DLA DSCC-DWG-85043 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FIVE SIZE 8 CONTACT CAVITIES《2号8条连接槽的微型镶入装置电气连接器》.pdf

《DLA DSCC-DWG-85043 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FIVE SIZE 8 CONTACT CAVITIES《2号8条连接槽的微型镶入装置电气连接器》.pdf》由会员分享，可在线阅读，更多相关《DLA DSCC-DWG-85043 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FIVE SIZE 8 CONTACT CAVITIES《2号8条连接槽的微型镶入装置电气连接器》.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、REVISIONS LTR DESCRIPTION DATE APPROVED B Part number update. Added vendor CAGEs 60563 and 28198; deleted vendor CAGEs 25330 and 71785. 90-07-31 R Marbias C Delete “part number” and substitute “Part or Identifying Number (PIN)”. Vendor CAGE 60563, PINs, delete and substitute new PINs. Editor changes

2、 throughout. 01-01-22 Robert M. Heber D Add Vendor CAGE SW884, delete MIL-STD-1344 test methods, add EIA-364 test procedures 06-01-20 Richard L. Taylor Prepared in accordance with ASME-Y14.100 REV PAGE REV D C D D REV STATUS OF PAGES PAGE 1 2 3 4 PREPARED BY PMIC N/A Dennis L. Kelly DEFENSE SUPPLY C

3、ENTER, COLUMBUS COLUMBUS, OHIO 43218-3990 CHECKED BY TITLE L. V. Olszewski APPROVED BY Richard Marbais CONNECTOR, ELECTRICAL, INSERT ARRANGEMENT, MINIATURE, FIVE SIZE 8 CONTACT CAVITIES SIZE CAGE CODE 037Z3 DWG. NO.85043 Original date of drawing 8 May 1986 A REV D PAGE 1 OF 4 AMSC N/A 5935-E763-000

4、Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. Engaging face (pin) Inches mm .034 .234 .302 .570 0.86 5.94 7.67 14.48 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. 3. Unless otherwis

5、e specified, tolerance for three place decimals is .005 inch (0.13 mm). 4. All dimensions are true position (TP). 5. Contact holes in insert shall be located on TP within a .005 inch (0.13 mm) diameter circle. 6. Markings are shown for the pin insert front. Socket inserts are the opposite. 7. Refere

6、nce documents shall be of the issue in effect on date of invitations for bid. 037Z3 85043 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVC PAGE2 FIGURE 1. Insert arrangement, five size 8 contacts cavities. Provided by IHSNot for ResaleNo reproduction or networking permitted without lic

7、ense from IHS-,-,-SIZE CAGE CODE DWG NO. ENGINEERING DATA: Voltage rating: 500 volts rms at sea level. Operating temperature: -55C to +125C. REQUIREMENTS: Requirements of drawing 85039 and MIL-DTL-24308 are applicable. Dimensions and configurations: See figure 1. Shell size: Three. Shell specificati

8、ons: Socket: MIL-DTL-24308/1, figure 1. Pin: MIL-DTL-24308/3, figure 1. Dielectric withstanding voltage: See table I. TABLE I. Dielectric withstanding voltage. Altitude Humidity condition All other conditions Sea level 600 1,000 70,000 - 325 Vibration: Test procedure EIA364-28, test condition IV. Te

9、mperature cycling: Test procedure EIA364-32, condition 1, 5 cycles, except temperature shall be -55C to +125C. 037Z3 85043 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE

10、CODE DWG NO. Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. Vendor similar PIN 1/ DSCC drawing PIN 2/ 3

11、/ 4/ 5/ CAGE 71468 CAGE 60563 CAGE 28198 CAGE SW884 5/ 85043GLKP 5/ 85043GLKS 85043GULPT 85043GULST 85043GULPR 85043GULSR DBMMY5W5PA101 DBMMY5W5SA101 DBMM5W5PA101 DBMM5W5SA101 P55P2D P55R2D P55P2 P55R2 CBM5W5M02F00C-0 CBM5W5F02F00C-0 CBM5W5M02000C-0 CBM5W5F02000C-0 PBMMHW5W5P PBMMHW5W5S PBMMW5W5P PB

12、MMW5W5S 1/ Caution. Do not use this number for item acquisition. Items acquired to this number may not satisfy the performance requirements of this drawing. 2/ Size 8 contacts should be ordered separately. 3/ Size 8 contacts are snap-in and removable. 4/ For size 8 contacts, see DSCC drawings 89046

13、through 89061. 5/ Pins 85043GLKP and 85043GLKS are canceled and superseded by 85043GULPT and 85043GULST respectively. Vender CAGE Vendor name number and address 28198 Positronics Industries, Incorporated 423 North Campbell Springfield, MO 65801-8247 60563 The Phoenix Company 555 Pond Drive Wood Dale

14、, IL 60191-1192 71468 ITT Cannon P.O. Box 929 666 East Dyer Road Santa Ana, CA 92702-0929 SW884 The Phoenix Company of Chicago, Mexico Carretera Internacional K M 1969 Guadalajara Nogales KM 2 Empalme, Mexico 85340 037Z3 85043 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-