DLA MS75075 REV D-2005 SWITCH TOGGLE TWO POLE UNSEALED《未密封的两极点肘节开关》.pdf

《DLA MS75075 REV D-2005 SWITCH TOGGLE TWO POLE UNSEALED《未密封的两极点肘节开关》.pdf》由会员分享，可在线阅读，更多相关《DLA MS75075 REV D-2005 SWITCH TOGGLE TWO POLE UNSEALED《未密封的两极点肘节开关》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A 1 of 2 FSC 5930 INCH-POUND MS75075D 21 July 2005SUPERSEDING MS75075C 22 May 1972 MILITARY SPECIFICATION SHEET SWITCH, TOGGLE, TWO POLE, UNSEALED INACTIVE FOR NEW DESIGN, DATED 8 MARCH 1999 This specification is approved for use by all Departments and Agencies of the Department of Defense. T

2、he requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-83731. NOTES: 1. All dimensions are in inches. 2. Unless otherwise specified, tolerance is .020 on two place decimals and .005 on three place decimals. 3. Contour of switch is optional pr

3、ovided maximum dimensions specified are not exceeded. 4. For hardware detail specifications, see supplement MIL-DTL-83731. FIGURE 1. Dimensions and configurations. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS75075D 2 TABLE I. Detail requirement

4、s. Circuit with toggle lever in Current capacity (amperes) 28 V dc (seal level) 28 V dc (70,000 ft) 115 volts/60 Hz (Sea level) MS part number Keying side Center Opposite keying side Inductive Resistive Inductive Resistive Maintained Maintained -1 -2 -3 -4 2-3 5-6 None 1-2 4-5 2.5 7 2.0 1.5 1. All s

5、witches on this standard are designed so that the movement of the switch mechanism is same as the toggle lever. 2. Maximum weight is .01 pound. 3. Black finish on bushing. 4. Non-nutrient fungus resistant case material in accordance with ASTM-D5948. 5. Strength of actuating lever pivot and lever sto

6、p test shall be performed at 8 pounds. 6. Dielectric strength after electrical endurance is 300 volts from terminal to ground. 7. Terminals will accept 18 AWG wire. NOTES: 1. Referenced documents shall be of the issue in effect on the date of invitations to bid. 2. For design feature purposes, this

7、standard takes precedence over acquisition documents referenced herein. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of changes. Referenced Documents: MIL-DTL-83731 ASTM-D5948 Custodians: Preparing activity: Army - CR DLA -

8、 CC Navy - EC Air Force - 11 (Project 5930-1919-01) NOTE: The activities listed above were interested in this document as of the date of the this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the Assist Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-