ARMY MIL-DTL-11484 25 F-2008 LAPEL BUTTON PRESIDENTIAL UNIT CITATION ARMY AND AIR FORCE《陆军和空军总统集体嘉奖领扣》.pdf

《ARMY MIL-DTL-11484 25 F-2008 LAPEL BUTTON PRESIDENTIAL UNIT CITATION ARMY AND AIR FORCE《陆军和空军总统集体嘉奖领扣》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-11484 25 F-2008 LAPEL BUTTON PRESIDENTIAL UNIT CITATION ARMY AND AIR FORCE《陆军和空军总统集体嘉奖领扣》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、INCH-POUND MIL-DTL-11484/25F 29 August 2008 SUPERSEDING MIL-DTL-11484/25E 27 September 1996 DETAIL SPECIFICATION SHEET LAPEL BUTTON, PRESIDENTIAL UNIT CITATION, ARMY AND AIR FORCE This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements fo

2、r acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Gilding Medal DIMENSIONS: HEIGHT (overall): 9/64 inch (REF) WIDTH (overall): 21/32 inch (REF) THICKNESS (at edge): 0.065 inch + 0.005 inch FINISH: Hard Enameled, Gold P

3、lated, Mirror-like Polished and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 6. NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. AMSC N/A Page 1 of 2 FSC 8455 Provided by IHSNot for ResaleNo reproduction or networking permit

4、ted without license from IHS-,-,-MIL-DTL-11484/25F Page 2 of 2 2. Enameled/epoxied areas shall be as shown. Epoxy resin (stoning epoxy) may be at the option of the manufacturer. When hard enamel is used, the material requirement shall be gilding metal. When epoxy is used, the material requirement sh

5、all be either red brass or gilding material. The enamel color shall be as indicated and conform to the TIOH Chip Number 18. 3. Attaching device shall be prong with pick and wing type clutch. The prong shall be centered on the reverse side and fused or soldered to the lapel button. CHANGES FROM PREVI

6、OUS ISSUE: The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are caution

7、ed to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Army - IH Army - IH Air Force 11 (Project No. 8455-2008-166) Review activities: Air Force - 99 DLA - CT NOTE

8、: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-