DLA A-A-59306 1 B-2012 FUSE CARTRIDGE CLASS T 300 VOLTS AC FAST ACTING.pdf

《DLA A-A-59306 1 B-2012 FUSE CARTRIDGE CLASS T 300 VOLTS AC FAST ACTING.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-59306 1 B-2012 FUSE CARTRIDGE CLASS T 300 VOLTS AC FAST ACTING.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5920 INCH-POUND A-A-59306/1B 26 April 2012 SUPERSEDING A-A-59306/1A 19 December 2007 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET FUSE CARTRIDGE, CLASS T, 300 VOLTS AC, FAST ACTING The General Services Administration has authorized the use of this commercial item description (CID) fo

2、r all federal agencies. The complete requirements for procuring the fuse cartridges described herein shall consist of this document and the issue in effect of A-A-59306. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) specification sheet uses a classificati

3、on system which is included in the PIN as shown in the following example (see NOTES). AA59306 /01 - 001 CID number Applicable CID specification sheet (two digits) Dash number (see table I) SALIENT CHARACTERISTICS. Interface and physical dimensions. Fuse cartridges supplied to this CID specification

4、sheet shall be as specified herein (see figure 1). Ampere rating. The ampere rating shall be as specified in table I. Voltage rating. The voltage rating shall be 300 V ac, 125 V dc. Interrupting rating. The interrupting rating shall be 200,000 amperes root mean square (RMS) symmetrical for ac operat

5、ion and 20,000 amperes for dc operation. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59306/1B 2 AA59306/01- Dimensions A B C 001 through 009 .880 (22.35) .280 (7.11) .406 (10.31) 010 through 014 .880 (22.35) .280 (7.11) .563 (14.30) NOTES: 1.

6、 Dimensions are in inches. 2. Tolerance is .005 inch (0.13 mm), unless otherwise specified. FIGURE 1. Configuration and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59306/1B 3 AA59306/01- Dimensions A B C D E F G H J K L 015 throug

7、h 018 2.156 (54.76) 0.25 (63.5) 0.646 (16.4) 0.250 (21.03) 0.750 (19.05) 0.375 (9.525) 0.125 (3.18) 1.556 (39.52) 0.281 (7.14) 0.850 (21.59) 0.300 (7.62) 019 through 023 2.438 (61.93) 0.25 (63.5) 0.787 (19.99) 1.078 (27.38) 0.875 (22.22) 0.437 (11.11) 0.188 (4.78) 1.695 (43.05) 0.344 (8.74) 0.850 (2

8、1.59) 0.372 (9.45) 024 through 028 2.750 (69.85) 0.25 (63.5) 0.926 (23.52) 1.344 (34.14) 1.000 (25.40) 0.500 (12.70) 0.250 (6.35) 1.844 (46.84) 0.406 (10.31) 0.860 (21.84) 0.453 (11.51) 029 through 031 3.063 (77.80) 0.25 (63.5) 1.074 (27.28) 1.625 (41.28) 1.250 (31.75) 0.625 (15.88) 0.312 (7.92) 2.0

9、31 (51.59) 0.484 (12.29) 0.880 (22.35) 0.516 (13.11) 032 through 033 3.375 (85.73) 0.25 (63.5) 1.222 (31.04) 2.078 (52.78) 1.750 (44.45) 0.875 (22.23) 0.375 (9.53) 2.219 (55.36) 0.547 (13.89) 0.891 (22.63) 0.578 (14.68) 034 through 035 4.000 (101.6) 0.25 (63.5) 1.441 (36.60) 2.516 (63.90) 2.000 (50.

10、80) 1.000 (25.40) 0.438 (11.11) 2.531 (64.29) 0.609 (15.48) 1.078 (27.38) 0.735 (18.67) NOTES: 1. Dimensions are in inches. 2. Tolerance is .005 inch (0.13 mm), unless otherwise specified. 3. The dashed line represents the limit of the maximum 1.58 mm (0.063 in.) projection of the screw, rivet head,

11、 or the like. FIGURE 2. Configuration and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59306/1B 4 TABLE I. Electrical characteristics. CID dash number AA59306/01- Ampere Rating CID dash number AA59306/01- Ampere rating 001 1 019 11

12、0 002 2 020 125 003 3 021 150 004 6 022 175 005 10 023 200 006 15 024 225 007 20 025 250 008 25 026 300 009 30 027 350 010 35 028 400 011 40 029 450 012 45 030 500 013 50 031 600 014 60 032 700 015 70 033 800 016 80 034 1000 017 90 035 1100 018 100 036 1200 NOTES. PIN. The PIN should be used for Gov

13、ernment purposes to buy commercial products to this CID specification sheet. See the classification section for PIN format example. Source of documents. Other publications. UNDERWRITERS LABORATORIES, INCORPORATED (UL) UL 248-15 - Low-Voltage Fuses - Part 15: Class T Fuses. (Copies of this document a

14、re available online at http:/ or from the Underwriters Laboratories, Incorporated, 333 Pfingsten Road, Northbrook, IL 60062-2096.) (Industry association specifications and standards are generally available for reference from libraries. They are also distributed among technical groups and using Feder

15、al agencies.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59306/1B 5 Commercial products. As part of the market analysis and research effort, this CID specification sheet was coordinated with the following manufacturers of commercial products

16、. At the time of CID specification sheet preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID specification sheet. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restr

17、ict procurement to only the manufacturers shown.) MFRs CAGE MFRs name and address 71400 Cooper Bussmann, Incorporated P. O. Box 14460 St. Louis, MO 63178-4460 Phone number (636) 394-2877 Facsimile number (800) 544-2570 E-mail: mailto: Uniform Resource Locator (URL): http:/ Part number (P/N) superses

18、sion data. These CID specification sheet PINs supersede the following MFRs P/Ns as shown. This information is being provided to assist in reducing proliferation in the Government inventory system. TABLE III. P/N supersession data. CID dash number AA59306/01- (see table I) MFRS CAGE 71400 CID dash nu

19、mber AA59306/01- (see table I) MFRS CAGE 71400 MFRs P/N 1/ MFRs P/N 1/ 001 JJN-1 019 JJN-110 002 JJN-2 020 JJN-125 003 JJN-3 021 JJN-150 004 JJN-6 022 JJN-175 005 JJN-10 023 JJN-200 006 JJN-15 024 JJN-225 007 JJN-20 025 JJN-250 008 JJN-25 026 JJN-300 009 JJN-30 027 JJN-350 010 JJN-35 028 JJN-400 011

20、 JJN-40 029 JJN-450 012 JJN-45 030 JJN-500 013 JJN-50 031 JJN-600 014 JJN-60 032 JJN-700 015 JJN-70 033 JJN-800 016 JJN-80 034 JJN-1000 017 JJN-90 035 N/A 018 JJN-100 036 JJN-1200 1/ The manufacturers P/N shall not be used for acquisition to the requirements of this CID specification sheet. At the t

21、ime of preparation of this CID specification sheet, the aforementioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see the marking paragraph of A-A-59306. Provided by IHSNot for ResaleNo reproduction or networking permitted with

22、out license from IHS-,-,-A-A-59306/1B 6 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FAS Custodians: Navy - E

23、C Preparing activity: DLA - CC DLA-CC Project 5920-2012-017 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-