ARMY MIL-DTL-11484 350-2013 LAPEL BUTTON EXEMPLARY LEADERSHIP AWARD DIVERSITY EQUAL EMPLOYMENT OPPORTUNITY DIRECTOR OF NATIONAL INTELLIGENCE.pdf

《ARMY MIL-DTL-11484 350-2013 LAPEL BUTTON EXEMPLARY LEADERSHIP AWARD DIVERSITY EQUAL EMPLOYMENT OPPORTUNITY DIRECTOR OF NATIONAL INTELLIGENCE.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-11484 350-2013 LAPEL BUTTON EXEMPLARY LEADERSHIP AWARD DIVERSITY EQUAL EMPLOYMENT OPPORTUNITY DIRECTOR OF NATIONAL INTELLIGENCE.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 AMSC N/A Page 1 of 2 FSC 8455 INCH - POUND MIL-DTL-11484/350 1 October 2013 DETAIL SPECIFICATION SHEET LAPEL BUTTON, EXEMPLARY LEADERSHIP AWARD, DIVERSITY, EQUAL EMPLOYMENT OPPORTUNITY, DIRECTOR OF NATIONAL INTELLIGENCE This specification is approved for use by all Departments and Agencies of the D

2、epartment of Defense The requirements for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Red Brass 85/15 (UNS Alloy No. C-230) DIMENSIONS: DIAMETER: 11/16 inch (REF) THICKNESS (at rim): 0.070 inch 0.010 inch FINISH: N

3、ICKEL: The torch and dike lines outlining the flames shall be Nickel Plated, Matte Finish, Polished Highlights and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 18 GOLD: All other areas shall be 24K Gold Plated, Matte Finish, Polished Highlights and shall match TIOH Metal Fin

4、ish Chip Number 8. BLUE #20 RED #1 WHITE #28 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-11484/350 Page 2 of 2 EPOXY: Epoxy resin shall be applied to the lapel button as indicated above, and shall match TIOH Hard Enamel Color Chip Numbers

5、 listed below. Hard cloisonn enamel may be used in lieu of epoxy. If hard cloisonn enamel is used, the required base material shall be Gilding Metal 95/5 (UNS Alloy C-210): TIOH HARD ENAMEL COLOR CHIP NUMBER LOCATIONS Red #1 Flames of torch Blue #20 (1) Inner Designation Band (2) Center Disc White #

6、28 Outer Designation Band ATTACHING DEVICE: The attaching device shall be a prong with pick and wing type clutch. The prong shall be centered on the reverse side and either fused or hard soldered to the lapel button. NOTES: 1. The term (REF) refers to measurements taken from the Government furnished

7、 hub or die. 2. The manufacturer may deviate from MIL-DTL-11484 by using nickel underplating prior to plating with 24K gold. 3. This item is not authorized for commercial sale, and may be produced only under Government contract and at the request of the Office of the Director of National Intelligenc

8、e. Custodian: Preparing activity: Army - IH Army - IH Civil agency: (Project No. 8455-2013-191) ODNI - NIAP NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-