DLA CCC-C-441 C-1969 CLOTH CORDUROY COTTON《棉灯芯绒布》.pdf

《DLA CCC-C-441 C-1969 CLOTH CORDUROY COTTON《棉灯芯绒布》.pdf》由会员分享，可在线阅读，更多相关《DLA CCC-C-441 C-1969 CLOTH CORDUROY COTTON《棉灯芯绒布》.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、CCC-C-4LILC 83 m 9779774 0055117 9 m . CCC-C-h.h.C September 29, 1969 April 15, is9 and Fed. Spec. CCC4-444 June 26, 1964 SUPERSEDING Ink. Fed. Spec CCC-c-o0441B(h-GL) FEDERAL SPECFICATION CMTH, CORDUROY, COTTON This specification was approved by the Commissioner, Federal Supply Service, General Ser

2、vices Administration, for the use of all Federal agencies. i. SCOPE AND CLASSIFEATION 1.1 w. This specification covers the requirements for cotton, corduroy cloth. 1.2 Classification. es and classes. This specification covers cotton, corduroy cloth of the following types and cakzii a-6.2) : !type I

3、- Natural. Class 1 -10.5 ounce. Type II - Dyed. Class 1 - ?8.0 ounce. Class 2 - 7.2 ounce. 2. APPLICABEE DOCUMENTS 2.1 The following documents of the issue in effect on date of invitation for bids or request for proposal, form a part of this -specificetion to the extent specified Jierein: Federal Sp

4、ecificationf . PPP-P-ll34 - ,Packaging and Packing of Cotton and Cotton-Synthetic Fiber Blend Fabrics (Excluding Duck Fabrics). Federal Standards: Fed, Std. No. 4 - Glossary of Fabric Imperfections. Fed. Test Method Std. No, 191 - Textile Test Methods. (Activities outside ?the Federal Government may

5、 obtain copies of Federal Specifications, Standards, and Handbooks as outlined under General Information in the Index of Federal Specifications and Standards and at %he prices indicated in the Index, The Index, which includes cumulative monthly supplements as issued, is for sale on a subscription ba

6、sis by the Superintendent of Documents, U. S. Government Printing Office, Washington, D.C. 20402. (Single copies of this specification and other Federal spe_cifications reQuired by activities outside the Federal Government for bidding purposes are available ?wi3hout charge from Business ServQe Cente

7、rs at the General Services Adninistration Regional Offices in Boston, New York, Washington, D.C., Atlanta, Chicago, Kansas City, Mo., Fort Worth, Denver, San Francisco, Los Angeles, and Seattle, Washington. (Federal Government activities may obtain copies of Federal Specifications, Standards , and H

8、andbooks and the Index of Federal Specifications and Standards from established distribution points in their agencies. ) Mieary Standard: . ML-STn-105 - Sampling Procedures and Tables for Inspection by Attributes. (Copies of Military Specifications and Standards required by ?contractors in colqectio

9、n with specification procurement functions should be obtained from the procuring activity or as directed by the contracting officer. ) FSC 8305 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ccc-c-441C Weight per Yarns per. inch BreaJdng strength sq

10、uare yard.(min.) dnimum minimum Ounces WarpY Filling Warp Filling 10.5 29 136 86 54 2.2 Other publication. The following document forms a part of this specification to the extent specified herein. request for proposal shall appiy. Unless otherwise indicated, the issue in effect on date of invitation

11、 for bids or . . Rules and Regulatione Under the Textile Fiber Products Identification Act. (Copies may be obtained without charge from the Federal Trade Cornmimion, Washington, D,C, 20580.) National Classification oard: National Motor Freight Classification. Wales. per inch (min.) 10 (Application f

12、or copies shall be addressed to the National Classification Board, 1616 P Street, N,W, Washington, D.C. 20036.) Uniform Classification Codttee: Uniform Freight Classification (Application for copies shall be addressed to the Uniform Classification Committee, Room 202 Union Station, 516 W, Jackson Bl

13、vd., Chicago, Ill. 60606,) 3. REQ- 3.1 Standara sample. When a standard sample is available, the finished cloth shall match the standard sample for shade and shall be equal to or better than the standard sample with respect to all characteristics for which the standard sample is referenced (see 6.3)

14、. 3.2 Katerial. 3.2.1 E. The yarn shall be made fxom cotton, which has beencleaned, carded, drawn and spun into singles for both the warp and fUing, 3.3 Color. 3.3.1 Type I. 3.3.2 Type II. The color of type I cloth shall be natural, The color of type II cloth shall. be as specified and shall match t

15、he standard sample The use of dyes and compounds containing elementary sulfur capable of oxidation to eulfuric The dyestuff shall be chosen and applied so that the dyed and finished cloth shall The color shall match the standard sample under natural. (north sky) daylight or (see 6.3). acid is prohib

16、ited. contain no more labile sulfur than shown.by the standard sample when tested as specified in 4.4. artificial daylight having a color temperature of 75WJ Kelvin and shall be a good approximation to the standard sample under incandescent lamplight at 28oO0 Kelvin. The dyed and finished cloth shal

17、l show colorfastness to combined laundering and bleaching, perspiration, crocking and light equal to or better than the standard sample when tested as specified in 4.4. for colorfastness, the finished cloth shall show iigocd” colorfastness to combined laundering and bleaching, perspiration, crocking

18、, and light when tested as specified in 4.4. 3.3.2.1 MatchiW. 3.3.2.2 Colorfastness, When no standard sample is established, or when the standard sample is not referenced 3.4 miysical requirements. when tested 8s specified in 4.4. The finished cloth shall conform to the requirements specified in tab

19、le I -1 Class 1 2 .IIABIE I. Physical requirements i Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- CCC-C-LiLiLC 3 = 9799774 0055339 . Weight-per. Yarns p. inch. . ounce Warp if Filling square yard (min.) . minimum me II Class 1 8.0 40 126 Class 2

20、7.2 .46 126 ccc -c-441c Breaking strength . . Wales minimum Per inch (min.), Warp Filling 60 45 i4 60 45 15 TABLE I. . msical requirements (con.) 3.6 Nonfibrous materials. 3.6.1 Type I. 3 h.2 Type II. 3.7 B. The starch and protein content including chloroform-soluble and water-soluble material of th

21、e finished cloth shall not exceed 13.0 percent when tested as specified in 4.4. of the finished cloth shall not exceed 2.0 percent when tested as specified in 4.4. The starch and protein content including chloroform-soluble and water-soluble material The pH value of the water extract of the finished

22、 cloth shall be no less than 5.5 nor more than 8.5 when tested as specified in 4.4. 3.8 Length and put-ue. Unless otherwise specified (see 6.2), the cloth shal be furnished in continuous lengths, each not less than 40 yards. specified in PPP-P-ll34. Each length shall be put up in a full width roll a

23、s 3.9 Fiber identification. Each roll shall be labeled, ticketed, or invoiced for fiber content in 3.10 Workmanshi , accordance with the Textile Fiber Products Identification Act. by this specificati5n. The demerit points per 100 square yards shall not exceed the established maximum point value. The

24、 finished cloth shall conform to the quality and grade of product established 4. QUALIU A poor dye penetration, mottled, streaky or cloudy. Excessive neppiness. 4.2.2.2 Examination for length. 4,2,2.2,1 Individual rolls. During the yard-by-yard examination, each roi in the sample shall be examined f

25、or length, Any length found to be less than the minimum specified or more than two yards less than the length marked on the ticket shall be considered a defect with respect to length. The.lot shall be unacceptable if two or more rolls in the sample are defective in respact to length. 4.2.2.2.2 Tatal

26、-yardage in sample. of rolla in the sample is less than the total of the length marked on the tickets. 4.2.2.3 Examination for color and shade. During the yard-by-yard examination, each roll in the sample of type II cloth shall be examined for color and shade. Any roll in the sample off shade, shade

27、d side to side, side to center or end to end, shall be cause.for rejection of the entire lot represented by the saqle. The lot shaU be unacceptable if the total of the actual lengths Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-CCC-C-44LC 3 777977

28、4 0055L2L b = ccc-c-44lC 4.2.2.4 Examination for compliance with the Textile Fiber Products Identification Act, Dur- the yard-by-yard examination, each roll in the sample shall be examined for these defects. The lot shall be unacceptable if two or more rolls in the sample are not labeled, ticketed o

29、r invoiced in accordance with the Textile Fiber Products Identification Act. 4.3 banination of preparation for delivery requirements. An examination shall be made in accordance with the provisions of PFT-P-ll34 to determine that packaging, packing and marking requirements of.section 5 are complied w

30、ith. The methods of testing specified in Fed. Std. No. 191 wherever applicable and as listed in table II shall be followed. The physical and chemical values specified in section 3 apply to the results of the determinations made on a sample unit for test purposes as specified in the applicable test m

31、ethod. AU test reports shall contain the individual values utilized in expressing the final result. The sample unit shall be 1 yard, fulJ. width of type L cloth and 2 continuous yards fuU width of type II cloth. The lot shall be unacceptable if one or more sample units fail to meet any test requirem

32、ents specified. individual values utilized in expressing the final resulta. be in accordance with the following: 4.4 Testing of the end item. The lot size shall be expressed in units of.1 yard. AU test reports shall contain the The sample size (number of sample units) shall e size 800 or less 801 up

33、 to and including 22,000. 22,ooL and over Characteristic Material (cotton yarn) Labile sulfur Colorfastness to: Light Combined laundering and bleaching Perspirat ion Crocking Weight Wales per inch Yarns per inch: warp Filling Breaking strength: Warp Filling Weave Dimensional stability: Warp Filling

34、IIIABLE II. Test methods Requiremarrt paragraph 3.2.1 3.3.2 3.3.2.2 3.3.2.2 3.3.2.2 3.3.2.2 3.4 3.4 3.4 3.4 3.4 3.4 3.4.2 3.5 3.5 Tes% method 1200 r/ 2020 5660 5605 5680 5651 5041 Visual 21 5050 5050 5550 5550 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license fro

35、m IHS-,-,-II. Test methods (con,) Requirement TWt Characteristic paragraph . method Nonfibrous material . . me 1 3.6-1 2611 Type II 3.6 .i 2611 PH 3.7 28U 1/ Unless otherwise specified, a certificate of compliance shall be submitted and WU be acceptable for the stated requirement. 2f The wales per i

36、nch shall be the average of five determinations, rounded off to the nearest whole number, 3f One determination for each sample unit and the result reported as “pass“ or “fail“. 5. PREPARATION FOR DEtI;VERY 5.1 Packaging, The packaging shal be level A or C as specified (see 6.2). 5.1.1 Levels A and C

37、. The cloth, put up as specified, shall be packaged in accordance with the applicable requirements of PPP-P-ll34. 5.2 Packing. 5.2.1 Levels A, B and C, The packing shall be level A, B, or C as specified (see 6.2). The cloth shall be packed in accordance with the applicable requirements of PPP-P-1134

38、 5.3 Markiq. 6. NOTES In addition to any Special marking required by the contract or order, shipments shall be marked in accordance with the requirements of PPP-P-ll34. 6.1 Intended use. The cloth covered by this specification is intended for use in the manufacture of clothing items. 6.2 Ordering da

39、ta. Purchasers should select the preferred options permitted herein and include the following information in procurement documents, (a) Title, number and date of this specification. (b) Ty-pe and class required (see 1.2). (c) Color of cloth required (see 3.3.2 . (d) Width of cloth required (see 3.4.

40、1 I . (e) Minimum length, if other than specified (see 3.8). (f) Selection of applicable levels of packaging and packing (see 5.1 and 5.2). 6.3 Standard sample. For access to standard sample, address the procuring office issuing the invitation for bids L 6 Provided by IHSNot for ResaleNo reproductio

41、n or networking permitted without license from IHS-,-,-ccc-c-44lC CCC-C-441C 83 7777774 0055123 T -c a- MILIPARY CUSTODANS: Am - GL Navy - SA Air Force - 82 Review activities: Am - MD Haw - SA Air Force - 82 . . . . Preparing activity: Av - GL CIVIL AGE1yCIES INTESEST: GSA-FSS HEW COM-m VA JUS-FPI O

42、rders for this publication are to be placed with General Services Administration, acting as an agent for the Superintendent of Documents. documents referenced herein. See section 2 of this specification to obtain extra copies and other 7 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-