DLA A-A-59688 3 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM TIME-DELAY LOW-BREAKING CAPACITY.pdf
《DLA A-A-59688 3 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM TIME-DELAY LOW-BREAKING CAPACITY.pdf》由会员分享,可在线阅读,更多相关《DLA A-A-59688 3 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM TIME-DELAY LOW-BREAKING CAPACITY.pdf(9页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5920 METRIC A-A-59688/3C 4 May 2009 SUPERSEDING A-A-59688/3B October 28, 2004 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET FUSE, CARTRIDGE, INSTRUMENT TYPE, 5 MM X 20 MM, TIME-DELAY, LOW-BREAKING CAPACITY The General Services Administration has authorized the use of this commercial i
2、tem description for all federal agencies. The complete requirements for procuring the fuses described herein shall consist of this document and the issue in effect of A-A-59688. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) specification sheet uses a clas
3、sification system which is included in the PIN as shown in the following example (see NOTES). AA59688/03 - 001 A CID number Dash number (see table I) Configuration (see figure 1) SALIENT CHARACTERISTICS. Interface and physical dimensions. Fuses supplied to this CID specification sheet shall be as sp
4、ecified herein, and shall meet the requirements of ANSI/IEC 60127-2, part 2 (see figure 1). Case or body. The case or body shall be glass. Ferrules. The materials for the ferrules shall be nickel or silver plated brass. Mounting. Configuration A (ferrule type) is intended to be used with an applicab
5、le fuseholder or fuse clip. Configuration B (axial leads) is intended to be directly soldered onto a printed wiring board. Current rating. The ampere rating shall be as specified in table I. Voltage rating. The voltage rating shall be 250 V ac maximum. Voltage drop. Voltage drop shall be in accordan
6、ce with table I. Pre-arcing time/current characteristic. Pre-arcing time/current characteristic shall be as specified in table II. Breaking capacity. The breaking capacity shall be 35 amperes maximum or 10 In, whichever is greater. Endurance. Endurance shall be 100 cycles at 1.2 times the rated curr
7、ent followed by 1 hour at 1.5 times the rated current. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/3C 2 mm Inches Ltr Min Max Min Max A 5.0 5.3 .20 .21 B 8.0 12.0 .31 .47 C 19.5 20.5 .77 .81 D 36.0 41.00 1.42 1.61 E 8.0 12.0 .31 .47 F 1
8、9.7 21.7 .78 .85 G .62 .82 .02 .03 H 5.0 6.0 .20 .24 NOTES: 1. Dimensions are in millimeters. 2. Tolerance is 0.13 mm (.005 inch), unless otherwise specified. FIGURE 1. Interface and physical dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-
9、,-A-A-59688/3C 3 TABLE I. Characteristics. CID dash number AA59688/03- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 001A A 001B B 32 mA 5,000 002A A 002B B 40 mA 4,000 003A A 003B B 50 mA 3,500 004A A 004B B 63 mA 3,000 005A A 005B B 80 mA 3,000 006A A
10、006B B 100 mA 2,500 007A A 007B B 125 mA 2,000 008A A 008B B 160 mA 1,900 009A A 009B B 200 mA 1,500 010A A 010B B 250 mA 1,300 011A A 011B B 315 mA 1,100 012A A 012B B 400 mA 1,000 013A A 013B B 500 mA 900 014A A 014B B 630 mA 300 015A A 015B B 800 mA 250 016A A 016B B 1 A 150 1.6 Provided by IHSNo
11、t for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/3C 4 TABLE I. Characteristics - Continued. CID dash number AA59688/03- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 017A A 017B B 1.25 A 150 018A A 018B B 1.6 A 1
12、50 019A A 019B B 2 A 150 020A A 020B B 2.5 A 120 021A A 021B B 3.15 A 100 022A A 022B B 4 A 100 023A A 023B B 5 A 100 024A A 024B B 6.3 A 100 1.6 TABLE II. Pre-arcing time/current characteristic (+25C 10C). Percent of current rating 210 275 400 1,000 Rated current Max. Min. Max. Min. Max. Min. Max.
13、32 to 100 mA inclusive 2 min. 200 ms 10 s 40 ms 3 s 10 ms 300 ms Above 100 mA to 6.3 A 2 min. 600 ms 10 s 150 ms 3 s 20 ms 300 ms Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/3C 5 NOTES. PIN. The PIN should be used for Government purpose
14、s to buy commercial products to this CID specification sheet. See the classification section for PIN format example. Source of document. Other Publications AMERICAN NATIONAL STANDARDS INSTITUTE/INTERNATIONAL ELECTROTECHNICAL COMMISSION (ANSI/IEC) ANSI/IEC 60127-2 - Miniature Fuses, Part 2: Cartridge
15、 Fuse-Links. (Copies of this document are available online at http:/www.ansi.org/ or from the American National Standards Institute, 25 West 43rd Street, 4th Floor, New York, NY, 10036-7406.) (Industry association specifications and standards are generally available for reference from libraries. The
16、y are also distributed among technical groups and using Federal agencies.) Commercial products. As part of the market analysis and research effort, this CID specification sheet was coordinated with the following manufacturers of commercial products. At the time of CID specification sheet preparation
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAAA596883C2009FUSECARTRIDGEINSTRUMENTTYPE5MMX20MMTIMEDELAYLOWBREAKINGCAPACITYPDF

链接地址:http://www.mydoc123.com/p-687662.html