DLA MS24614 REV L-2011 SWITCH TOGGLE POSITIVE BREAK LEVER LOCK ENVIRONMENTALLY SEALED SCREW TERMINAL FOUR POLE 469 MOUNTING BUSHING 25 AMPERES.pdf

《DLA MS24614 REV L-2011 SWITCH TOGGLE POSITIVE BREAK LEVER LOCK ENVIRONMENTALLY SEALED SCREW TERMINAL FOUR POLE 469 MOUNTING BUSHING 25 AMPERES.pdf》由会员分享，可在线阅读，更多相关《DLA MS24614 REV L-2011 SWITCH TOGGLE POSITIVE BREAK LEVER LOCK ENVIRONMENTALLY SEALED SCREW TERMINAL FOUR POLE 469 MOUNTING BUSHING 25 AMPERES.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5930 INCH-POUND MS24614L 5 October 2011 SUPERSEDING MS24614K 30 September 1986 DETAIL SPECIFICATION SHEET SWITCH, TOGGLE, POSITIVE BREAK, LEVER LOCK, ENVIRONMENTALLY SEALED, SCREW TERMINAL, FOUR POLE, .469 MOUNTING BUSHING, 25 AMPERES Inactive For new design after 24 JUNE 2005 This spec

2、ification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the products described herein shall consist of this specification sheet and MIL-DTL-8834. FIGURE 1. Dimensions and configuration. Provided by IHSNot for ResaleNo reproduction or

3、 networking permitted without license from IHS-,-,-MS24614L 2 FIGURE 1. Dimensions and configuration - Continued. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS24614L 3 MS dash number Superseded dash number sealed Environ- mentally sealed Toggle

4、Environ- mental Toggle Inches mm Inches mm -212 -222 -232 -242 -262 -272 -282 -292 -302 -312 -21 -22 -23 -24 -26 -27 -28 -29 -30 -31 -21S -22S -23S -24S -26S -27S -28S -29S -30S -31S -211 -221 -231 -241 -261 -271 -281 -291 -301 -311 .005 .012 .047 .072 .138 .250 .430 0.13 0.30 1.19 1.83 3.51 6.35 10

5、.92 .432 .469 .480 .921 1.328 1.336 1.686 10.97 11.91 12.19 23.39 33.73 33.93 42.82 Maximum vibration detail Acceleration G-units Frequency Hz 20 Gs 10 Gs 85-200 200-500 Example of Part or Identifying Number (PIN): MS24614B212 = on-off-on, environmentally sealed, locked in center off position. MS246

6、14F272 = mom-on, off, mom-on, environmentally sealed, locked in center off position. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are .010 (0.25 mm) on decimals and 5 on angles. FIGURE 1. Dimensions and co

7、nfiguration - Continued. REQUIREMENTS: For hardware and terminal screw detail specifications, see appendix of MIL-DTL-8834. In the event of a conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence. The superseded dash num

8、bers are inactive for design after 20 July 1962. The MS dash numbers supersede and are completely interchangeable with the superseded dash numbers. Unlocking force = 4 1 pound. Maximum weight: .2231 pound maximum (101.2 grams). Altitude requirements: 80,000 feet. 115 V ac 60 hertz electrical enduran

9、ce tests are to be performed at room temperature and pressure. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS24614L 4 TABLE I. Detail requirements. MS dash no. Locking comb. Circuit made between terminals as indicated with the toggle lever in the

10、se positions: Environ- mentally sealed Opposite keyway side Center position Keyway side 212 A, B, C, D, E on 2-3, 5-6, 8-9, 11-12 off on 1-2, 4-5, 7-8, 10-11 222 C, E none off 232 on 1-2, 4-5, 7-8, 10-11 242 J, B off none 262 L none mom-on 1-2, 4-5, 7-8, 10-11 272 F, H mom-no 2-3, 5-6, 8-9, 11-12 of

11、f 282 K none 292 L on 2-3, 5-6, 8-9, 11-12 none mom-off 302 off mom-on 1-2, 4-5, 7-8, 10-11 312 G, K, M, N on 2-3, 5-6, 8-9, 11-12 off 1/ See footnote at end of table. TABLE I. Detail requirements - Continued MS dash no. Current capacity amperes per pole 28 volts dc Current capacity amperes per pole

12、 115 volts 400 hertz Circuit capacity amperes per pole 115 volts 60 hertz Environ- mental sealed Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit 212 7 25 15 7 25 15 7 20 15 222 232

13、 242 262 272 282 292 302 312 1/ See footnote at end of table. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS24614L 5 TABLE I. Detail requirements - Continued MS dash no. Current capacity amperes per pole 250 volts 60 hertz ac 1/ Current capacity

14、amperes per pole 125 volts dc 1/ Circuit capacity amperes per pole 250 volts dc 1/ Life low current level switching 30 mV Environ- mentally sealed Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Indu

15、c-tive circuit 212 10 7 750 mA - 500 mA - 10 mA 222 232 242 262 272 282 292 302 312 1/ Application information ratings at room temperature. Referenced documents: MIL-DTL-8834 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previou

16、s issue due to the extent of the changes. Custodians: Preparing activity: Army - CR DLA CC Navy - AS Air Force - 85 (Project 5930-2011-084) DLA - CC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-