DLA A-A-50193 B-2011 ETHYLENE ABSORBER SHELF-LIFE EXTENDER BLANKET POTASSIUM PERMANGANATE FOR FRESH FRUITS AND VEGETABLES.pdf

《DLA A-A-50193 B-2011 ETHYLENE ABSORBER SHELF-LIFE EXTENDER BLANKET POTASSIUM PERMANGANATE FOR FRESH FRUITS AND VEGETABLES.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-50193 B-2011 ETHYLENE ABSORBER SHELF-LIFE EXTENDER BLANKET POTASSIUM PERMANGANATE FOR FRESH FRUITS AND VEGETABLES.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: STDZNMGTdla.mil or Defense Logistics Agency Aviation VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-5616. Since contact information can change, you m

2、ay want to verify the currency of this address information using the ASSIST database at https:/assist.daps.dla.mil/. FSC 6850 INCH-POUND A-A-50193B 12 April 2011 SUPERSEDING A-A-50193A 18 July 1997 COMMERCIAL ITEM DESCRIPTION ETHYLENE ABSORBER/SHELF-LIFE EXTENDER BLANKET, POTASSIUM PERMANGANATE, FOR

3、 FRESH FRUITS AND VEGETABLES The General Services Administration has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers a porous fabric blanket containing ethylene-absorbing material. The blanket is intended to ext

4、end the shelf-life of fresh fruits and vegetables when it is used in their storage. 2. SALIENT CHARACTERISTICS 2.1 Absorbing materials. The absorbing material shall be activated alumina (aluminum oxide) coated or impregnated with potassium permanganate (KMnO4) and shall have a maximum moisture conte

5、nt of 16 percent. The absorbing material shall be spherical or pelletized in shape and shall be porous for efficient removal of ethylene from the atmosphere. The absorbing material shall be bright purple in color and free of dust. 2.2 Construction. The blanket shall contain a range of 12 to 15 pound

6、s of absorbing material. The fabric shall be a porous barrier such as non-woven polyester or similar material which allows passage of air, and is dense enough to prevent pellets or excessive particle fines from escaping to the atmosphere. The blanket shall be constructed to withstand tearing during

7、normal placement in refrigerated walk-in boxes or shipping containers. The blanket shall be rectangular in shape and the surface area shall be in the range of 500 to 1200 square inches (in2) per side. Eyelets to facilitate hanging shall be built into the outer borders of the blanket. Eyelets shall b

8、e placed so that the absorbing material will distribute evenly and not be compacted to one end when in a hanging position. A tag shall be affixed to the blanket and shall have the following statement: “AVOID CONTACT WITH WATER“.Provided by IHSNot for ResaleNo reproduction or networking permitted wit

9、hout license from IHS-,-,-A-A-50193B 2 2.3 Performance. 2.3.1 Moisture analysis. Analysis for moisture shall be made in accordance with the latest edition of the “Official Methods of Analysis of AOAC International“: Test Source Method Moisture Chapter: Cereal foods Air oven method Section: Wheat flo

10、ur 2.3.2 Potassium permanganate. The absorbing material shall have a minimum content of 4 percent KMnO4by weight to provide adequate capacity for ethylene removal. The determination for weight percentage of KMnO4shall be as follows: a. Prepare a standard KMnO4solution by mixing 0.100 gram (g) KMnO4i

11、n 100 milliliters (mL) of water and then dilute it 20-fold (1 volume of KMnO4solution plus 19 volumes of water). This will produce a concentration of 0.005 percent by mass of KMnO4. b. Read the absorbency of the KMnO4solution on a spectrophotometer at 525 nanometers against water as the blank (Astd)

12、. c. With a mortar and pestle, pulverize the absorbing material into a fine powder. Mix 1 g of the powder with 100 mL of water in a flask and stir gently for 10 minutes. Filter an aliquot of the solution. d. Dilute the absorbing material solution 10-fold and read the absorbency at 525 nanometers (As

13、ample). e. Determine percentage using the formula: Percent KMnO4= (Asample/Astd) x (0.005 mass %) x 1000 3. REGULATORY REQUIREMENTS 3.1 Recovered materials. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the F

14、ederal Acquisition Regulation (FAR). 3.2 Material safety data sheet (MSDS). A MSDS shall be furnished in accordance with FED-STD-313, “Material Safety Data, Transportation Data and Disposal Data for Hazardous Materials Furnished to Government Activities“, and 29 CFR 1910.1200, “Hazard Communication“

15、. 3.3 Hazard warning label. An Occupational Safety and Health Administration hazard warning label shall be furnished in accordance with 29 CFR 1910.1200. 4. PRODUCT CONFORMANCE PROVISIONS 4.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections, examina

16、tions, and tests. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-50193B 3 4.2 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and qu

17、ality assurance practices, and be the same product offered for sale in the commercial marketplace. The government reserves the right to require proof of such conformance. 4.3 Market acceptability. The products offered must have been previously sold either to the government or on the commercial marke

18、t. 5. PACKAGING 5.1 Preservation, packing, and marking. Preservation, packing, and marking shall be as specified in the acquisition order (see 6.2(b). 6. NOTES 6.1 Sources of documents. 6.1.1 CFR and FAR. Copies of CFR and FAR may be obtained from the Superintendent of Documents, P.O. Box 371954, Pi

19、ttsburgh, PA 15250-7954. Electronic copies of CFR documents may be obtained from http:/www.gpoaccess.gov/ecfr/. Electronic copies of FAR documents may be obtained from https:/www.acquisition.gov/far/. 6.1.2 Federal standards. Copies of federal standards may be obtained from General Services Administ

20、ration, Federal Supply Service, Specification Section, 470 East LEnfant Plaza SW, Suite 8100, Washington, DC 20407. Electronic copies may be obtained from https:/assist.daps.dla.mil/. 6.1.3 AOAC. Copies of the Official Methods of Analysis of AOAC International may be obtained from AOAC International

21、, 481 North Fredrick Avenue, Suite 500, Gaithersburg, MD 20877-2417. Electronic copies may be obtained from http:/www.aoac.org/. 6.2 Ordering data. The acquisition order should specify the following information: a. CID document number and revision. b. Preservation, packing, and marking (see 5.1) 6.3

22、 Subject term (key word) listing. Alumina Aluminum oxide Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-50193B 4 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY:Custodians: GSA - FAS Army - GL Navy - MC Air Force - 68 DLA - GS Review Acti

23、vities: Army - MD1 Navy - SH DLA - SS Preparing Activity: DLA - GS3 (Project 6850-2011-001) NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST database at https:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-