ARMY A-A-52128-1993 SHELVING STORAGE STATIONARY AND MOBILE FOOD STORAGE《食品储藏固定和移动储藏架》.pdf

《ARMY A-A-52128-1993 SHELVING STORAGE STATIONARY AND MOBILE FOOD STORAGE《食品储藏固定和移动储藏架》.pdf》由会员分享，可在线阅读，更多相关《ARMY A-A-52128-1993 SHELVING STORAGE STATIONARY AND MOBILE FOOD STORAGE《食品储藏固定和移动储藏架》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-52328 m 9999974 0344882 523 m A-A-52128 June 16, 1993 SHELVING, SID=, S“ATION?UZY AND KIBILE, FKD SID= The General Services Administration has authorized the use of this camien=ial item description in preference to MIL-S-40144. 1.1 Classification. This camnercial item description covers the foll

2、owing types, styles and sizes, exclusive of casters, of stationary and mbile food storage shelves: Type I - Stationary Style I - Wire Construction Size 2 - Type II - Mobile 18“ to 20“ deep by 48“ wide by 58“ to 66“ high Style I - Wire Construction Size 2 - 18“ to 20“ deep by 48“ wide by 58“ to 66“ h

3、igh Size 4 - 24“ deep by 48“ wide by 58“ to 66“ high Size 6 - 21“ deep by 30“ wide by 72“ to 75“ high Size 7 - 18“ or 21“ deep by 36“ wide by 72“ to 75“ high Size 8 - 18“ or 21“ deep by 48“ wide by 72“ to 75“ high Beneficial comnents (recammdations, additions, deletions) and any pertinent data which

4、 may be used in improving this document should be addressed to: Center, Natick, MA 01760-5018, by using the Standardi zation Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. U.S. Army Natick Research, Developnent, and Engineering AMSC N/A FSC 7125 DmmI

5、m A. Fgproved for Nic release; distrmtion is mimiteci. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52128 9999974 0144883 468 A-A-52 12 8 Size 9 - 24“ deep by 30“ wide by 72“ to 75“ high Size 10 - 24“ deep by 36“ wide by 72“ to 75“ high Size 1

6、1 - 24“ deep by 42“ wide by 72“ to 75“ high Size 12 - 24“ deep by 48“ wide by 72“ to 75“ high Style II - Slotted sheet metal or louvered shelves Size 2 - 18“ to 20“ deep by 48“ wide by 58“ to 66“ high Size 3 - 24“ deep by 36“ wide by 58“ to 66“ high Size 4 - 24“ deep by 48“ wide by 58“ to 66“ high 1

7、.2 CID based part identification nimiber (PIN). A dommnt based PIN to identify types, sizes and styles of it- is included in section 5. This identification numbering procedure is for Government pupose and does not constitute a requirement for the contractor (see 5.3). 2. SALIENT ciuwcmusTIcs 2.1 Des

8、icm and construction. shall not require fastening to the floor, wall, ceiling or adjacent units. The shelving shall be open type construction and be capable of being assanbled and disassembled with the use of hand tools. Shelves shall be capable of being adjusted vertically the entire height of the

9、frame. Sway braces are allowed if normally provided on the manufacturers product sold carmemially. All shelving shall be self supporting and Size 2 through 4 shelving shall be supplied with four adjustable shelves. Sizes 6 through 12 shelving shall be supplied with five adjustable shelves. Type I sh

10、elving shall be fabricated fran carbon steel with nickle-chraniun plating, zinc plating, clear coating, baked-on over nickle-chromium or zinc plating, or baked on plastic finish over zinc plating. meling devices shall be provided at each bottan comer. Type II shelving shall be fabricated fran stainl

11、ess steel with a No. 3 or better finish and shall have casters or a dolly. minirnrm of 5“ in diameter and two of the casters shall be equipped with brakes. Dollies, if furnished, shall be fabricated fran stainless steel. Each bottan comer of the type II shelving base frame or dolly shall be equipped

12、 with a bumper to prevent uprights fran contacting a vertical wall. The bumper shall be fabricated fran a non-marking rubber or rubber-like material. Caster wheels shall be a 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52128 9999974 0344884

13、 3T4 A-A-52 128 Style I shelving shall have wire shelves. Uprights shall be wire, tubular or angular construction. Style II shelving shall have tubular uprights and slotted or louvered sheet metal shelves. Erection instructions shall be furnished with each shelving unit. 2.2 Dimensions. Shelving dim

14、ensions shall be as specified in table I. The height shall be exclusive of casters or dollies. TABLE I. Overall dimensions (inches) Size Depth Width _+ 1-1/4 Height A/ 2 18 to 20 48 58-66 3 24 f 1-1/4 36 58-66 4 24 f 1-1/4 48 58-66 6 21 f 1/2 30 72-75 7 21 f 1/2 36 72-75 8 21 f 1/2 48 72-75 9 24 _+

15、1/2 30 72-75 10 24 f 1/2 36 72-75 11 24 f 1/2 42 72-75 12 24 f 1/2 48 72-75 O - i/ Maximum height for shelving equipped with casters or dolly shall be 80“. 2.3 Standards of cam liante. requirements of NSF International Standard No. 2 for Food Service Equipent. The shelving shall canply with applicab

16、le 2.4 Identification markinu (“Goverment unique“) rew irement. Fach shelving unit shall be pmanently and legibly marked with the manufacturers identification -king. Use of “stick on“ or mvable labels is prohibited. 2.5 Reau latorv reau irementS. Federal Acquisition Regulations, the Govennrrents pol

17、icy is to acquire iteris canposed of the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of canpetition without adversely affecting performance requirements or exposing suppliers enployees to uridue hazards from the recovered materials. The off

18、eror/contractor is encouraged to use recovered materials in accordance with Public aw 94-580 to the maximum extent practicable. The term “recovered materials“ mans materials which have been collected or recwered fran solid waste and reprocessed to becare a source of raw materials as opposed to virgi

19、n raw mterials. used or rebuilt products are allING 4.1 Packaqinq and packinq. exprt as specified (see 5.2). Packaging and packing shall be carniercial or 4.2 packaged and packed in accordance with ASTM D 3951. Cannercial packauinCr - and packinq. The shelving shall be preserved, 4.3 EkPO rt packaqi

20、na and wckinq. 4.3.1 E%po rt packaqinq. Each shelving unit shall be canpletely disassembled and unit packed in a snug-fitting weather-resistant fibrbard box confonning to PPP-B-636. contents and prevent age during shipnent. Cushioning shall be used as necessary to imnobilize the 4 Provided by IHSNot

21、 for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52128 m 9999974 O1i4488b 177 m A-A-52128 4.3.2 Exm rt wckinq. Three units of shelving, packaged as specified, shall be packed in a crate conforming to type II, style A of MIL-C-52950. 4.4 Markinu (carmercial and emrt

22、l. Marking shall be in accordance with MIL-SID-129. 5. ms 5.1 Intended use. for general storage of packaged and canned goods. in refrigerated areas of restricted dimensions. Shelving covered by this camremial item description are Type II shelving is used 5.2 rderinu data. Acquisition documents shoul

23、d specify the following: a. Title, number, and date of this document. b. Type, style and size of shelving required (see 1.1). c. ?pe of packaging and packing required (see 4.1) . 5.3 CID based part identification nwber. The following part identification nimibering procedure is for Govenmient -ses an

24、d does not constitute a requirement for this docunient: A-A-52120 - I - 1 - 2 I CID nimiber. Do not include the revision letter or activity symbol. indicates a camnercial item description 5.4 Supersession data. The shelving was previously available fran Military Specification MIL-S-40144. 5.5 Source

25、s of documents. 5.5.1 Sources of nonuovernment association documents. NSF International Standard No. 2 is available fran: NSF International 3475 Plymouth Road P.O. Box 130140 Ann Arbor, MI 48113-0140 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

26、A-A-52128 m 9999974 OLY4887 003 m A-A-52 120 ASIM D 3951 - Standard Practice for Camnarcial Packaging, is available frrm: The American Society for Testing and Materials (m) 1916 Race Street Philadelphia, PA 19103-1187 5.5.2 Sources of sovemwntal documents. Copies of Military and Federal docunients a

27、re available fmm: Standardi zation Documnts order Desk Building 4D 700 Robbins Avenue Philadelphia, PA 19111-5094 MILITARY ISTS: Custodians Army-= Air Force - 99 Review Activity User Activities CML AGENCY CIXRDINATING XIMTIES: GSA - Fss VA-13plls PREPARING ACTMTY: Army-= Project 7125-0135 .I Navy - Mc, CG, YD 6 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-