EN 13528-1-2002 en Ambient air quality - Diffusive samplers for the determination of concentrations of gases and vapours - Requirements and test methods - Part 1 General requiremen.pdf

《EN 13528-1-2002 en Ambient air quality - Diffusive samplers for the determination of concentrations of gases and vapours - Requirements and test methods - Part 1 General requiremen.pdf》由会员分享，可在线阅读，更多相关《EN 13528-1-2002 en Ambient air quality - Diffusive samplers for the determination of concentrations of gases and vapours - Requirements and test methods - Part 1 General requiremen.pdf（14页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD Ambient air quality - Diffusive samplers for the determination of concentrations of gases and vapours - Requirements and test methods - Part 1: General requirements The European Standard EN 13528-1:2002 has the status of a British Standard ICC 13.040.20 BS EN 135 28-1 200 2 Brit ish

2、 Sta nda rds NO COPYING WITHOUT BCI PERMISSION EXCEPT Ac PERMITTED BY COPYRIGHT LAW BS EN 13528-12002 Amd. No. Date ISBN O 580 40576 1 National foreword Comments This British Standard is the official English language version of The UK participation in its preparation was entrusted by Technical Commi

3、ttee EHf2, Air quality, to Subcommittee EH monitor related international and European developments and promulgate them in the UK. - A list of organizations represented on this subcommittee can be obtained on request to its secretary. Cross-references The British Standards which implement internation

4、al or European publications referred to in this document may be found in the BSI Catalogue under the section entitled “International Standards Correspondence Index”, or by using the “Search” facility of the BSI Electronic Catalogue or of British Standards Online. This publication does not purport to

5、 include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. This British Standard, having been prepared under the direction of the Health and Environment Sector P

6、olicy and pages to and a back cover. Summary of pages This document comprises a front cover, an inside front cover, the EN title page, The BSI copyright date displayed in this document indicates when the document was last issued. Strategy Committee, was published under the authority of the Standards

7、 policy and Strategy Committee on 11 October 2002 Amendments issued since publication D BSI 11 October 2002 EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 13528-1 September 2002 ICs 13.040.20 English version Ambient air quality - Diffusive samplers for the determination of concentrations of ga

8、ses and vapours - Requirements and test methods - Part 1 : General requirements Qualit de lair - Echantillonneurs par diffusion pour la dtermination des concentrations des gaz et des vapeurs. Prescriptions et mthodes dessai - Partie 1: Prescriptions gnrales Auenluftqualitt - Passivsammler zur Bestim

9、mung der Konzentrationen von Gasen und Dmpfen - Anforderungen und Prfverfahren - Teil 1: Allgemeine Anforderungen This European Standard was approved by CEN on 21 July 2002. CEN members are bound to comply with the CENICENELEC Internal Regulations which stipulate the conditions for giving this Europ

10、ean Standard the status of a national standard without any alteration. Up-bdate lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. This European Standard exists in three official versions (English, Fre

11、nch, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denm

12、ark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg. Malta, Netherlands, Noway, Portugal, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMITE EUROPEEN DE NORMALISATION EUROPISCHES KOMITEE FOR NORMUNG Management Centre: rue de Stassart,

13、36 8-1050 Brussels O 2002 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 13528-1:2002 E EN 13528-1 2002 (E) Contents Page Foreword 3 Introduction . 4 I Scope 5 2 Normative references 5 3 Terms and definitions . 5 4 Assessment regi

14、mes . 7 5 Performance requirements . 7 5.1 Unambiguity 7 5.2 Selectivity 8 5.3 Data Quality Objectives . 8 5.4 Composite procedures 8 5.5 Environmental conditions 8 5.6 Description of measuring procedure . 8 5.7 Dimension of result 8 5.8 Quality systems . 8 6 Test methods . 8 7 Test report 9 Annex A

15、 (informative) Assessment of ambient air quality IO Bibliography 11 2 EN 13528-1:2002 (E) Foreword This document (EN 13528-1:2002) has been prepared by Technical Committee CENTTC 264 “Air Quality”, the secretariat of which is held by DIN. This European Standard shall be given the status of a nationa

16、l standard, either by publication of an identical text or by endorsement, at the latest by March 2003, and conflicting national standards shall be withdrawn at the latest by March 2003. This European Standard is a multi-part standard having the following parts: - Part 1 (Ambient Air Quality) General

17、 requirements; - Part 2 (Ambient Air Quality) Specific requirements and test methods; - Part 3 (Ambient Air Quality) Guide to selection, use and maintenance. Annex A is informative. According to the CENICENELEC Internal Regulations, the national standards organizations of the following countries are

18、 bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. 3 EN 13528-12002 (E) Introduction This European Stand

19、ard specifies requirements and test methods for the determination of performance characteristics of diffusive samplers used for the determination of concentrations of gases and vapours in ambient atmospheres. With regard to air quality, the objectives fixed in the 5hAction Programme of the European

20、Union are for the effective protection of all people against recognised risks from air pollution and the establishment of permitted concentration levels of air pollutants, which should take into account the protection of the environment. These objectives include monitoring of concentrations with reg

21、ard to standards. Successive programmes of action of the European Union on the protection of the environment have stressed the need to find a balance between the use of different tools: product standards, emission limits and environmental objectives/standards. The implementation of existing Directiv

22、es has highlighted the existence of various problems, which are being addressed in the Council Directive on Ambient Air Quality Assessment and Management I. These include: - the different monitoring strategies in comparable situations between and within Member States; - the harmonisation of measurin

23、g methods; - the quality of the measurements which depends on the calibration and quality assurance procedures. Diffusive samplers used to measure air quality have to fulfil some general requirements, which are given in this part of EN 13528. These requirements include unambiguity, selectivity and D

24、ata Quality Objectives, including uncertainty. Such general requirements can also be appropriate for other measurement procedures used in the assessment of ambient air quality. In addition, diffusive samplers used to measure air quality shall also fulfil some specific requirements in addition to tho

25、se specified in this part of EN 13528. These specific requirements are given in EN 13528-2. EN 13528-3 gives guidance on the selection, use and maintenance of diffusive samplers used to measure ambient air quality. It is the users primary responsibility to choose appropriate procedures or devices th

26、at meet the requirements in this European Standard. One way of doing this is to obtain information or confirmation from the manufacturer. Type testing, or more generally, the assessment of performance criteria of procedures or devices, can be undertaken by the manufacturer, user, test house or resea

27、rch and development laboratory, as is most appropriate. Although this part of EN 13528 specifically addresses ambient air, diffusive sampling is also relevant to the assessment of air quality in indoor air. Both pumped and diffusive sampling procedures are considered appropriate for such measurement

28、s, depending on circumstances (particularly any requirement for time resolution) 2. prEN 14412 gives guidance on the selection, use and maintenance of diffusive samplers used to measure indoor air quality. This part of EN 13528 is similar in content to EN 482:1994 and EN 13528-2 is similar in conten

29、t to EN 838:1995.The series of standards on the use of diffusive samplers for ambient air has been created in addition to those for workplace air because the underlying European Directives are different and the consequent definitions and practical applications of the estimation of the uncertainty of

30、 measurements are different. 4 EN 13528-Ir2002 (E) 1 Scope This European Standard specifies general performance requirements for diffusive samplers used for the determination of the concentration of gases and vapours in ambient air. Such requirements apply to all diffusive samplers, irrespective of

31、the physical nature of the rate controlling process and irrespective of the nature of the sorption process and the analytical determination. This standard applies to all stages of the measuring procedure, including deployment, transportation and storage of the sample where appropriate. This standard

32、 applies to measuring procedures with separate sampling and analysis stages, and also to direct- reading devices. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate plac

33、es in the text, and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication refe

34、rred to applies (including amendments). ENV 13005, Guide to the expression of uncertainty in measurement. EN ISOllEC 17025, General requirements for the competence of testing and calibration laboratories (ISO/IEC 1 7025: 1999). IS0 5725: 1994, Accuracy (trueness and precision) of measurement methods

35、 and results (all parts). 3 Terms and definitions For the purpose of this European Standard the following terms and definitions apply. 3.1 ambient air outdoor air in the troposphere, excluding indoor air and workplaces 3.2 averaging time period of time for which the measuring procedure yields a sing

36、le value EN 482:1994 3.3 bias difference between the expectation of the test results and an accepted reference value IS0 3534-1:1993 3.4 combined standard uncertainty standard uncertainty of the result of a measurement when that result is obtained from the values of a number of other quantities, equ

37、al to the positive square root of a sum of terms, the terms being the variances or covariances of these other quantities weighted according to how the measurement result varies with changes in these quantities ENV 13005 3.5 desorption efficiency ratio of the mass of analyte desorbed from a sampling

38、device to that applied EN 838:1995 5 EM 13528-1:2002 (E) 3.6 diffusive sampler device which is capable of taking samples of gases or vapours from the atmosphere at a rate controlled by a physical process such as gaseous diffusion through a static air layer or a porous material and/or permeation thro

39、ugh a membrane, but which does not involve the active movement of air through the device NOTE 1 Active normally refers to the pumped movement of air. NOTE 2 This definition differs from that in EN 838:1995 by the addition of the words or a porous material, 3.7 expanded uncertainty quantity defining

40、an interval about the result of a measurement that may be expected to encompass a large fraction of the distribution of values that could reasonably be attributed to the measurand NOTE 1 The fraction may be viewed as the coverage probability or level of confidence of the interval. NOTE 2 To associat

41、e a specific level of confidence with the interval defined by the expanded uncertainty requires explicit of implicit assumptions regarding the probability distribution characterised by the measurement result and its combined standard uncertainty. The level of confidence that can be attributed to the

42、 interval can be known only to the extent to which such assumptions may be justified. NOTE 3 Expanded uncertainty is temed overall uncertainyin ENV 13005. ENV 130051 3.8 measuring procedure procedure for sampling and analysing one or more pollutants in ambient air and including storage and transport

43、ation of the sample 3.9 repeatability conditions conditions where independent test results are obtained with the same method on identical test items in the same laboratory by the same operator using the same equipment within short intervals of time IS0 3534-1:1993 3.10 reproducibility conditions con

44、ditions where test results are obtained with the same method on identical test items in different laboratories with different operators using different equipment IS0 3534-1 :I 9931 3.1 1 selectivity degree of independence from interferents 3.12 standard uncertainty uncertainty of the result of a mea

45、surement expressed as a standard deviation ENV 130051 3.13 uncertainty (of measurement) parameter, associated with the results of a measurement, that characterises the dispersion of values that could reasonably be attributed to the measurand NOTE 1 The parameter may be, for example, a standard devia

46、tion (or given multiple of it), or the half width of an interval having a stated level of confidence. NOTE 2 Uncertainty of measurement comprises, in general, many components. Same of these components may be evaluated from the statistical distribution of the results of a series of measurements and c

47、an be characterised by experimental standard 6 EN 13528-12002 (E) deviations. The other components, which can also be characterised by standard deviations, are evaluated from assumed probability distributions based on experience or other information. NOTE 3 It is understood that the result of a meas

48、urement is the best estimate of the value of a measurand, and that all components of uncertainty, including those arising from systematic effects, such as components associated with corrections and reference standards, contribute to this dispersion ENV 130051. Attention is drawn to the fact that the

49、 terms Assessment, Limit Value and Pollutant are defined in Directive 96/62/EC I. 4 Assessment regimes Different regimes of air quality assessment are possible for the implementation of the Council Directive on Ambient Air Quality Assessment and Management I 1, and successive Daughter Directives, in which the measurement requirements are relaxed as the risk of exceeding the limit values decreases (see annex A). Other assessment regimes may be required by a number of other EU regulations (Acidification Directive, Directive on Forest Protection) as we