products and services. We vould be grateful if anyone finding an inaccuracy or ambiguity while using this Iritish Standard would inform the Secretary of the responsible technical committee, he identity of which can be found on the Wide front cover. Tel O181 996

28、9000; Fax: I181 996 7400. 3SI offers members an individual updating service called PLUS which ensures that iubscriberc automatically receive the latest editions of standards. hying standards kders for all BSI, international and foreign standards publications should be iddressed to Customer Services,

29、 Sales Department at Chiswick Tel 0181 996 7000; ?ax: O181 996 7001. n response to orders for international standards, it is BSI policy to supply the BSI mplementation of those that have been published as British Standards, unless Itherwise requested. nformation on standards 3SI provides a wide rang

30、e of information on national, European and international ;tandards through its Lbrary, the Standardline Database, the BSI Information rechnology Service (BITS) and its Technical Help to Exporters Service. Contact the nformation Department at Chiswick Tel: 0181 996 7111; Fax: 0181 996 7048. Subscribi

31、ng members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of bese and other benets contact Customer Services, Membership at Chiswick lel O181 9% 7002; Fax: O181 996 7001. Copyright Copyright subsists in all BSI

32、 publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or txmmitted in any form or by any means - electro

33、nic, photocopying, recorduig or otherwise - without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbolc, and size, type or grade designations. If these details are to be used for any other purpose th

34、an implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager, BSI, 389 Chiswick High Road, London W4 4AL. BSI 389 Chiswick High Road London w4 4AL