ARMY MIL-PRF-3098 113 E-2011 CRYSTAL UNIT QUARTZ CR134 U.pdf

《ARMY MIL-PRF-3098 113 E-2011 CRYSTAL UNIT QUARTZ CR134 U.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-PRF-3098 113 E-2011 CRYSTAL UNIT QUARTZ CR134 U.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 INCH-POUND AMSC N/A FSC 5955 MIL-PRF-3098/113E 11 July 2011 SUPERSEDING MIL-PRF-3098/113D 27 July 2005 PERFORMANCE SPECIFICATION SHEET CRYSTAL UNIT, QUARTZ, CR134/U This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring th

2、e product described herein shall consist of this specification sheet and MIL-PRF-3098. Pertinent characteristics: 18 MHz to 21 MHz; fundamental; noncontrolled; antiresonance. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Marking to be in accorda

3、nce with MIL-PRF-3098. FIGURE 1. Crystal unit - CR134/U. Ltr Inches mm Min Max Min Max A - .402 - 10.21 B - .183 - 4.65 C - .435 - 11.05 D .184 .200 4.67 5.08 E - .530 - 13.46 F .50 - 12.7 - G - .150 - 3.81 H .015 .019 0.38 0.48 Copyright Communications - Electronics Command Provided by IHS under li

4、cense with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-3098/113E 2 REQUIREMENTS: Dimensions, marking, and configuration: See figure 1. Frequency range: 18 MHz to 21.0 MHz, inclusive. Capacitance, shunt: 6.0 pF +.05 pF, -1.0 pF. Mode of oscillation:

5、Fundamental. Frequency tolerances: Primary operating temperature range: 25 ppm. Secondary operating temperature range: 50 ppm. Equivalent resistance: 20 ohms, maximum. Rated drive level: 1.0 mW, maximum. Antiresonance, load capacitance: 32.0 pF 0.5 pF. Reference temperature: +85C 1C. Operating tempe

6、rature ranges (noncontrolled): Primary: +10C to +80C, inclusive. Secondary: -40C to +10C and +80C to +90C, inclusive. Shock (specified pulse): Frequency change permitted: 5 ppm. Equivalent resistance change permitted: 10 percent. Vibration: Method 204, MIL-STD-202; test condition A. Frequency change

7、 permitted: 5 ppm. Equivalent resistance change permitted: 10 percent. Thermal shock: Frequency change permitted: 5 ppm. Equivalent resistance change permitted: 10 percent. Aging: Frequency change permitted: 5 ppm. Part or Identifying Number (PIN): For Product Level B, PIN shall be CR134/U or CR134B

8、/U (followed by specified frequency). For Product Level S, PIN shall be CR134S/U (followed by specified frequency, see 1.2 of MIL-PRF-3098. Reference documents. In addition to MIL-PRF-3098, this document references the following: MIL-PRF-202 Copyright Communications - Electronics Command Provided by

9、 IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-3098/113E 3 The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the

10、 Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodians: Prepari

11、ng activity: Army - CR Army - CR Navy - EC Air Force - 99 Agent: DLA - CC DLA - CC Review activities: (Project 5955-2011-004) Air Force - 84 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-