ARMY MIL-I-70698 (2)-1997 IMPROVED LIFTING TARGET ELEVATING MECHANISM 9375512《9375512改良起重目标升降机》.pdf

《ARMY MIL-I-70698 (2)-1997 IMPROVED LIFTING TARGET ELEVATING MECHANISM 9375512《9375512改良起重目标升降机》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-I-70698 (2)-1997 IMPROVED LIFTING TARGET ELEVATING MECHANISM 9375512《9375512改良起重目标升降机》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-1-70678 (2) 9997906 2057505 262 I INCH-POUNDS I MIL-1-70698 (AR) AMENDMENT 2 27 August 1997 SUPERSEDING AMENDMENT 1 27 January 1995 MILITARY SPECIFICATION IMPROVED LIFTING TARGET ELEVATING MECHANISM: 9375512 MIL-1-70698 was Inactivated after 7 January 1997 For New Design; This amendment forms a

2、part of MIL-I-70698(AR), dated 30 December 1988, and is approved for use by the U.S. Army Armament, Research , Development and Engineering Center, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 1.1: Delete in its entirety and substitute the following: “

3、1.1 Scope. This specification covers the Improved Lifting Target Elevating Mechanism (ILTEM), Part No. 9375512.” PAGE 10 4.7.5, Line 3: Delete “4.6” and substitute “4.8.3” PAGE 11 4.8.1: Delete in its entirety and substitute the following: “4.8.1 Equipment. a. Actual or simulated target load can be

4、used providing it equals the maximum weight require- ment per 3.4.6 e distribution is unlimited Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- NIL-1-70698 (2) 9999906 2057506 IT9 MIL-1-70698 (AR) AMENDMENT 2 b. Ohmmeter or indicator lamp circuit co

5、nnected between STI-M and STI-N can be used to determine on and off condition of smoke scorer simulator lamp circuit.“ 4.8.3.1 b: Delete in its entirety and substitute the following: “b. Connect 230 V AC power to J1 on Electrical Box Assembly.“ PAGE 13 * 5.1: Delete in its entirety and substitute th

6、e following: “5.1 General. Packaging shall be level A, B or C as specified in the procurement documentation. PAGE 14 6.1, Line 7: Add “The (ILTEM) is used on the Armor Moving Target Carrier (AMTC) , in the Remote Target System RETS) .“ The margins of this amendment are marked with an astrisk or vert

7、ical lines to indicate where changes (additions, modifica- tions, corrections, deletions) from the previous amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to ev

8、aluate the requirements of this document based on the entire content irrespective of the marginal notation and relationship to the last previous amendment. Custodian: Army-AR Preparing activity: Amy-AR ( Pro j ect 6 92 0-0 168 ) 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-