DLA MIL-PRF-27 134 B-2009 TRANSFORMER POWER STEP-DOWN.pdf

《DLA MIL-PRF-27 134 B-2009 TRANSFORMER POWER STEP-DOWN.pdf》由会员分享，可在线阅读，更多相关《DLA MIL-PRF-27 134 B-2009 TRANSFORMER POWER STEP-DOWN.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5950 INCH-POUND MIL-PRF-27/134B 9 November 2009 SUPERSEDING MIL-PRF-27/134A 23 April 1979 PERFORMANCE SPECIFICATION SHEET TRANSFORMER, POWER, STEP-DOWN This specification is approved for use by all Depart- ments and Agencies of the Department of Defense. The requirements for acquiring t

2、he transformer described herein shall consist of this specification sheet and MIL-PRF-27. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Marking shall be sides of the case. FIGURE 1. Dimensions and configurations. Inches mm .015 0.38 .030 0.76 .0

3、50 1.27 .200 5.08 .280 7.11 .375 9.53 .550 13.97 .750 19.05 1.000 25.40 1.090 27.69 1.100 27.94 1.150 29.21 1.400 35.56 .112-40 UNC-2B INSERT 8 THDS MIN. 4 PLACES 4 3 CIRCUIT DIAGRAM 28.6 V 120 V 400 Hz 2 1 1 2 3 4 1.150 .030 .280 TYP. .030 (5 PLS) 1.000 .050 .200 MAX. 1.400 MAX. .375 .550 1.100 .01

4、51.090 MAX.750 .015 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/134B 2 REQUIREMENTS: (When numbers in parentheses, such as (1-2) are used, they indicate the winding and the extreme terminals of the winding.) Electrical ratings: Primary

5、 voltage: (1-2): 120 volts, 400 Hz, 12 VA. Secondary voltage: Working voltage: 250 volts. Design and construction: Dimensions and configuration: See figure 1. Duty cycle: Continuous. Case: Epoxy, glass in accordance with MIL-DTL-25421, type 1, class 2. Terminals: Solder, turret type Material: Brass,

6、 silver-plated. Height: .200 inches, maximum. Weight: 100 grams. Altitude: 50,000 feet. Operating temperature range: -65C to +155C. Terminal strength: MIL-STD-202, method 211, test condition A, 5.0 pounds. Dielectric withstanding voltage At sea level: 700 volts rms. At reduced barometric pressure: 3

7、12 volts rms. Electrical characteristics: No load: With 120 volts and 400 Hz in (1-2): Current in (1-2): 20 mA maximum. Power in (1-2): 2.40 watts maximum. Voltage across (3-4): 31.5 V rms 2 percent. Rated load: With 120 volts and 400 Hz in (1-2): Voltage across (3-4): 28.6 V rms 5 percent. Current

8、in (3-4): 0.385 A rms. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/134B 3 DC resistance: (1-2) 49.5 ohms. (3-4) 3.1 ohms. Polarity: Additive, with terminals 2 and 3 connected. Temperature rise: 55C with 120 volts, 400 Hz across (1-2) a

9、t an ambient temperature of 100C. Vibration: MIL-STD-202, method 204, test condition D. Marking location: See figure 1. Part or Identification Number (PIN): M27/134-1. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the pre

10、vious issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notation

11、s and relationship to the last previous issue. Referenced documents. In addition to MIL-PRF-27, this document references the following: MIL-DTL-25421 MIL-STD-202 Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force - 85 (Project 5950-2009-005) DLA - CC Review activities: Army - AR,

12、 CR4 Navy - AS, MC, OS, SH Air Force - 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-