DLA MS39134 REV F-2010 SPRING HELICAL COMPRESSION AUTOMOTIVE AIR BRAKE HOSE ADAPTER.pdf

《DLA MS39134 REV F-2010 SPRING HELICAL COMPRESSION AUTOMOTIVE AIR BRAKE HOSE ADAPTER.pdf》由会员分享，可在线阅读，更多相关《DLA MS39134 REV F-2010 SPRING HELICAL COMPRESSION AUTOMOTIVE AIR BRAKE HOSE ADAPTER.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 DETAIL SPECIFICATION SHEET SPRING, HELICAL, COMPRESSION, AUTOMOTIVE AIR BRAKE HOSE ADAPTER This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet. This

2、 spring is a component of the adapter, straight, pipe to hose-automotive air brake hose. FIRST 5 COILS CLOSE WOUNDOTHER COILS .19 PITCH2.75THIS END OF WIREMUST BE FUSED.78 .03+.00-.02TAPER TO BEGIN HERE1.84Inches mm 0.02 0.508 0.03 0.762 0.19 4.826 0.78 19.812 0.84 21.336 1.00 25.40 2.75 69.85 FIGUR

3、E 1. Helical spring. AMSC N/A FSC 4730 INCH-POUND MS39134F 24 May 2010 SUPERSEDING MS39134E 4 January 1999 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS39134F 2 NOTES: 1. All dimensions are in inches. 2. Metric equivalents are given for informat

4、ion only. 3. For design feature purposes, this document takes precedence over acquisition documents referenced herein. 4. In the event of a conflict between the text of this specification sheet and the references cited herein, the text of this specification sheet shall take precedence. 5. Part or Id

5、entifying Number (PIN). MS39134. FIGURE 1. Helical spring Continued. REQUIREMENTS: Springs shall be in accordance with figure 1. The spring specified herein are a component of the adapter, straight pipe to hose, automotive air brake hose as specified in MS39133. Materials shall conform to .105 dia.,

6、 hard drawn, high carbon steel wire, type II, as specified in SAE-AMS-QQ-W-428. Finish shall be a zinc coating, thickness not less than 25m, type II, as specified in ASTM-B33. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from

7、 the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal

8、notations and relationship to the last previous issue. Referenced documents. This document references the following: MS39133 SAE-AMS-QQ-W-428 ASTM-B33 CONCLUDING MATERIAL Custodians: Preparing activity: Army AT DLA - CC Navy SH Air Force 99 DLA CC (Project 4730-2010-060) Review activities: Army AR,

9、EA Navy MC, SA Air Force 71 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-