ASD-STAN PREN 2240-065-1996 Aerospace Series Lamps Incandescent Part 065 Lamp Code 1820 Product Standard (Edition P 1)《航空航天系列 白炽灯 第065部分 灯 型号1820 产品标准 第P1版》.pdf

《ASD-STAN PREN 2240-065-1996 Aerospace Series Lamps Incandescent Part 065 Lamp Code 1820 Product Standard (Edition P 1)《航空航天系列 白炽灯 第065部分 灯 型号1820 产品标准 第P1版》.pdf》由会员分享，可在线阅读，更多相关《ASD-STAN PREN 2240-065-1996 Aerospace Series Lamps Incandescent Part 065 Lamp Code 1820 Product Standard (Edition P 1)《航空航天系列 白炽灯 第065部分 灯 型号1820 产品标准 第P1版》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、STD*AECMA PREN 2240-0b5-ENGL L77b = LOL2311 0012447 b72 AECMA STANDARD NORME AECMA AECMA NORM prEN 2240-065 August 1996 Edition P 1 PUBLISHED BY THE EUROPEAN ASSOCIATION OF AEROSPACE INDUSTRIES (AECMA) Gulledelle 94 - B-1200 BRUXELLES - Tel. (32) 2 775 81 10 - Fax. (32) 2 775 81 11 ICs : 49.060 Desc

2、riptors : ENGLISH VERSION Aerospace series Lamps, incandescent Part 065 : Lamp, code 1820 Product standard Srie arospatiale Lampes incandescence Partie 065 : Lampe, code 1820 Norme de produit Luft- und Raumfahrt Glhlampen Teil 065 : Lampe, Kode 1820 Produktnorm This “Aerospace Series Prestandard has

3、 been drawn up under the responsibility of AECMA (The European Association of Aerospace Industries). It is published on green paper for the needs of AECMA-Members. It has been technically approved by the experts of tbe concerned Technical Committee following comment by the Member countries. Subseque

4、nt to the publication of this Prestandard, the technical content shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard, After examination and signature of the AECMA Standard Checking Centre INPSI and formal agreem

5、ent of the Official Services of the Member countries it will be submitted as a draft European Standard to CEN (European Committee for Standardization) for formal vote. Nota - Extra copies can be supplied by B.N.A.E. - Technopolis 54 - 199, rue Jean-Jacques Rousseau - 921 38 ISSY-LEC-MOULINEAUX CEDEX

6、 I Comments should be sent within six months after the date of publication to I Edition approved for publication C2 Chairman 1996-08-30 AECMA Gulledelle 94 B-1200 BRUXELLES I I aecma 1996 Mr Pezzetta STD-AECMA PREN 2240-0b5-ENGL 177b m LOL2311 0012448 507 m Page 3 prEN 2240-065 : 1996 1 Scope This s

7、tandard specifies the required characteristics for lamp, code 1820, used on-board aircraft. It shall be used together with EN 2756. 2 Normative references This European Standard incorporates by dated or undat eference provisions from other publications. These normative references are cited at the ap

8、propriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the pub

9、lication referred to applies. EN 2240-001 EN 2240-002 EN 2241 EN 2756 Aerospace series - Lamps, incandescent - Part 001 : Technical specification Aerospace series - Lamps, incandescent - Part 002 : Main characteristics - General Aerospace series - Lamp caps - Dimensions Aerospace series - Lamps, inc

10、andescent - Tests 3 Required characteristics 3.1 Dimensions and mass See figure 1 and table 1. Dimensions are given in millimetres. Figure 1 d Table 1 1) Published as AECMA Prestandard at the date of publication of this standard Previous page is blank Page 4 prEN 2240-065 : 1996 3.2 Other characteri

11、stics See table 1. 3.3 Form of filament See EN 2240-002. 3.4 Cap BASSI1 4 - See EN 2241. 4 Designation EXAMPLE : Identity block I EN2240-1820 Description block LAMP, INCANDESCENT IT Number of the basic standard Code NOTE : If necessary, the code 19005 shall be placed between the description block and the identity block. 5 Marking Unless there is not enough space, the lamp and its packaging shall be marked with the international code number such as indicated in prEN 2240-002. a Technical specification See EN 2240-001.