DLA A-A-59688 1 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM QUICK-ACTING HIGH-BREAKING CAPACITY.pdf

《DLA A-A-59688 1 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM QUICK-ACTING HIGH-BREAKING CAPACITY.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-59688 1 C-2009 FUSE CARTRIDGE INSTRUMENT TYPE 5 MM X 20 MM QUICK-ACTING HIGH-BREAKING CAPACITY.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 AMSC N/A FSC 5920 METRIC A-A-59688/1C 4 May 2009 SUPERSEDING A-A-59688/1B October 28, 2004 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET FUSE, CARTRIDGE, INSTRUMENT TYPE, 5 MM X 20 MM, QUICK-ACTING, HIGH-BREAKING CAPACITY The General Services Administration has authorized the use of this commerci

2、al item description for all federal agencies. The complete requirements for procuring the fuses described herein shall consist of this document and the issue in effect of A-A-59688. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) specification sheet uses a

3、classification system which is included in the PIN as shown in the following example (see NOTES). AA59688 /01 - 001 A CID number Applicable CID sheet (two digits) Dash number (see table I) Configuration (see figure 1) SALIENT CHARACTERISTICS. Interface and physical dimensions. Fuses supplied to this

4、 CID specification sheet shall be as specified herein, and shall meet the requirements of ANSI/IEC 60127-2, part 2 (see figure 1). Case or body. The case or body shall be an opaque tube. Ferrules. The materials for the ferrules shall be nickel or silver plated brass. Mounting. Configuration A (ferru

5、le type) is intended to be used with an applicable fuseholder or fuse clip. Configuration B (axial leads) is intended to be directly soldered onto a printed wiring board. Current rating. The ampere rating shall be as specified in table I. Voltage rating. The voltage rating shall be 250 V ac maximum.

6、 Voltage drop. Voltage drop shall be in accordance with table I. Pre-arcing time/current characteristic. Pre-arcing time/current characteristic shall be as specified in table II. Breaking capacity. The breaking capacity shall be 1,500 amperes maximum at 250 V ac. Endurance. Endurance shall be 100 cy

7、cles at 1.2 times the rated current followed by 1 hour at 1.5 times the rated current. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/1C 2 mm Inches Ltr Min Max Min Max A 5.0 5.3 .20 .21 B 8.0 12.0 .31 .47 C 19.5 20.5 .77 .81 D 36.0 41.00

8、1.42 1.61 E 8.0 12.0 .31 .47 F 19.7 21.7 .78 .85 G .62 .82 .02 .03 H 5.0 6.0 .20 .24 NOTES: 1. Dimensions are in millimeters. 2. Tolerance is 0.13 mm (.005 inch), unless otherwise specified. FIGURE 1. Interface and physical dimensions. Provided by IHSNot for ResaleNo reproduction or networking permi

9、tted without license from IHS-,-,-A-A-59688/1C 3 TABLE I. Characteristics. CID dash number AA59688/01- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 001A A 001B B 50 mA 10,000 002A A 002B B 63 mA 8,800 003A A 003B B 80 mA 7,600 004A A 004B B 100 mA 7,000

10、 005A A 005B B 125 mA 5,000 006A A 006B B 160 mA 4,300 007A A 007B B 200 mA 3,500 1.6 008A A 008B B 250 mA 2,800 009A A 009B B 315 mA 2,500 010A A 010B B 400 mA 2,000 011A A 011B B 500 mA 1,800 012A A 012B B 630 mA 1,500 013A A 013B B 800 mA 1,200 014A A 014B B 1 A 1,000 2.5 015A A 015B B 1.25 A 800

11、 016A A 016B B 1.6 A 600 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/1C 4 TABLE I. Characteristics - Continued. CID dash number AA59688/01- Configuration Current rating (amperes) Maximum voltage drop (mV) Power dissipation (W) max. 01

12、7A A 017B B 2 A 500 018A A 018B B 2.5 A 400 019A A 019B B 3.15 A 350 020A A 020B B 4 A 300 021A A 021B B 5 A 250 022A A 022B B 6.3 A 200 4 TABLE II. Pre-arcing time/current characteristic (+25C 10C). Percent of current rating 210% 275% 400% 1000% Max. Min. Max. Min. Max. Max. 30 min. 10 ms 3 s 3 ms

13、300 ms 20 ms NOTES. PIN. The PIN should be used for Government purposes to buy commercial products to this CID specification sheet. See the classification section for PIN format example. Source of document. Other Publications AMERICAN NATIONAL STANDARDS INSTITUTE/INTERNATIONAL ELECTROTECHNICAL COMMI

14、SSION (ANSI/IEC) ANSI/IEC 60127-2 - Miniature Fuses, Part 2: Cartridge Fuse-Links. (Copies of this document are available online at http:/www.ansi.org/ or from the American National Standards Institute, 25 West 43rd Street, 4th Floor, New York, NY, 10036-7406.) (Industry association specifications a

15、nd standards are generally available for reference from libraries. They are also distributed among technical groups and using Federal agencies.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/1C 5 Commercial products. As part of the market

16、 analysis and research effort, this CID specification sheet was coordinated with the following manufacturers of commercial products. At the time of CID specification sheet preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of thi

17、s CID specification sheet. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only the manufacturers shown.) MFRs CAGE MFRs name and address 75915 Littelfuse Incorporated 800 E. Northwest Highway Des Plaines, IL 60016-3096 Phone

18、 number (847) 824-1188 Facsimile number (847) 391-0894 E-mail: URL: 92912 Bel Fuse Incorporated 206 Van Vorst Street Jersey City, NJ 07302-3096 Phone number (201) 432-0463 Facsimile number (201) 432-9542 E-mail: URL: Provided by IHSNot for ResaleNo reproduction or networking permitted without li

19、cense from IHS-,-,-A-A-59688/1C 6 Part number (P/N) supersession data. These CID specification sheet PINs supersede the following MFRs P/Ns as shown. This information is being provided to assist in reducing proliferation in the Government inventory system. TABLE III. P/N supersession data. MFRs P/N

20、1/ MFRs P/N 1/ CID dash number AA59688/01- (see table I) MFR CAGE 75915 MFR CAGE 92912 CID dash number AA59688/01- (see table I) MFR CAGE 75915 MFR CAGE 92912 001A 216.050 N/A 012A 216.630 5HF630-R 001B 226.050 N/A 012B 226.630 5HFP630-R 002A 216.063 N/A 013A 216.800 5HF800-R 002B 226.063 N/A 013B 2

21、26.800 5HFP800-R 003A 216.080 N/A 014A 216001 5HF001-R 003B 226.080 N/A 014B 226001 5HFP1-R 004A 216.100 5HF100-R 015A 2161.25 5HF1.25-R 004B 226.100 5HFP100-R 015B 2261.25 5HFP1.25-R 005A 216.125 5HF125-R 016A 21601.6 5HF1.6-R 005B 226.125 5HFP125-R 016B 22601.6 5HFP1.6-R 006A 216.160 5HF160-R 017A

22、 216002 5HF2-R 006B 226.160 5HFP160-R 017B 226002 5HFP2-R 007A 216.200 5HF200-R 018A 21602.5 5HF2.5-R 007B 226.200 5HFP200-R 018B 22602.5 5HFP2.5-R 008A 216.250 5HF250-R 019A 2163.15 5HF3.15-R 008B 226.250 5HFP250-R 019B 2263.15 5HFP3.15-R 009A 216.315 5HF315-R 020A 216004 5HF4-R 009B 226.315 5HFP31

23、5-R 020B 226004 5HFP4-R 010A 216.400 5HF400-R 021A 216005 5HF5-R 010B 226.400 5HFP400-R 021B 226005 5HFP5-R 011A 216.500 5HF500-R 022A 21606.3 5HF6.3-R 011B 226.500 5HFP500-R 022B 21606.3 5HFP6.3-R 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID specificati

24、on sheet. At the time of preparation of this CID specification sheet, the aforementioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see the marking paragraph of A-A-59688. Provided by IHSNot for ResaleNo reproduction or network

25、ing permitted without license from IHS-,-,-A-A-59688/1C 7 CID number supersession data. This CID supersedes Defense Supply Center, Columbus (DSCC) drawing 90030 and its dash numbers as shown. TABLE IV. CID number supersession data. CID dash number (see table I) AA59688/01- Superseded DSCC drawing nu

26、mber 90030- CID dash number (see table I) AA59688/01- Superseded DSCC drawing number 90030- 001A 001A 012A 012A 001B 001B 012A 012B 002A 002A 013A 013A 002B 002B 013B 013B 003A 003A 014A 014A 003B 003B 014B 014B 004A 004A 015A 015A 004B 004B 015B 015B 005A 005A 016A 016A 005B 005B 016B 016B 006A 006

27、A 017A 017A 006B 006B 017B 017B 007A 007A 018A 018A 007B 007B 018B 018B 008A 008A 019A 019A 008B 008B 019B 019B 009A 009A 020A 020A 009B 009B 020B 020B 010A 010A 021A 021A 010B 010B 021B 021B 011A 011A 022A 022A 011B 011B 022B 022B Changes from previous issue. Marginal notations are not used in this

28、 revision to identify changes with respect to the previous issue due to the extensiveness of the changes. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59688/1C 8 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FSS Custodians: Nav

29、y - EC Preparing activity: DLA - CC DLA-CC Project 5920-2009-044 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-