ISO TR 22201-3-2016 Lifts (elevators) escalators and moving walks - Programmable electronic systems in safety related applications - Part 3 Life cycle guideline.pdf
《ISO TR 22201-3-2016 Lifts (elevators) escalators and moving walks - Programmable electronic systems in safety related applications - Part 3 Life cycle guideline.pdf》由会员分享,可在线阅读,更多相关《ISO TR 22201-3-2016 Lifts (elevators) escalators and moving walks - Programmable electronic systems in safety related applications - Part 3 Life cycle guideline.pdf(16页珍藏版)》请在麦多课文档分享上搜索。
1、 ISO 2016 Lifts (elevators), escalators and moving walks Programmable electronic systems in safety related applications Part 3: Life cycle guideline for programmable electronic systems related to PESSRAL and PESSRAE Ascenseurs, escaliers mcaniques et trottoirs roulants Conception et mise au point de
2、s systmes lectroniques programmables dans les applications lies la scurit Partie 3: Lignes directrices pour le cycle de vie des systmes lectroniques programmables lis PESSRAL et PESSRAE TECHNICAL REPORT ISO/TR 22201-3 Reference number ISO/TR 22201-3:2016(E) Second edition 2016-11-15 ISO/TR 22201-3:2
3、016(E)ii ISO 2016 All rights reserved COPYRIGHT PROTECTED DOCUMENT ISO 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or
4、 posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11
5、Fax +41 22 749 09 47 copyrightiso.org www.iso.org ISO/TR 22201-3:2016(E)Foreword iv Introduction v 1 Scope . 1 2 Normative references 1 3 T erms and definitions . 1 4 Instruction manual content 3 4.1 Safety precautions 3 4.2 Markings, signs, pictograms and written warnings 3 4.3 Elements to consider
6、 for content of the instruction manual 4 5 Procedure. 4 Annex A (informative) Elements of instruction manual and validation process .6 Bibliography 8 ISO 2016 All rights reserved iii Contents Page ISO/TR 22201-3:2016(E) Foreword ISO (the International Organization for Standardization) is a worldwide
7、 federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that
8、committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this docume
9、nt and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives
10、, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development
11、 of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents). Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement. For an explanation on the meaning of ISO speci
12、fic terms and expressions related to conformit y assessment, as well as information about ISOs adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see the following URL: www.iso.org/iso/foreword.html. The committee responsible for this document is ISO/
13、TC 178, Lifts, escalators and moving walks. This second edition cancels and replaces the first edition (ISO/TR 22201-3:2013), which has been technically revised. A list of all parts in the ISO 22201 series can be found on the ISO website.iv ISO 2016 All rights reserved ISO/TR 22201-3:2016(E) Introdu
14、ction This document addresses phases in the life cycle planning and actions for post-installation activities (e.g. maintenance, repair, and replacement and modification of interface) of PESSRAL and PESSRAE to help ensure the safety integrity level (SIL) over the life cycle of the system. ISO 2016 Al
15、l rights reserved v Lifts (elevators), escalators and moving walks Programmable electronic systems in safety related applications Part 3: Life cycle guideline for programmable electronic systems related to PESSRAL and PESSRAE 1 Scope This document provides additional information and process for the
16、development of the instruction manual required by ISO 22201-1 (PESSRAL) and ISO 22201-2 (PESSRAE) for programmable electronic systems for use by competent maintenance person(s) that carry out maintenance operations. 2 Normative references There are no normative references in this document. 3 T erms
17、a nd definiti ons For the purposes of this document, the terms and definitions given in ISO 22201-1, ISO 22201-2 and the following apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: IEC Electropedia: available at http:/ /www.electropedia.org/
18、ISO Online browsing platform: available at http:/ /www.iso.org/obp 3.1 competent maintenance person designated person, suitably trained, qualified by knowledge and practical experience, provided with necessary instructions and supported within their maintenance organization (3.4) to enable the requi
19、red maintenance operations to be safely carried out Note 1 to entry: The competence of the maintenance person within the maintenance organization (3.4) should be continuously updated. 3.2 design equivalent original equipment manufacturer, or third party certified product, which fulfils same SIL rate
20、d element/subsystem design specifications but has different specifications for the non-SIL rated portion of the PE system 3.3 functional equivalent product which fulfils same functional requirements with different SIL rated element/subsystem design specifications from that of the original certified
21、product TECHNICAL REPORT ISO/TR 22201-3:2016(E) ISO 2016 All rights reserved 1 ISO/TR 22201-3:2016(E) 3.4 maintenance organization company or part of a company where competent maintenance person(s) (3.1) carry out maintenance operations on behalf of the owner (3.7) of the installation 3.5 manufactur
22、er natural or legal person who takes responsibility for the design, manufacture and placing on the market safety components for lifts or of machinery (escalator, passenger conveyor, service lift and accessible goods only lift) 3.6 maintenance post-installation life cycle activities, including preven
23、tative, replacement, repair, and alteration (modifications) 3.7 owner natural or legal person who has the power or disposal of the installation and takes the responsibility for its operation and use 3.8 programmable electronic PE based on computer technology which may be comprised of hardware, softw
24、are, and of input and/or output units Note 1 to entry: This term covers microelectronic devices based on one or more central processing units (CPUs) together with associated memories, etc. EXAMPLE The following are all programmable electronic devices: microprocessors; micro-controllers; programmable
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISOTR2220132016LIFTSELEVATORSESCALATORSANDMOVINGWALKSPROGRAMMABLEELECTRONICSYSTEMSINSAFETYRELATEDAPPLICATIONSPART3LIFECYCLEGUIDELINEPDF

链接地址:http://www.mydoc123.com/p-1257831.html