ARMY A-A-59784-2005 E-GLASS CLOTH REINFORCEMENT《无碱玻璃布增强》.pdf

《ARMY A-A-59784-2005 E-GLASS CLOTH REINFORCEMENT《无碱玻璃布增强》.pdf》由会员分享，可在线阅读，更多相关《ARMY A-A-59784-2005 E-GLASS CLOTH REINFORCEMENT《无碱玻璃布增强》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 INCH-POUND A-A-59784 9 DECEMBER 2005 COMMERCIAL ITEM DESCRIPTION E-GLASS CLOTH REINFORCEMENT The General Services Administration has authorized the use of this Commercial Item Description by all federal agencies. 1. SCOPE. This commercial item description (CID) covers E-Glass cloth used as the rein

2、forcement media in the manufacture of advanced composite materials using infusion processes or hand lay-up. 2. SALIENT CHARACTERISTICS. 2.1 General. E-Glass Woven Roving Fabric is one of the major fiber materials used in the composite industry as the reinforcing media for low pressure, high performa

3、nce resin system manufacturing processes such as Resin Transfer Molding (RTM), Vacuum Assisted Resin Transfer Molding (VARTM), Seemans Composite Resin Injection Molding Process (SCRIMPTM), prepreg hand lay-up, and/or other infusion processes. Usually, fibers consist of thousands of filaments, each f

4、ilament having a diameter between 5 and 15 microns, allowing them to be producible using textile machines. The filaments are obtained by pulling the molten glass (silicon + sodium carbonate and calcium carbonate at a temperature greater than 1000C) through the small orifice of a plate made of platin

5、um alloy. The fibers are normally treated afterwards with sizing and coupling agents. These reduce the effects of fiber-fibre abrasion which can significantly degrade the mechanical strength of the individual fibers. Other treatments may also be used to promote wetting and adherence of the matrix ma

6、terial to the fiber material. 2.2 Performance. Specifications are as follows: a. Woven Roving Fabric Cloth shall be free from any chemical splices that might cause laminate defects. b. No weave distortion or missed picks in the weave pattern c. Fabric shall be compatible with Vinyl ester and Epoxy R

7、esin system d. Nominal Weight per Square Yard: 24.0 24.25 Oz. e. Nominal Roll Width: Minimum dimension of the fabric cut ply, which will depend on the specific part to be made. Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any other data which may improve this

8、 document should be sent by letter to: US Army Tank-automotive and Armaments Command, ATTN: AMSRD-TAR-E/268, 6501 E. 11 Mile Road Warren, MI 48397-5000. AMSC N/A FSC 8305 Distribution Statement A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or

9、 networking permitted without license from IHS-,-,-A-A-59784 2 f. Construction: 1. Warp 5.0/inch 2. Percent of weight 55 % 3. Fill 4.0/inch 4. Percent of Weight 45 % 3. REGULATORY REQUIREMENT. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accor

10、dance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 4. PRODUCT CONFORMANCE. 4.1 Product Conformance. The products provided shall meet the salient characteristics of this Commercial Item Description, conform to the producers own drawings, specifications, standards and quality ass

11、urance practices and be the same product offered for sale in the commercial marketplace. The government reserves the right to require proof of such conformance. 4.2 Market Acceptability. The product shall be a standard commercial item or a modified commercial item to minimize design and engineering

12、risk. A commercial item is required to ensure serviceability, reliability and quality of materials. Bid samples may be required for the Epoxy Resin System to ensure product quality. 5. PACKAGING. Preservation, packaging, packing and marking shall be specified in the contract or order. 6. NOTES 6.1 S

13、ource of Documents. 6.1.1 Material Safety Data Sheet for Woven Roving Cloth may be obtained from Saint-Gobain Vetrotex America, 3410 Briarfield Blvd, Maumee, OH 43537 or at their website http:/. 6.1.2 The Code of Federal Regulations (CFR) may be obtained from the U.S. Government Printing Office, 732

14、 Capitol Street NW, Washington, DC 20401 or at their website http:/www.gpoaccess.gov/cfr/index.html 6.2 Ordering Data. The contract or order should specify the following: a. CID document Number b. Product conformance provisions c. Packaging requirements d. Width of roll Provided by IHSNot for Resale

15、No reproduction or networking permitted without license from IHS-,-,-A-A-59784 3 6.3 Products known to meet this CID. a. Part Number 324-2407 Woven Roving E-glass fiber cloth Mahogany Company of Mays Landing 5450 Atlantic Avenue Mays Landing, NJ 08330 b. 324-1507 Woven Roving E-glass fiber cloth Sai

16、nt-Gobain Vetrotex America Inc. 750 East Swedesford Road Valley Forge, PA 19482-0101 6.4 Key words. Woven Roving E-glass Fiber reinforced composites MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FSS Custodians Army AT Preparing Activity: Navy - AS Army AT Air Force 11 DLA - CT (Project: 8305-2006-006) Review Activities Army GL, GL1, IH Navy CG Air Force 03 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-