DLA MS27720 REV H-2012 SWITCH TOGGLE MINIATURE SINGLE POLE TOGGLE SEAL LEVER LOCK.pdf
《DLA MS27720 REV H-2012 SWITCH TOGGLE MINIATURE SINGLE POLE TOGGLE SEAL LEVER LOCK.pdf》由会员分享,可在线阅读,更多相关《DLA MS27720 REV H-2012 SWITCH TOGGLE MINIATURE SINGLE POLE TOGGLE SEAL LEVER LOCK.pdf(4页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5930 INCH-POUND MS27720H 4 May 2012 SUPERSEDING MS27720G 20 May 1988 DETAIL SPECIFICATION SHEET SWITCH, TOGGLE, MINIATURE, SINGLE POLE TOGGLE SEAL, LEVER LOCK This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquir
2、ing the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-83731. Inches mm Inches mm Inches mm .005 .020 .030 .04 .062 .07 0.13 0.51 0.76 1.02 1.57 1.78 .072 .090 .10 .175 .27 .428 1.83 2.29 2.54 4.45 6.86 10.87 .47 .51 .535 .575 .740 1.160 11.94 12.9
3、5 13.59 14.61 18.80 29.46 NOTES: 1. Dimensions are in inches. 5. Metric equivalents are given for general information only. 2. Unless otherwise specified, tolerance is .020 (0.51 mm) on two place decimals and .005 (0.31 mm) on three place decimals. 4. Configuration of switch case is optional provide
4、d maximum dimensions specified are not exceeded. 3. For hardware detail specifications, see supplement of MIL-DTL-83731. FIGURE 1. Dimensions and configurations. 28 10 .585 MAX .548 MAX Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27720H 2 FIGUR
5、E 2. Detail requirements. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27720H 3 Canceled MS part number 1/ Substitute part number 1/ Available locking combinations Circuits made with toggle lever in Keying side 1-2 4-5 Center position Opposite k
6、eying side 2-3 5-6 MS27720-21 MS27720-21-1 All ON OFF ON -22 -22-1 D, F, G OFF NONE ON -23 -23-1 D, F, G ON NONE ON -26 -26-1 F MOM-ON NONE ON -27 -27-1 E, L, N MOM-ON OFF MOM-ON -31 -31-1 E, F, K, L, M, N MOM-ON OFF ON 1/ The canceled part numbers are no longer acquirable; the substitute part numbe
7、rs have a lower dielectric withstanding voltage at reduced barometric pressure (see test voltage requirement below.) REQUIREMENTS: All switches on this standard are designed so that the movement of the switch mechanism is opposite to that of the toggle lever. Test voltage for dielectric withstanding
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAMS27720REVH2012SWITCHTOGGLEMINIATURESINGLEPOLETOGGLESEALLEVERLOCKPDF

链接地址:http://www.mydoc123.com/p-696857.html