ARMY MIL-C-55693 (3)-1976 COUPLERS ANTENNA CU-942( ) AR CU-1894( ) AR AND ANTENNA AS-1703( ) AR《CU-942() AR CU-1894() AR天线耦合器及AS-1703() AR天线》.pdf
《ARMY MIL-C-55693 (3)-1976 COUPLERS ANTENNA CU-942( ) AR CU-1894( ) AR AND ANTENNA AS-1703( ) AR《CU-942() AR CU-1894() AR天线耦合器及AS-1703() AR天线》.pdf》由会员分享,可在线阅读,更多相关《ARMY MIL-C-55693 (3)-1976 COUPLERS ANTENNA CU-942( ) AR CU-1894( ) AR AND ANTENNA AS-1703( ) AR《CU-942() AR CU-1894() AR天线耦合器及AS-1703() AR天线》.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、COUPLERS, *. , MIL-C-55693 (EL) .I “LIMENT 3. I *. SUPERSEDING AMENDMENT 2 2 AUGUST 1973 27 January i976 MILITARY SPECIFICATION * . ., ANTENNA CU-942( )/AR, CU-1894( )/AR AND ANTENNA AS-1703( )/AR -I - ._ : . * . =: .- . - . This amendment forms a part of Military Specification ML-C-55693(EL) ,. dat
2、ed 3 February 1970, and is approved for use by all departments and . agencies of the Department of Defense. Delete “Preproduction“ and replace with “First Article“ wherever mentioned in the Specification. Page 1 . 1.1: Change “75.95“ to “80.00“ 2.1: Delete “MIL-T-5422 Testing, Environmental, Aircraf
3、t Electronic . Equipment“. Page 2 2.1 (Last Para.) : 3.1: Change “75.95“ to 80.00“. Delete “supplier“ and substitute “suppliers“. Page 3 3.2.2: 0.75 lbs.“ Delete “(less .). . . 14 oz.“ and replace with “shall not exceed Page 4 3.7: Delete in its entirety. FSC 5821 Copyright Communications - Electron
4、ics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,- MIL-C-55693 (3) 58 9999906 0169089 3 m ,- p MIL-C-55693(EL) _* AMENDMENT 3 . Page 5 3.11.1: Delete in its entirety and substitute: “3.11.1 Temperature-Altitude (See
5、4.8.1). - The equipment shall be E, subjected to and meet the following temperature-altitude combination requirements: a. Operating frqm -650F to 131F b. Operating with duty cycle: 30 minutes ON, 15 minutes OFF, from 131F to 160F c. range of -80F to 185F.“ Equipment shall be capable of storage over
6、the non-operating Page 6 3.11.5: tion MIL-T-5422, Curve IV“ and substitute “The equipment(s) shall meet the vibrationrequirement of Crve IV, of MIL-E-5400 for aircraft and heli- copters“. Delete “The equipment shall meet the vibration tests of Specifica- 3.12.2 : Change “75.95“ to “80.00“. Page 7 3.
7、13.1: Change “75.95“ to “80.00“. 3.12.4: Add the following: isotropic gain, of the Antenna Coupler(s) as used with the AS-1703 whip Antenna shall be as shown on Figure 1.“ 3.14: Delete in its entirety. “3.13.4 Gain (See 4.10.4). - The minimum perfornance, reference 3.18: Delete “Alignment (parts) 3.
8、7“ - Page 2 of 7 Pages i .- I- f l-; :i i Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-55693 (EL) . AMENDmNT3 . Page 8 4.1: Delete in its entirety and substitute: 114. 1
9、Responsibility or inspection. - Unless otherwise specf ied in the contract or purchase Order, the supplier is responsible for the per- formance of all inspection requirements as specified herein. Except as otherwise specified in the contract or order, the supplier may use his ownor any other facilit
10、ies suitable for the performance of the inspec- tion requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform ciny of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and servic
11、es conform to prescribed requirements.“ Page 9 4.5: Add at the end of paragraph - “Each equipment of each lot of equip- ment shall be subjected to the Operational inspection .(4.11) prior to in- spection. inspection shall be classified as a defect and recorded as such.“ 4.5.1, TABLE I Group A Inspec
12、tion, under column headed Electrical: Delete row headed - “Power Capability 3.13.3, 4.10.1 and substitute “Power Capa- bility (rf) 3.13.3, 4.10.3“. Failure to meet any requirements as a result of the operational Page 10 4.4.5: Delete “4.4.5“ and.substitute “4.54“. Inspection, under column headed Sub
13、group I: Delete “Temperature“ and substitute “Temperature (only)“, and under Couplers, delete row “Temperature 3.11.1, 4.8.1, Altitude 3.11.2, 4.8.2“, and sub- stitute “Temperature-Altitude 3.11.1, 4.8.1“. In TABLE III - Group C Antenna AS-1703( )/AR: .4.5.3, TABLE II Group B Inspection, following i
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ARMYMILC5569331976COUPLERSANTENNACU942ARCU1894ARANDANTENNAAS1703ARCU942ARCU1894AR 天线 耦合器 AS1703AR PDF

链接地址:http://www.mydoc123.com/p-441884.html