DLA DSCC-DWG-85047 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE EIGHT SIZE 8 CONTACT CAVITIES《8信号八种谐振器的微型镶入式电气连接器》.pdf

《DLA DSCC-DWG-85047 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE EIGHT SIZE 8 CONTACT CAVITIES《8信号八种谐振器的微型镶入式电气连接器》.pdf》由会员分享，可在线阅读，更多相关《DLA DSCC-DWG-85047 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE EIGHT SIZE 8 CONTACT CAVITIES《8信号八种谐振器的微型镶入式电气连接器》.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、REVISIONS LTR DESCRIPTION DATE APPROVED B Part number update. Added vendor CAGEs 60563 and 28198; deleted vendor CAGEs 25330 and 71785. 90-07-31 R Marbias C Change “part number” to “Part or Identifying Number (PIN)”. Vendor CAGE 60563, PINs, delete and substitute new PINs. Editor changes throughout.

2、 01-01-22 Robert M. Heber D Add Vendor CAGE SW884, delete MIL-STD-1344 test methods, add EIA-364 test procedures 06-01-20 Richard L. Taylor Prepared in accordance with ASME-Y14.100 REV PAGE REV D C D D REV STATUS OF PAGES PAGE 1 2 3 4 PREPARED BY PMIC N/A Dennis L. Kelly DEFENSE SUPPLY CENTER, COLUM

3、BUS COLUMBUS, OHIO 43218-3990 CHECKED BY TITLE L. V. Olszewski APPROVED BY Richard Marbais CONNECTOR, ELECTRICAL, INSERT ARRANGEMENT, MINIATURE, EIGHT SIZE 8 CONTACT CAVITIES SIZE CAGE CODE 037Z3 DWG. NO.85047 Original date of drawing 8 May 1986 A REV D PAGE 1 OF 4 AMSC N/A 5935-E766-000 Provided by

4、 IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. Engaging face (pin) Inches mm .100 .150 .350 .400 .600 .650 .900 2.54 3.81 8.89 10.16 15.24 16.51 22.86 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information on

5、ly. 3. Unless otherwise specified, tolerance for three place decimals is .005 inch (0.13 mm). 4. All dimensions are true position (TP). 5. Contact holes in insert shall be located on TP within a .005 inch (0.13 mm) diameter circle. 6. Markings are shown for the pin insert front. Socket inserts are t

6、he opposite. 7. Reference documents shall be of the issue in effect on date of invitations for bid. 037Z3 85047 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVC PAGE2 FIGURE 1. Insert arrangement, eight size 8 contact cavities. Provided by IHSNot for ResaleNo reproduction or networking

7、 permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. ENGINEERING DATA: Voltage rating: 500 volts rms at sea level. Operating temperature: -55C to +125C. REQUIREMENTS: Requirements of drawing 85039 and MIL-DTL-24308 are applicable. Dimensions and configurations: See figure 1. Shell size: Fo

8、ur. Shell specifications: Socket: MIL-DTL-24308/1, figure 1. Pin: MIL-DTL-24308/3, figure 1. Dielectric withstanding voltages: See table I. TABLE I. Dielectric withstanding voltage. Altitude Humidity condition All other conditions Sea level 600 1,000 70,000 - 325 Vibration: Test procedure EIA364-28,

9、 test condition IV. Temperature cycling: Test procedure EIA364-32, condition 1, 5 cycles, except temperature shall be -55C to +125C. 037Z3 85047 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license f

10、rom IHS-,-,-SIZE CAGE CODE DWG NO. Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. Vendor similar PIN 1/

11、 DSCC drawing PIN 2/ 3/ 4/ 5/ CAGE 71468 CAGE 60563 CAGE 28198 CAGE SW884 5/ 85047GLJP 5/ 85047GLJS 85047GULPT 85047GULST 85047GULPR 85047GULSR DCMMY8W8PA101 DCMMY8W8SA101 DCMM8W8PA101 DCMM8W8SA101 P88P2D P88R2D P88P2 P88R2 CBM8W8M02F00C-0 CBM8W8F02F00C-0 CBM8W8M02000C-0 CBM8W8F02000C-0 PCMMHW8W8P P

12、CMMHW8W8S PCMMW8W8P PCMMW8W8S 1/ Caution. Do not use this number for item acquisition. Items acquired to this number may not satisfy the performance requirements of this drawing. 2/ Size 8 contacts should be ordered separately. 3/ Size 8 contacts are snap-in and removable. 4/ For size 8 contacts, se

13、e DSCC drawings 89046 through 89061. 5/ Pins 85047GLJP and 85047GLJS are cancelled and superseded by 85047GULPT and 85047GULST respectively. Vender CAGE Vendor name number and address 28198 Positronics Industries, Incorporated 423 North Campbell Springfield, MO 65801-8247 60563 The Phoenix Company 5

14、55 Pond Drive Wood Dale, IL 60191-1192 71468 ITT Cannon P.O. Box 929 666 East Dyer Road Santa Ana, CA 92702-0929 SW884 The Phoenix Company of Chicago, Mexico Carretera Internacional K M 1969 Guadalajara Nogales KM 2 Empalme, Mexico 85340 037Z3 85047 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-