DLA A-A-55518 3 C-2011 FUSEHOLDER BLOCK 30 AMPERES (A) 250 VOLTS (V) AC 1 THROUGH 12 POLE ACCOMMODATES 4AG OR 4AB TYPE FUSE CARTRIDGES.pdf
《DLA A-A-55518 3 C-2011 FUSEHOLDER BLOCK 30 AMPERES (A) 250 VOLTS (V) AC 1 THROUGH 12 POLE ACCOMMODATES 4AG OR 4AB TYPE FUSE CARTRIDGES.pdf》由会员分享,可在线阅读,更多相关《DLA A-A-55518 3 C-2011 FUSEHOLDER BLOCK 30 AMPERES (A) 250 VOLTS (V) AC 1 THROUGH 12 POLE ACCOMMODATES 4AG OR 4AB TYPE FUSE CARTRIDGES.pdf(4页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5920 INCH-POUND A-A-55518/3C 17 March 2011 SUPERSEDING A-A-55518/3B 22 June 2006 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET FUSEHOLDER, BLOCK, 30 AMPERES (A), 250 VOLTS (V) AC, 1 THROUGH 12 POLE, ACCOMMODATES 4AG OR 4AB TYPE FUSE CARTRIDGES The General Services Administration has a
2、uthorized the use of this commercial item description for all federal agencies. The complete requirements for procuring the fuseholder blocks described herein shall consist of this document and the issue in effect of A-A-55518. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item
3、 description (CID) specification sheet uses a classification system which is included in the PIN as shown in the following example (see NOTES). AA55518 /03 - 001 CID number Applicable CID specification sheet (two digits) Dash number SALIENT CHARACTERISTICS. Interface and physical dimensions. Fusehol
4、der blocks supplied to this CID specification sheet shall be as specified herein (see figure 1). Ampere rating. The ampere rating shall be 30 A maximum. Voltage rating. The voltage rating shall be 250 V ac maximum. Fuse accommodation. This fuseholder block accommodates 4AG or 4AB type fuse cartridge
5、s with dimensions of .281 inch x 1.25 inch (7.14 mm x 31.75 mm). Fuseholder block base. The fuseholder block base shall be molded or laminated plastic. Fuse clips. This fuseholder block shall be supplied with Commercial Item Description (CID) number AA55507/01-02 fuse clips. Provided by IHSNot for R
6、esaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55518/3C 2 NOTES: 1. Dimensions are in inches. 2. Unless otherwise specified, tolerance is .005 inch (0.13 mm). 3. The following notes apply to width A of the fuseholder blocks (see table I). a. The longitudinal centerline
7、 of single pole and outer pairs of fuse clips of multiple pole fuseholder blocks shall be located .39 inch (9.9 mm) from the edge of the block. b. The distance between longitudinal centerlines of adjacent pairs of fuse clips shall be .91 inch (23.1 mm). c. A minimum of two mounting holes shall be pr
8、ovided on multiple pole fuseholder blocks. These holes shall be one each centrally located between the fuse clips on the longitudinal centerline of the outer pairs of fuse clips. FIGURE 1. Configuration and dimensions (screw terminals).Inches mm Inches mm .031 0.79 .440 11.18 .170 4.32 .810 20.57 .2
9、20 5.59 1.190 30.23 .250 6.35 1.280 32.51 .270 6.86 2.382 60.50 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55518/3C 3 TABLE I. Characteristics. CID dash number AA55518/03- Number of poles Dimension A (see figure 1) 001 1 .78 (19.8) 002 2 1.6
10、9 (42.9) 003 4 3.50 (88.9) 004 9 8.03 (204.0) NOTES. PIN. The PIN should be used for Government purposes to buy commercial products to this CID specification sheet. See the classification section for PIN format example. Source of document. FEDERAL SPECIFICATIONS A-A-55507/1 - Clip Electrical, Fuse,
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAAA555183C2011FUSEHOLDERBLOCK30AMPERESA250VOLTSVAC1THROUGH12POLEACCOMMODATES4AGOR4ABTYPEFUSECARTRIDGESPDF

链接地址:http://www.mydoc123.com/p-686890.html