DLA A-A-55475 D-2012 FUSEHOLDER EXTRACTOR POST.pdf

《DLA A-A-55475 D-2012 FUSEHOLDER EXTRACTOR POST.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55475 D-2012 FUSEHOLDER EXTRACTOR POST.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may improve this document should be sent to: DLA Land and Maritime, ATTN: VAT, P.O. Box 3990, Columbus, OH 43218-3990, or email mailto:CircuitProtectdla.mil. Since contact information can change you m

2、ay want to verify the currency of the address information using the ASSIST Online database at https:/assist.daps.dla.mil/. AMSC N/A FSC 5920 INCH-POUND A-A-55475D 9 May 2012 SUPERSEDING A-A-55475C 3 May 2007 COMMERCIAL ITEM DESCRIPTION FUSEHOLDER, EXTRACTOR POST The General Services Administration h

3、as authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for an extractor post fuseholder. Fuseholders covered by this CID are intended for commercial/industrial applications. 2. CLASSIFICATIO

4、N/PART OR IDENTIFICATION NUMBER (PIN). This CID uses a classification system which is included in the PIN as shown in the following example (see 7.1). AA55475 - 001 CID PIN Dash number (see table I) 3. SALIENT CHARACTERISTICS. 3.1 Interface and physical dimensions. Fuseholders supplied to this CID s

5、hall be as specified herein (see figure 1). 3.2. Ampere rating. The ampere rating shall be as specified in table I. 3.3 Voltage rating. The voltage rating shall be 32 V dc. 3.4 Fuseholder configuration. AA55475-001 through AA55475-006 is assembled and includes lead wire contacts, a wire loop and a f

6、use. AA55475-007 through AA55475-018 is unassembled and includes lead wire contacts only (no fuse or lead wire included). AA55475-019 is assembled and includes lead wire contacts, a wire loop and three springs to accommodate all fuses indicated in table I. 3.5 Marking. Fuseholders supplied to this C

7、ID shall be marked with the manufacturers (MFRs) standard commercial PIN and the UL listing mark. (NOTE: The part number marked on the unit pack shall be the CID PIN.) 3.6 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials shoul

8、d be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous life cycle costs. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 2 N

9、OTES: 1. Dimensions are in inches. 2. Tolerance is .005 inch (0.13 mm), unless otherwise specified. FIGURE 1. Configuration and dimensions. Inches mm 0.69 17.52 2.18 55.58 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 3 TABLE I. Characte

10、ristics. CID PIN AA55475- Ampere rating Wire loop size Wire contact size (AWG) Fuse accommodation (CID PIN) Fuse installed (Y-yes, N-no) length inch (mm) gauge (AWG) 001 4 19 (482.6) 14 N/A AA55476-001 Y 002 6 19 (482.6) 14 N/A AA55476-002 Y 003 7.5 19 (482.6) 14 N/A AA55476-003 Y 004 9 19 (482.6) 1

11、4 N/A AA55476-004 Y 005 14 19 (482.6) 14 N/A AA55476-005 Y 006 20 19 (482.6) 14 N/A AA55476-006 Y 007 4 N/A N/A 18 - 20 AA55476-001 N 008 6 N/A N/A 18 - 20 AA55476-002 N 009 7.5 N/A N/A 18 - 20 AA55476-003 N 010 9 N/A N/A 18 - 20 AA55476-004 N 011 14 N/A N/A 18 - 20 AA55476-005 N 012 20 N/A N/A 18 -

12、 20 AA55476-006 N 013 4 N/A N/A 14 AA55476-001 N 014 6 N/A N/A 14 AA55476-002 N 015 7.5 N/A N/A 14 AA55476-003 N 016 9 N/A N/A 14 AA55476-004 N 017 14 N/A N/A 14 AA55476-005 N 018 20 N/A N/A 14 AA55476-006 N 019 4 - 20 8 (203.2) min 15 (381) max 14 N/A AA55476-001 through -006 N 3.7 Workmanship. Fus

13、eholders shall be processed in such a manner as to be uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance. 4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accord

14、ance with 23.403 of the Federal Acquisition Regulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS. 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance practices, and b

15、e the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 4 5.2 Market acceptance. The following market acceptance

16、criteria are necessary to document the quality of the product to be provided under this CID: a. The company producing the item must have been producing a product meeting the requirements of this CID for at least 2 years. b. The company producing the item must have sold 1,000 units meeting this CID i

17、n the commercial marketplace over the past 2 years. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES. 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See section 2 for PIN format example. 7.2 Env

18、ironmentally preferable materials. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this document, the U.S. Environmental Protection Agency (EPA) is focusing efforts on reducing 31 priority chemical

19、s. The list of chemicals and additional information is available on their website http:/www.epa.gov/osw/hazard/watemin/priority.htm. Included in the EPA list of 31 priority chemicals are cadmium, lead, and mercury. Use of these materials should be minimized or eliminated unless needed to meet the re

20、quirements specified herein (see section 3). 7.3 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these fuseholders to DLA Land and Maritime under the Military Parts Control Advisory Group (MPCAG) evaluation program, CAGE code 58536 should be

21、used. 7.4 Source of documents. FEDERAL REGULATIONS FAR - Federal Acquisition Regulations (FAR). (Copies of this document are available online at https:/www.acquisition.gov/comp/far/index.html or from the U.S. Government Printing Office, 732 N. Capital Street, NW, Washington D.C. 20401-0001.) Commerc

22、ial Item Description A-A-55476 - Fuse, Cartridge, Type SFE (Copies of this document are available online at https:/assist.daps.dla.mil/quicksearch/ or https:/assist.daps.dla.mil or from the DLA Document Services, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.) 7.5 Ordering data. The c

23、ontract or order should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 5 7.6 Commercial products. As part

24、of the market analysis and research effort, this CID was coordinated with the following manufacturers of commercial products. At the time of CID preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID. (NOTE: This informat

25、ion should not be considered as a list of approved manufacturers or be used to restrict acquisition to only the manufacturers shown.) MFRs CAGE MFRs name and address 71400 Cooper Bussmann, Incorporated P. O. Box 14460 St. Louis, MO 63178-4460 Phone number (636) 394-2877 Facsimile number (800) 544-25

26、70 E-mail: mailto: Uniform Resource Locator (URL): http:/ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 6 7.7 Part number (P/N) supersession data. These CID PINs supersede the following MFRs P/Ns as shown. This information is being provi

27、ded to assist in reducing proliferation in the government inventory system. TABLE III. P/N supersession data. CID dash number AA55475- MFRs CAGE 71400 MFRs CAGE 75915 MFRs P/N 1/ MFRs P/N 1/ 001 HRF 155004A 002 HRG 155006A 003 HRE 15507.5A 004 HRH 155009A 005 HRI 155014A 006 HRJ 155020A 007 HAF-A N/

28、A 008 N/A N/A 009 N/A N/A 010 N/A N/A 011 HHI-A N/A 012 HHJ-A N/A 013 HIF-B 155004U 014 N/A 155006U 015 N/A 15507.5U 016 N/A 155009U 017 HHI-B 155014U 018 HHJ-B 155020U 019 HRK 155145 1/ The manufacturers P/N shall not be used for acquisition to the requirements of this CID. At the time of preparati

29、on of this CID, the aforementioned commercial products were reviewed and could be replaced by the CID P/N shown. For actual part marking requirements see 3.5. 7.8 Government users. To acquire information on obtaining these fuseholders from the Government inventory system, contact DLA Land and Mariti

30、me, ATTN: DLA Land and Maritime-FMX, Post Office Box 3990, Columbus, OH 43218-3990, or telephone (614) 692-3677. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55475D 7 7.8.1 National stock number (NSN). The following is a list of NSNs assigned

31、which correspond to this CID. The list is for information only and may not be indicative of all possible NSNs associated with the CID. For up to date information on assigned NSNs, please contact the aforementioned DLA Land and Maritime office (see 7.8). TABLE IV. NSNs. Dash number (see table I) AA55

32、475- NSN Dash number (see table I) AA55475- NSN 001 N/A 011 N/A 002 N/A 012 5920-01-255-4282 003 5920-01-252-0193 013 N/A 004 5920-00-242-2706 014 N/A 005 N/A 015 N/A 006 N/A 016 N/A 007 N/A 017 N/A 008 N/A 018 N/A 009 N/A 019 5920-01-396-1989 010 N/A N/A 7.9 Changes from previous issue. Marginal no

33、tations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FAS Custodians: Navy - EC Preparing activity: DLA - CC DLA-CC Project 5920-2012-012 NOTE: The activities

34、 listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-