AHRI GUIDELINE Q-2016 Content Recovery & Proper Recycling of Refrigerant Cylinders.pdf

《AHRI GUIDELINE Q-2016 Content Recovery & Proper Recycling of Refrigerant Cylinders.pdf》由会员分享，可在线阅读，更多相关《AHRI GUIDELINE Q-2016 Content Recovery & Proper Recycling of Refrigerant Cylinders.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 AHRI Guideline Q 2016 Guideline for Content Recovery & Proper Recycling of Refrigerant Cylinders Price $10.00 (M) $20.00 (NM) Copyright 2016, by Air-Conditioning, Heating, and Refrigeration Institute Printed in U.S.A. Registered United States Patent and Trademark Office IMPORTANT SAFETY RECOMMENDAT

2、IONS It is strongly recommended that the product be designed, constructed, assembled and installed in accordance with nationally recognized safety requirements appropriate for products covered by this guideline. AHRI, as a manufacturers trade association, uses its best efforts to develop guidelines,

3、 employing state-of-the-art and accepted industry practices. However, AHRI does not certify or guarantee safety of any products, components or systems designed, tested, rated, installed or operated in accordance with these guidelines or that any tests conducted under its guidelines will be non-hazar

4、dous or free from risk. Note: This guideline supersedes AHRI Guideline Q-2010. TABLE OF CONTENTS SECTION PAGE Section 1. Purpose 1 Section 2. Scope . 1 Section 3. Definitions . 1 Section 4. Responsibilities . 2 Section 5. Procedure 2 FIGURES Figure 1. Placement of Screwdriver for Piercing . 2 Figure

5、 2. Pierce Rupture Disc . 3 Figure 3. Open Rupture Disc 3 Figure 4. Placement of Non-sparking Pick for Piercing . 3 Figure 5. Pierce Side of Tank . 4 Figure 6. Label Pierced Hole 4 APPENDICES Appendix A. References Normative . 5 Appendix B. References Informative 5 AHRI GUIDELINE Q-2016 1 CONTENT RE

6、COVERY AND PROPER RECYCLING OF REFRIGERANT CYLINDERS Section 1. Purpose 1.1 Purpose. For practical, safety and environmental reasons, there is a need for content recovery and proper recycling of refrigerant cylinders. This document is a guideline for content recovery and recycling of cylinders at th

7、e end of their useful service life. This document is not intended to be an exhaustive listing of all good practices or requirements. Applicable federal, state and local requirements should be reviewed. 1.1.1 Intent. This guideline is intended for the guidance of the industry, including manufacturers

8、, engineers, installers, contractors, users, refrigerant reclaimers and metal recyclers 1.1.2 Review and Amendment. This guideline is subject to review and amendment as technology advances. Section 2. Scope 2.1 Scope. This guideline is applicable to all U.S Department of Transportation (DOT) non-ref

9、illable and refillable fluorocarbon refrigerant cylinders, as defined in Section 3, having water capacity greater than two pounds used to transport refrigerants sold in the United States. 2.2 Exclusions. This guideline does not apply to drums used to ship refrigerants. Section 3. Definitions All ter

10、ms in this document will follow the standard industry definitions in the ASHRAE Terminology website (https:/www.ashrae.org/resources-publications/free-resources/ashrae-terminology) unless otherwise defined in this section. 3.1 DOT-39 Non-refillable Cylinder. A single-use container produced in accord

11、ance with Title 49, Code of Federal Regulations, Section 178.65. 3.2 DOT Refillable Cylinder. A refillable container produced in accordance with the Title 49, Code of Federal Regulations, Section 178.36 (DOT 3A), 178.37 (DOT 3AA), 178.51 (DOT 4BA) or 178.61 (DOT 4BW) or as specified in an applicable

12、 special permit authorization as provided by the cylinder manufacturer. 3.3 Empty State. 3.3.1 Non-refillable Cylinder. A cylinder whose contents have been evacuated to a vacuum of 15 in Hg, relative to standard atmospheric pressure of 29.9 in Hg. 3.3.2 Refillable Cylinder. A cylinder whose contents

13、 have been recovered to an internal pressure of 0 psig or less with the intent to return it to the owner for proper handling. 3.4 End User. The individual or entity that renders the cylinder empty as defined in Section 3.3. 3.5 Metal Recycler. A business or organization that processes or recycles in

14、dustrial consumed scrapped material in a sound, environmentally responsible manner. 3.6 Recover. To remove refrigerant from a cylinder at the end of its useful service life and store it in a properly pressure rated recovery cylinder. 3.7 Should. “Should“ is used to indicate provisions which are not

15、mandatory but which are desirable as good practice. 3.8 Special Permit Cylinder. A cylinder that has been authorized by the DOT to be manufactured outside the scope of existing DOT regulations but in accordance with the requirements specified by DOT in a special permit. The requirements in AHRI GUID

16、ELINE Q-2016 2 the special permit may include design, composition, manufacture, testing, marking, and transportation criteria as well as special provisions. Section 4. Responsibilities 4.1 Responsibilities. It is the responsibility of the End User to verify that any residual refrigerant contents are

17、 recovered from the cylinder while the cylinder is still under the control of the End User. Section 5. Procedure 5.1 Labeling Recommendations. 5.1.1 Recommended Label for DOT-39 Non-refillable Cylinder. “Do not vent residual pressure to the atmosphere. Recover residual contents using proper recovery

18、 equipment, hoses and gauges to a vacuum of 15 in Hg. Observe all precautions printed on the cylinder labels. After recovery, close valve and return for proper recycling or open valve and pierce according to AHRI Guideline Q. Do not reuse. Cylinder should be returned for proper metal recycling.” 5.1

19、.2 Recommended Label for DOT Refillable Cylinder. “Do not vent residual pressure to the atmosphere. Observe all precautions printed on the cylinder labels. Close valves tightly. Promptly return to supplier.” 5.2 Residual Content Recovery Procedures. Disposition of refrigerants must be in compliance

20、with all applicable federal, state and local regulations. 5.2.1 Valves should remain closed at the onset of the refrigerant recovery process. 5.2.1.1 Recover refrigerant from cylinder into an appropriate pressure-rated recovery cylinder to Empty State as listed in Section 3.3. 5.2.1.2 For non-refill

21、able cylinders only, open the valve on the cylinder. Verify cylinder is empty. 5.2.2 Important: Do not mix refrigerants that have different ASHRAE numbers into the same recovery container. 5.3 Cylinder Recycling Recommendations for Non-flammable Refrigerant. 5.3.1 DOT-39 Non-refillable Cylinder. Do

22、not reuse cylinders. Cylinder must be emptied of their contents as described in Section 5.2.1. After emptied of their contents, open valve. Cylinders may be rendered to a recyclable condition by the following method. WARNING: Failure to follow these instructions for safe disposal of the non-refillab

23、le refrigerant cylinder can result in an immediate release of contents resulting in personal injury, property damage or both. Read all tank warnings for more information. 5.3.1.1 Place the tip of a flat-headed screwdriver on the inside serration of the rupture disc located on the shoulder of the tan

24、k (see Figure 1). Figure 1. Placement of Screwdriver for Piercing AHRI GUIDELINE Q-2016 3 5.3.1.2 With a hammer or mallet, lightly tap the handle of the screwdriver to pierce the rupture disc open (see Figure 2). Figure 2. Pierce Rupture Disc 5.3.1.3 Carefully, completely open the rupture disc. With

25、 a permanent magic marker, draw a large circle around the open rupture disk and write the word “EMPTY” on the tank (see Figure 3). Figure 3. Open Rupture Disc 5.3.1.4 Once the rupture disc is open, the tank can be recycled with other steel recyclables at your local steel recycling center. 5.3.2 DOT

26、Refillable Cylinder. Valves should be closed tightly and hood cap securely placed, if applicable. Cylinders should be returned to supplier or owner. 5.4 Cylinder Recycling Recommendations for Flammable Refrigerant. 5.4.1 DOT-39 Non-refillable Cylinder. Do not reuse cylinders. Cylinder must be emptie

27、d of their contents as described in Section 5.2.1. After emptied of their contents, open valve. Cylinders may be rendered to a recyclable condition by the following method. WARNING: Failure to follow these instructions for safe disposal of the non-refillable refrigerant cylinder can result in an imm

28、ediate release of contents resulting in personal injury, property damage or both. Read all tank warnings for more information. 5.4.1.1 Place the tip of a non-sparking pick on the side of the tank (see Figure 4). Figure 4. Placement of Non-sparking Pick for Piercing AHRI GUIDELINE Q-2016 4 5.4.1.2 Wi

29、th a hammer or mallet, lightly tap the handle of the non-sparking pick to pierce a hole in the side of the tank (see Figure 5). Figure 5. Pierce Side of Tank 5.4.1.3 With a permanent magic marker, draw a large circle around the hole and write the word “EMPTY” on the tank (see Figure 6). Figure 6. La

30、bel Pierced Hole 5.4.1.4 Once the hole is made, the tank can be recycled with other steel recyclables at your local steel recycling center. 5.4.2 DOT Refillable Cylinder. Valves should be closed tightly and hood cap securely placed, if applicable. Cylinders should be returned to supplier or owner. E

31、MPTY AHRI GUIDELINE Q-2016 5 APPENDIX A. REFERENCES NORMATIVE A1 Listed here are all standards, handbooks and other publications essential to the formation and implementation of the standards. All references in this appendix are considered as part of the standard. None. APPENDIX B. REFERENCES INFORM

32、ATIVE B1 Listed here are all guidelines, handbooks and other publications essential to the formation and implementation of this guideline. All references in this appendix are considered as part of the guideline. B1.1 AHRI Guideline K-2015, Containers for Recovered Fluorocarbon Refrigerants, 2015, Ai

33、r-Conditioning, Heating, and Refrigeration Institute, 2111 Wilson Boulevard, Suite 500, Arlington, VA 22201, U.S.A. B1.2 ASHRAE Terminology, https:/www.ashrae.org/resources-publications/free-resources/ashrae-terminology, 2016, American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc., 1791 Tullie Circle, N.E., Atlanta, GA 30329, U.S.A. B1.3 Title 49 CFR, Code of Federal Regulations, Office of the Federal Register, National Archives and Records Administration, 800 North Capitol Street, NW, Washington, DC 20402, U.S.A.