DOT 49 CFR PART 213-2010 TRACK SAFETY STANDARDS.pdf
《DOT 49 CFR PART 213-2010 TRACK SAFETY STANDARDS.pdf》由会员分享,可在线阅读,更多相关《DOT 49 CFR PART 213-2010 TRACK SAFETY STANDARDS.pdf(53页珍藏版)》请在麦多课文档分享上搜索。
1、100 49 CFR Ch. II (10110 Edition) 212.233 deemed to meet all requirements of this section and is qualified to conduct independent inspections of all types of highway-rail grade crossing warning systems for the purpose of determining compliance with Grade Crossing Signal System Safety Rules (49 CFR p
2、art 234), to make reports of those inspections, and to recommend institution of en-forcement actions when appropriate to promote compliance. 59 FR 50104, Sept. 30, 1994 212.233 Apprentice highway-rail grade crossing inspector. (a) An apprentice highway-rail grade crossing inspector shall be enrolled
3、 in a program of training prescribed by the Associate Administrator for Safety leading to qualification as a highway- rail grade crossing inspector. The ap-prentice inspector may not participate in investigative and surveillance ac-tivities, except as an assistant to a qualified State or FRA inspect
4、or while accompanying that qualified inspector. (b) Prior to being enrolled in the pro-gram the apprentice inspector shall demonstrate: (1) Working basic knowledge of elec-tricity; (2) The ability to use electrical test equipment in direct current and alter-nating current circuits; and (3) A basic k
5、nowledge of highway-rail grade crossing inspection and mainte-nance methods and procedures. 59 FR 50104, Sept. 30, 1994 212.235 Inapplicable qualification re-quirements. The Associate Administrator may de-termine that a specific requirement of this subpart is inapplicable to an iden-tified position
6、created by a State agen-cy if it is not relevant to the actual du-ties of the position. The determination is made in writing. 47 FR 41051, Sept. 16, 1982. Redesignated at 57 FR 28115, June 24, 1992. Further redesig-nated at 59 FR 50104, Sept. 30, 1994 PART 213TRACK SAFETY STANDARDS Subpart AGeneral
7、Sec. 213.1 Scope of part. 213.2 Preemptive effect. 213.3 Application. 213.4 Excepted track. 213.5 Responsibility for compliance. 213.7 Designation of qualified persons to su-pervise certain renewals and inspect track. 213.9 Classes of track: operating speed lim-its. 213.11 Restoration or renewal of
8、track under traffic conditions. 213.13 Measuring track not under load. 213.15 Penalties. 213.17 Waivers. 213.19 Information collection. Subpart BRoadbed 213.31 Scope. 213.33 Drainage. 213.37 Vegetation. Subpart CTrack Geometry 213.51 Scope. 213.53 Gage. 213.55 Alinement. 213.57 Curves; elevation and
9、 speed limita-tions. 213.59 Elevation of curved track; runoff. 213.63 Track surface. Subpart DTrack Structure 213.101 Scope. 213.103 Ballast; general. 213.109 Crossties. 213.110 Gage restraint measurement sys-tems. 213.113 Defective rails. 213.115 Rail end mismatch. 213.118 Continuous welded rail (C
10、WR); plan review and approval. 213.119 Continuous welded rail (CWR); plan contents. 213.121 Rail joints. 213.122 Torch cut rail. 213.123 Tie plates. 213.127 Rail fastening systems. 213.133 Turnouts and track crossings gen-erally. 213.135 Switches. 213.137 Frogs. 213.139 Spring rail frogs. 213.141 Se
11、lf-guarded frogs. 213.143 Frog guard rails and guard faces; gage. VerDate Mar2010 09:47 Dec 14, 2010 Jkt 220215 PO 00000 Frm 00110 Fmt 8010 Sfmt 8010 Y:SGML220215.XXX 220215jdjones on DSK8KYBLC1PROD with CFRProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS
12、-,-,-101 Federal Railroad Administration, DOT 213.3 Subpart ETrack Appliances and Track- Related Devices 213.201 Scope. 213.205 Derails Subpart FInspection 213.231 Scope. 213.233 Track inspections. 213.235 Inspection of switches, track cross-ings, and lift rail assemblies or other transition devices
13、 on moveable bridges. 213.237 Inspection of rail. 213.239 Special inspections. 213.241 Inspection records. Subpart GTrain Operations at Track Classes 6 and Higher 213.301 Scope of subpart. 213.303 Responsibility for compliance. 213.305 Designation of qualified individuals; general qualifications. 21
14、3.307 Class of track: operating speed lim-its. 213.309 Restoration or renewal of track under traffic conditions. 213.311 Measuring track not under load. 213.317 Waivers. 213.319 Drainage. 213.321 Vegetation. 213.323 Track gage. 213.327 Alinement. 213.329 Curves, elevation and speed limita-tions. 213
15、.331 Track surface. 213.333 Automated vehicle inspection sys-tems. 213.334 Ballast; general. 213.335 Crossties. 213.337 Defective rails. 213.339 Inspection of rail in service. 213.341 Initial inspection of new rail and welds. 213.343 Continuous welded rail (CWR). 213.345 Vehicle qualification testin
16、g. 213.347 Automotive or railroad crossings at grade. 213.349 Rail end mismatch. 213.351 Rail joints. 213.352 Torch cut rail. 213.353 Turnouts, crossovers, and lift rail as-semblies or other transition devices on moveable bridges. 213.355 Frog guard rails and guard faces; gage. 213.357 Derails. 213.
17、359 Track stiffness. 213.361 Right of way. 213.365 Visual inspections. 213.367 Special inspections. 213.369 Inspection records. APPENDIX A TO PART 213MAXIMUM ALLOW-ABLE CURVING SPEEDS APPENDIX B TO PART 213SCHEDULE OF CIVIL PENALTIES AUTHORITY: 49 U.S.C. 2010220114 and 20142; 28 U.S.C. 2461, note; a
18、nd 49 CFR 1.49(m). SOURCE: 63 FR 34029, June 22, 1998, unless otherwise noted. Subpart AGeneral 213.1 Scope of part. (a) This part prescribes minimum safety requirements for railroad track that is part of the general railroad sys-tem of transportation. The require-ments prescribed in this part apply
19、 to specific track conditions existing in isolation. Therefore, a combination of track conditions, none of which indi-vidually amounts to a deviation from the requirements in this part, may re-quire remedial action to provide for safe operations over that track. This part does not restrict a railroa
20、d from adopting and enforcing additional or more stringent requirements not in-consistent with this part. (b) Subparts A through F apply to track Classes 1 through 5. Subpart G and 213.2, 213.3, and 213.15 apply to track over which trains are operated at speeds in excess of those permitted over Clas
21、s 5 track. 213.2 Preemptive effect. Under 49 U.S.C. 20106, issuance of these regulations preempts any State law, regulation, or order covering the same subject matter, except an addi-tional or more stringent law, regula-tion, or order that is necessary to eliminate or reduce an essentially local saf
22、ety hazard; is not incompatible with a law, regulation, or order of the United States Government; and that does not impose an unreasonable bur-den on interstate commerce. 213.3 Application. (a) Except as provided in paragraph (b) of this section, this part applies to all standard gage track in the g
23、eneral railroad system of transportation. (b) This part does not apply to track (1) Located inside an installation which is not part of the general rail-road system of transportation; or (2) Used exclusively for rapid transit operations in an urban area that are not connected with the general rail-r
24、oad system of transportation. VerDate Mar2010 09:47 Dec 14, 2010 Jkt 220215 PO 00000 Frm 00111 Fmt 8010 Sfmt 8010 Y:SGML220215.XXX 220215jdjones on DSK8KYBLC1PROD with CFRProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-102 49 CFR Ch. II (10110 Editio
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DOT49CFRPART2132010TRACKSAFETYSTANDARDSPDF