ARMY MIL-DTL-53126 1 A-2012 POWER DISTRIBUTION ILLUMINATION SYSTEMS ELECTRICAL FEEDER SYSTEM 200 AMPS PHASE (A P) [Superseded ARMY MIL-E-53126 REINST NOTICE 3 ARMY MIL-E-53126 CANC.pdf

《ARMY MIL-DTL-53126 1 A-2012 POWER DISTRIBUTION ILLUMINATION SYSTEMS ELECTRICAL FEEDER SYSTEM 200 AMPS PHASE (A P) [Superseded ARMY MIL-E-53126 REINST NOTICE 3 ARMY MIL-E-53126 CANC.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-53126 1 A-2012 POWER DISTRIBUTION ILLUMINATION SYSTEMS ELECTRICAL FEEDER SYSTEM 200 AMPS PHASE (A P) [Superseded ARMY MIL-E-53126 REINST NOTICE 3 ARMY MIL-E-53126 CANC.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、 AMSC N/A FSC 6150 Distribution Statement A. Approved for public release, distribution is unlimited. INCH-POUND MIL-DTL-53126/1A 16 October 2012 SUPERSEDING MIL-E-53126(ME) 20 April 1992 DETAIL SPECIFICATION SHEET POWER DISTRIBUTION, ILLUMINATION SYSTEMS, ELECTRICAL FEEDER SYSTEM, 200 AMPS/PHASE (A/

2、P) This specification is approved for use within US Army Research Development and Engineering Command, Communications and Electronics Research and Development Center, Product Realization Directorate, Department of the Army and is available for use by all Departments and Agencies of the Department of

3、 Defense. The requirement for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-53126. 1 SCOPE 1.1. Scope. This specification sheet covers the detail requirements for the Power Distribution Illumination Systems Electrical (PDISE), Type I, model: M200. 2. AP

4、PLICABLE DOCUMENTS 2.1. Drawings. The following Government drawings form a part of this specification sheet to the extent specified herein. Unless otherwise specified, the issues are those cited in the solicitation. DRAWING# NOMENCLATURE DRAWING # NOMENCLATURE CECOM & PM-MEP Drawings - Cage Code: 97

5、403 and 30554 13229E6350 Feeder System, Electrical, Three Phase, 200 Amperes/Phase 13229E6308 Connector Assembly 200 AMP/PH Input Plug (Copies of drawings required by contractors in connection with specific acquisition functions should be obtained from: PROJECT MANAGER-MOBILE ELECTRIC POWER, 5850 De

6、lafield Road, Bldg 324 FT BELVOIR VA 22060-5809.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 2 OF 7 3. REQUIREMENTS 3.1. Requirements. The M200 PDISE shall be a self-contained, free-standing, man portable unit. The system s

7、hall be capable of distributing 200 A/P of electricity to all its outputs simultaneously, as specified herein. Type I 200 A/P feeder system 3.2. Design. The M200 PDISE shall be IAW TA13229E6350 and as specified herein. 3.2.1. Dimensions. The M200 PDISE shall not be greater than the following dimensi

8、ons: Length (Inches) Width (Inches) Height (Inches) 36.00 24.00 22.00 3.2.2. Weight. The M200 PDISE shall weigh no more than 147 pounds. 3.2.3. M200 PDISE Inputs. The M200 PDISE shall have a single 3-phase input capable of handling 200 A/P. Provided by IHSNot for ResaleNo reproduction or networking

9、permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 3 OF 7 3.2.3.1. Input circuit interrupter. The input circuit for the M200 PDISE shall be protected from overload by a properly sized circuit breaker. The circuit breaker shall act as a switch to activate/deactivate the circuit. 3.2.3.2. In

10、put Connector. The M200 PDISE shall have a 200 ampere, three phase, male, input receptacle IAW 13229E6308. 3.2.4. M200 PDISE Outputs The M200 PDISE shall have the following output circuits and connectors: Quantity Output Rating Ouput Connector P/N* 3 100 Amp, 3 phase M90556C44413P 4 60 Amp, 3 phase

11、M90556C32413P 1 20 Amp, 1 phase M3406D16-10S *Note: See 3.3.16.1 in MIL-DTL-53126. 3.2.4.1. Output circuit interrupters. Each output circuit shall be protected by a properly sized circuit breaker. The circuit breaker shall act as a switch to activate/deactivate the circuit. 3.2.5. Type I accessories

12、. The unit shall be provided with the following accessories: Quantity Description Reference* 1 Input interface cable assembly, rated at 200 amperes 3.3.18.1 4 200 A/P cable assemblies 3.3.18.2 8 Double-strap carriers 3.3.19.3 *Note: See requirement paragraph referenced MIL-DTL-53126. Provided by IHS

13、Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 4 OF 7 CARRYINGSTRAPSCINCHINGSTRAPSCARRYINGSTRAPSMARKING TAG(WHITE)JOININGSTRAP1.50 STK10.0027.754.75 3x 1.50JOININGSTRAP3.2.6. Wiring diagram. The circuits shall be configured as specified in th

14、e following wiring diagram: Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 5 OF 7 J11OUTPUT100 A 3 PHASE60 A 3 PHASEOUTPUTJ9J9C4CB9CJ9B4CB9BJ9A4CB9ACBA60 A 3 PHASEOUTPUTJ7200 A 3 PHASEINPUTJ1CB9A CB10AJ4J8ABCJ10OUTPUT60 A 3 PHA

15、SEOUTPUT60 A 3 PHASEOUTPUT100 A 3 PHASEJ10A4CB10AJ10B4CB10BJ10C4CB10CNGJ9N4NEUTJ9G6GNDCB9BCB9CGNJ10G6GNDJ10N4NEUTCB10BCB10CBBNEUT L1BB BBL2BBL3 GNDBBCB8CCB8BJ8N4NEUTJ8G6GNDNGCB7CCB7BJ7G6GNDJ7N4NEUTGNJ8C4CB8CJ8B4CB8BJ8A4CB8ACBACB8ACB7AABCJ7A4CB7AJ7B4CB7BJ7C4CB7CJ1C4/OCB1CJ1B4/OCB1BJ1A4/OCB1ACBACB1AAB

16、CJ4A1CB4AJ4B1CB4BJ4C1CB4CNG1J1N4/ONEUTJ1G4GNDCB1BCB1CNJ4N1NEUTG2G3G4 J1G4GNDJ1G4GNDJ1G4GNDG4G3G2G1J4G6GNDJ4G6GNDJ4G6GNDJ4G6GNDDS1DS3J11G6GNDJ11G6GNDJ11G6GNDG4G3G2J11G6GNDJ11N1NEUTG1NABCJ11A1CB11AJ11B1CB11BJ11C1CB11C CB11CCB11BCB11ACB5ACB5BCB5CJ5C1CB5CJ5B1CB5BJ5A1CB5ACBANG1J5N1NEUTJ5G6GNDG2G3G4 J5G6G

17、NDJ5G6GNDJ5G6GND100 A 3 PHASEOUTPUTJ5CB6 J6A12CB6 AJ6B12NEUTJ6C12GNDBCJ6OUTPUT20 A 1 PHASECB4ACB4BCB4CCB11A1L1CB11B1L2CB11C1L3CB9A4L1CB7A4L1CB7B4L2CB7C4L3CB5A1L1CB5B1L2CB5C1L3CB1A4/OL1CB1B4/OL2CB1C4/OL3CB9B4L2CB9C4L3DS2CB1BDS3CB1C DS3NBBDS2NBBDS1NBBCB10A4L1CB10B4L2CB10C4L3CB8A4L1CB8B4L2CB8C4L3CB612L

18、2CB4A1L1CB4B1L2CB4C1L3DS1CB1ADS2CHASSIS GROUNDTOP COVERCIRCUIT BREAKERMOUNTING PANELLIGHT BRACKETProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 6 OF 7 3.2.7. This specification sheet had no superseding “base”. The original publ

19、ication of this specification was a performance specification that was used in-house by CR4. Since this specification is now a detailed military specification, this specification sheet is deemed necessary to capture the unique characteristics desired in the end item. 3.2.8. Changes from previous iss

20、ues: Marginal notations are not used in this revision to identify changes with respect to the previous issue because this detail specification sheet although a part of the base document, was not published because it was a document with limited circulation and coordination that was used essentially b

21、y CR4. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-53126/1A PAGE 7 OF 7 Concluding Material Custodian: Preparing Activity: Army - CR4 Army - CR4 (Project 6150-2012-010) Review Activities: DLA GS Note: The activities listed above were inte

22、rested in this document as of the date of this document. Since organization and responsibilities can change, you should verify the currency of the information above using ASSIST Online https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-