ARMY MIL-DTL-11484 353-2012 LAPEL BUTTON STRATEGIC MISSION DEFENSE INTELLIGENCE AGENCY.pdf

《ARMY MIL-DTL-11484 353-2012 LAPEL BUTTON STRATEGIC MISSION DEFENSE INTELLIGENCE AGENCY.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-11484 353-2012 LAPEL BUTTON STRATEGIC MISSION DEFENSE INTELLIGENCE AGENCY.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A Page 1 of 2 FSC 8455 INCH - POUND MIL-DTL-11484/353 12 December 2012 DETAIL SPECIFICATION SHEET LAPEL BUTTON, STRATEGIC MISSION, DEFENSE INTELLIGENCE AGENCY This specification is approved for use by all Departments and Agencies of the Department of Defense The requirements for acquiring the

2、 product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Red Brass 85/15 (UNS Alloy No. C-230) DIMENSIONS: HEIGHT: 11/16 inch WIDTH: 11/16 inch THICKNESS (along bottom scroll): 0.075 inch 0.010 inch FINISH: 24K Gold Plated, Matte Finish, Po

3、lished Highlights and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 8. All lettering and discs between phrases shall be epoxied BLUE #20 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-11484/353 Page 2 of 2 EPOXY: Epox

4、y shall be applied where indicated, and shall match TIOH Hard Enamel Color Chip Number listed: TIOH HARD ENAMEL COLOR CHIP NUMBER LOCATION(S) Blue #20 All letters and the discs between phrases ATTACHING DEVICE: Attaching device shall be prong with pick and wing type clutch. The prong shall be center

5、ed on the reverse side and either fused or soldered to the lapel button. ITEM CASE: Lapel buttons to be presented in a case shall be mounted and centered on a polyethylene pad and placed in a rigid hinged plastic box having a transparent lid and opaque bottom section. The box shall have two plastic

6、hinges and catches and shall be approximately 1-1/8 inches square and 5/8 inch in overall depth. The pad shall be of sufficient depth to restrict movement of the lapel button. NOTES: 1. The manufacturer may deviate from MIL-DTL-11484 by applying a nickel underplating prior to applying the requisite

7、24K gold plating. 2. Hard cloisonn enamel may be used in lieu of epoxy enamel. If hard cloisonn enamel is used, the requisite base material for this item is Gilding Metal 95/5 (UNS Alloy No.C-210). Custodian: Preparing activity: Army - IH Army - IH Civil Agency: (Project No. 8455-2013-071) DIA - DI

8、NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-