AECMA PREN 3733-002-2002 Aerospace Series Connector Optical Circular Single Channel Coupled by Self-Locking Ring Operating Temperature up to 150 Degrees Celsius Continuous Part 002.pdf

《AECMA PREN 3733-002-2002 Aerospace Series Connector Optical Circular Single Channel Coupled by Self-Locking Ring Operating Temperature up to 150 Degrees Celsius Continuous Part 002.pdf》由会员分享，可在线阅读，更多相关《AECMA PREN 3733-002-2002 Aerospace Series Connector Optical Circular Single Channel Coupled by Self-Locking Ring Operating Temperature up to 150 Degrees Celsius Continuous Part 002.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、AECMA STANDARD NORME AECMA AECMA NORM prEN 3733-002 Edition P 1 February 2002 PUBLISHED BY THE EUROPEAN ASSOCIATION OF AEROSPACE INDUSTRIES - STANDARDIZATION (AECMA-STAN) Gulledelle 94 - 8-1200 BRUXELLES - Tel. (+32) 2 775 81 10 - Fax. (+32) 2 775 81 11 ICs: 49.060 Descriptors: ENGLISH VERSION Aeros

2、pace series Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous Part 002: List of product standards Srie arospatiale Luft- und Raumfahrt Connecteur optique circulaire monovoie, accouplement par bague filete, temprature dutilisatio

3、n 150 “C continu Partie 002 : Liste des normes de produit Optischer Rundsteckverbinder einpolig Schraubkupplung, Betriebctemperatur 150 “C konstant Teil 002: bersicht ber die Einzelnormen This “Aerospace Series“ Prestandard has been drawn up under the responsibility of AECMA-STAN (The European Assoc

4、iation of Aerospace Industries - Standardization). It is published on green paper for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequent to the publication of this Prestandard, the technical cont

5、ent shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard. After examination and review by users and formal agreement of AECMA-STAN it will be submitted as a draff European Standard to CEN (European Committee for

6、Standardization) for formal vote. Nota - Extra copies can be supplied by B.N.A.E. - Technopolis 54 - 199, rue Jean-Jacques Rousseau - 92138 ICSY-LES-MOULINEAUX CEDEX I I Edition approved for publication 1 Comments should be sent within six months after the date of oublication to Electrical Domain 20

7、02-02-28 AECM A-STAN Gulledelle 94 8-1200 BRUXELLES Mr Peuetta aecrna 201 Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 2 prEN 3733-002: 2002 Co

8、ntents Page Scope Normative references . 3 Product type and codification . Terminology . Operating condi Tooling . Assembly and installation . Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking

9、 permitted without license from IHS-,-,-Page 3 prEN 3733-002: 2002 I Scope This standard lists the product standards for use with circular optical connectors covered by technical specification EN 3733-001. This standard also defines the conditions common to a singleway fibre optic connector with vib

10、ration proof self-locking coupling ring, for a variety of fibre and cable types, operating temperature up to 150 “C. 2 Normative references This European Standard incorporates by dated or undated reference provisions from other publications. These normative references are cited at the appropriate pl

11、aces in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication ref

12、erred to applies. EN 2591-100 EN 3733-001 EN 3733-003 EN 3733-004 EN 3733-005 EN 3733-006 EN 3733-007 EN 3733-008 EN 3733-009 EN 3733-101 EN 3733-102 Aerospace series - Elements of electrical and optical connection - Test methods - Part 100: General 1) Aerospace series - Connector, optical, circular

13、, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part O01 : Technical specification 1) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 003: Plug connecto

14、r for cable to EN 4532 - Product standard 1) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 004: Receptacle, connector, four hole fixing for cable to EN 4532 - Product standard 1) Aerospace series -

15、Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 005: Receptacle, connector, two hole fixing for cable to EN 4532 - Product standard 1) Aerospace series - Connector, optical, circular, single channel, coupled by self-loc

16、king ring, operating temperature up to 150 “C continuous - Part 006: Receptacle, connector, jam nut fixing for cable to EN 4532 - Product standard 1) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 00

17、7: Ferrule (optical contact) for cable to EN 4532 (200 p/280 pm fibre) - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 008: Plug sub-assembly for cable to EN 4532 - Product stand

18、ard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 009: Receptacle sub- assembly for cable to EN 4532 - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupied

19、 by self-locking ring, operating temperature up to 150 “C continuous - Part 101: Protective cover receptacle - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 102: Protective cover

20、 plug - Product standard 2) 1) Published as AECMA Prestandard at the date of publication of this standard 2) In preparation at the date of publication of this standard Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo r

21、eproduction or networking permitted without license from IHS-,-,-Page 4 prEN 3733-002: 2002 EN 3733-103 EN 3733-104 EN 3733-105 EN 3733-106 EN 3733-107 EN 3733-108 EN 3733-109 EN 3733-203 EN 3733-204 EN 3733-205 EN 3733-206 EN 3733-207 EN 3733-208 EN 3733-209 EN 4532 EN 4533-001 Aerospace series - C

22、onnector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 103: Protective cover jam nut - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up

23、to 150 “C continuous - Part 104: Receptacle, connector, dummy, four hole fixing - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 105: Receptacle, connector, dummy, two hole fixing

24、 - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 106: Receptacle, connector, dummy, jam nut - Product standard 2) Aerospace series - Connector, optical, circular, single channel,

25、 coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 107: Terminator cover receptacle - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 108: Strain r

26、elief boot - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 109: Epoxy - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locki

27、ng ring, operating temperature up to 150 “C continuous - Part 203: Plug connector - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 204: Receptacle, connector, four hole fixing - P

28、roduct standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 205: Receptacle, connector, two hole fixing - Product standard 2) Aerospace series - Connector, optical, circular, single channel, co

29、upled by self-locking ring, operating temperature up to 150 “C continuous - Part 206: Receptacle, connector, jam nut fixing - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 207: F

30、errule (optical contact) - Product standard 2) Aerospace series - Connector, optical, circular, single channel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 208: Plug sub-assembly - Product standard 2) Aerospace series - Connector, optical, circular, single chan

31、nel, coupled by self-locking ring, operating temperature up to 150 “C continuous - Part 209: Receptacle sub- assembly - Product standard 2) Aerospace series - Cables, optical, single core - 2001280 pm fibre, 2,5 mm outer jacket - Technical specification 2) Aerospace series - Fibre optic systems - Ha

32、ndbook - Part 001: Termination methods and tools 2) Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 5 prEN 3733-002: 2002 3 Product type and codif

33、ication See table 1. Table 1 - Product type and codification Product type Plug connector Receptacle, connector, four hole fixing Receptacle, connector, two hole fixing Receptacle, connector, jam nut fixing Ferrule (optical contact) Plug sub-assembly Receptacle sub-assembly Protective cover receptacl

34、e 2/4 hole Protective cover plug Protective cover jam nut Receptacle, connector, dummy, four hole fixing Receptacle, connector, dummy, two hole fixing Receptacle, connector, dummy, jam nut Terminator cover receptacle Strain relief boot EPOXY EN 4532 (200 1280 pm) Product standard EN 3733- (Applicabl

35、e cablelfibre) EN part no. (to be allocated) (62,5 pm/l25 pm) 003 004 005 006 007 008 O09 101 102 103 104 105 106 107 108 1 o9 203 204 205 206 207 208 209 I o1 102 103 104 105 106 107 108 1 o9 EN part no. (to be allocated) (Illustration only) 303 304 305 306 307 308 309 4 Terminology See EN 2591-100

36、. Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 6 prEN 3733-002: 2002 5 Operating conditions 5.1 Appropriate combinations of product types for t

37、he same cable/fibre, .e. EN 3733-003 to EN 3733-009 and EN 3733-203 to EN 3733-209, are compatible with the respective required performances. It is possible to interface plugs/receptacles of different fibre types, e.g. EN 3733-006 with EN 3733-203, although this is outside the scope of this standard

38、. Combinations of plugs, receptacles, subassemblies and ferrules 5.2 See table 2. Combinations of protective covers and connectors Table 2 - Combinations of protective covers and connectors 5.3 Permissible cables Product standards EN 3733-003 to EN 3733-009 will only meet the performance requirement

39、 of this standard when terminated with cable to EN 4532. Product standards EN 3733-203 to EN 3733-209 will only meet the performance requirement of this standard when terminated with cable to the applicable product standard. 5.4 Operating characteristics 5.4.1 Climatic conditions Operating temperatu

40、res: - minimum temperature: - 65 OC; - maximum temperature: 150 “C. Corrosion and fluid resistance: - salt mist: 500 h; - fluid resistance: see EN 3733-001 5.4.2 Mechanical conditions Mechanical endurance: 500 mating and unmating operations Copyright Association Europeene des Constructeurs de Materi

41、el Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 7 prEN 3733-002: 2002 6 Tooling Refer to the relevant product standard. 7 Assembly and installation Refer to EN 4533-001 for information. Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-