ARMY MIL-PRF-55310 29 C-2011 OSCILLATOR CRYSTAL CONTROLLED TYPE 1 (CRYSTAL OSCILLATOR (XO)) 0 2 MHz THROUGH 85 MHz HERMETIC SEAL SQUARE WAVE HCMOS.pdf
《ARMY MIL-PRF-55310 29 C-2011 OSCILLATOR CRYSTAL CONTROLLED TYPE 1 (CRYSTAL OSCILLATOR (XO)) 0 2 MHz THROUGH 85 MHz HERMETIC SEAL SQUARE WAVE HCMOS.pdf》由会员分享,可在线阅读,更多相关《ARMY MIL-PRF-55310 29 C-2011 OSCILLATOR CRYSTAL CONTROLLED TYPE 1 (CRYSTAL OSCILLATOR (XO)) 0 2 MHz THROUGH 85 MHz HERMETIC SEAL SQUARE WAVE HCMOS.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5955 INCH-POUND MIL-PRF-55310/29C 25 March 2011 SUPERSEDING MIL-PRF-55310/29B 24 February 2005 PERFORMANCE SPECIFICATION SHEET OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO), 0.2 MHz THROUGH 85 MHz, HERMETIC SEAL, SQUARE WAVE, HCMOS This specification is approved for us
2、e by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310. FIGURE 1. Dimensions and configuration. Pin number Function 4 B+ 10 B+ 31 GND 32 Disable/enable 37 GND 39 Output 1-3 NC 5
3、-9 NC 11-30 NC 33-36 NC 38 NC 40 NC Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-55310/29C 2 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for gen
4、eral information only. 3. Unless otherwise specified, tolerances are .005 (0.13 mm) for three place decimals and .02 (0.5 mm) for two place decimals. 4 All pads with NC functions are not connected externally. FIGURE 1. Dimensions and configuration - Continued. Ltr Inches mm Min Max Min Max A .454 .4
5、66 11.53 11.84 B .465 SQ .495 SQ 11.81 SQ 12.57 SQ C - .085 - 2.16 D .033 .047 0.84 11.94 E .015 .025 0.38 0.63 F .055 .070 1.40 1.78 G .355 SQ .365 SQ 9.02 SQ 9.27 SQ H .035 .045 0.89 1.14 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reprodu
6、ction or networking permitted without license from IHS-,-,-MIL-PRF-55310/29C 3 REQUIREMENTS: Interface and physical dimensions: See figure 1. Mounting: See figure 1. Pads: See figure 1. Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate 5 x 10-8 atm cc/s. Weight: 3 grams, maximum.
7、 Oscillator: Class 2 or any class 1 or class 3 oscillator meeting all class 2 requirements and verification tests specified herein and in MIL-PRF-55310. Calibration: Manufacturer calibrated. Screening: In accordance with MIL-PRF-55310, product level B or S, as applicable. Temperature: Operating: See
8、 table I. Storage: -62C to +125C. Load test circuit: See figure 2. Supply voltage: +5.0 V dc 10 percent. Supply current: See table I. Overvoltage survivability: In accordance with MIL-PRF-55310. Start-up time: 15 ms maximum, measurement shall be taken at reference temperature and operating temperatu
9、re range end points. Nominal output frequency: Specified nominal frequency (see table I). Output levels at designated load: See figure 3. Logic 1: 0.9 VDD, minimum. Logic 0: 0.1 VDD, maximum. Output waveform: Symmetrical square wave, HCMOS logic compatible (see figure 3). Duty cycle: See table I and
10、 figure 3. Rise and fall times: See table I and figure 3. Enable/disable: Output disabled (high impedance): Pad 32 input = 0.8 V dc maximum. Output enabled: Pad 32 input = 2.0 V dc minimum. Initial frequency accuracy at +23C: See table I. Copyright Communications - Electronics Command Provided by IH
11、S under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-55310/29C 4 TABLE I. Dash numbers and operating characteristics. 1/ Maximum input current for no load condition. 2/ Up to 30 days following shipment. 3/ After 30 days following shipmen
12、t. 4/ See figure 3. TABLE II. Frequency aging limits. 1/ See table I. Initial frequency - temperature accuracy (1/2 temperature cycle): See table I. Measurements shall be taken at ten equally spaced increments over the specified operating temperature range. Frequency - voltage tolerance for 10 perce
13、nt change in supply voltage: For output frequency 40.0 MHz: 2 ppm, maximum. For output frequency 40.0 MHz: 4 ppm, maximum. Frequency - environmental tolerance: 3 ppm. Frequency aging: Frequency aging shall be in accordance with MIL-PRF-55310 and shall meet the limits of table II. Dash number Output
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ARMYMILPRF5531029C2011OSCILLATORCRYSTALCONTROLLEDTYPE1CRYSTALOSCILLATORXO02MHZTHROUGH85MHZHERMETICSEALSQUAREWAVEHCMOSPDF

链接地址:http://www.mydoc123.com/p-447476.html