ISO IEC 20113-2004 Information technology - Telecommunications and information exchange between systems - Private Integrated Services Network - Specification fu.pdf

《ISO IEC 20113-2004 Information technology - Telecommunications and information exchange between systems - Private Integrated Services Network - Specification fu.pdf》由会员分享，可在线阅读，更多相关《ISO IEC 20113-2004 Information technology - Telecommunications and information exchange between systems - Private Integrated Services Network - Specification fu.pdf（28页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference number ISO/IEC 20113:2004(E) ISO/IEC 2004INTERNATIONAL STANDARD ISO/IEC 20113 First edition 2004-05-15 Information technology Telecommunications and information exchange between systems Private Integrated Services Network Specification, functional model and information flows Make call req

2、uest supplementary service Technologies de linformation Tlcommunications et change dinformation entre systmes Rseau priv intgration de services Spcification, modle fonctionnel et flux dinformations Service supplmentaire de demande par appel ISO/IEC 20113:2004(E) PDF disclaimer This PDF file may cont

3、ain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibi

4、lity of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation par

5、ameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO/IEC 2004 All rights reserved. Unless ot

6、herwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyri

7、ght office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2004 All rights reservedISO/IEC 20113:2004(E) ISO/IEC 2004 All rights reserved iiiContents Page Foreword iv Introduction v 1 Scope 1 2

8、 Conformance . 1 3 Normative references . 1 4 Terms and definitions. 2 4.1 External definitions. 2 4.2 Other definitions . 2 5 Acronyms. 3 6 SS-MCR stage 1 specification . 3 6.1 Description. 3 6.2 Procedures 3 6.3 Interactions with other Supplementary Services / Additional Network Features 5 6.4 Int

9、erworking considerations 8 6.5 Overall SDL 8 7 SS-MCR stage 2 specification . 10 7.1 Functional model 10 7.2 Information flows 12 7.3 Functional Entity actions . 14 7.4 Functional Entity behaviour. 15 7.5 Allocation of Functional Entities to physical equipment 20 7.6 Interworking considerations 20 I

10、SO/IEC 20113:2004(E) iv ISO/IEC 2004 All rights reservedForeword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in t

11、he development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-g

12、overnmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main ta

13、sk of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a

14、 vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. ISO/IEC 20113 was prepared by ECMA (as ECMA-343) and was adopted, under a special “fas

15、t-track procedure”, by Joint Technical Committee ISO/IEC JTC 1, Information technology, in parallel with its approval by national bodies of ISO and IEC. ISO/IEC 20113:2004(E) ISO/IEC 2004 All rights reserved vIntroduction This International Standard is one of a series defining services and signallin

16、g protocols applicable to Private Integrated Services Networks (PISNs). The series uses ISDN concepts as developed by ITU-T and conforms to the framework of International Standards for Open Systems Interconnection as defined by ISO/IEC. This International Standard specifies the Make Call Request sup

17、plementary service. This International Standard is based upon the practical experience of ECMA member companies and the results of their active and continuous participation in the work of ISO/IEC JTC1, ITU-T, ETSI and other international and national standardization bodies. It represents a pragmatic

18、 and widely based consensus. INTERNATIONAL STANDARD ISO/IEC 20113:2004(E) ISO/IEC 2004 All rights reserved 1Information technology Telecommunications and information exchange between systems Private Integrated Services Network Specification, functional model and information flows Make call request s

19、upplementary service 1 Scope This International Standard specifies supplementary service Make Call Request (SS-MCR), which is related, but not limited, to various basic services supported by Private Integrated Services Networks (PISNs). Basic services are specified in ISO/IEC 11574. The supplementar

20、y service MCR enables a Requesting User to request a Co-operating User to establish a new Requested Call to a Destination User. This new Requested Call between the Co-operating and Destination User can be either a Basic call or call independent signalling connection. Service specifications are produ

21、ced in three stages, according to the method described in ETS 300 387. This International Standard contains the stage 1 and stage 2 specifications of SS-MCR. The stage 1 specification (Clause 6) specifies the supplementary service as seen by users of PISNs. The stage 2 specification (Clause 7) speci

22、fies the functional entities involved in the supplementary service and the information flows between them. 2 Conformance In order to conform to this International Standard, a stage 3 standard shall specify signalling protocols and equipment behaviour that are capable of being used in a PISN which su

23、pports the supplementary service specified in this International Standard. This means that, to claim conformance, a stage 3 standard is required to be adequate for the support of those aspects of Clause 6 (stage 1) and Clause 7 (stage 2) which are relevant to the interface or equipment to which the

24、stage 3 standard applies. 3 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

25、ISO/IEC 11574:2000, Information technology Telecommunications and information exchange between systems Private Integrated Services Network Circuit-mode 64 kbit/s bearer services Service description, functional capabilities and information flows ISO/IEC 11579-1:1994, Information technology Telecommun

26、ications and information exchange between systems Private integrated services network Part 1: Reference configuration for PISN Exchanges (PINX) ISO/IEC 11582:2002, Information technology Telecommunications and information exchange between systems Private Integrated Services Network Generic functiona

27、l protocol for the support of supplementary services Inter-exchange signalling procedures and protocol ISO/IEC 20113:2004(E) 2 ISO/IEC 2004 All rights reservedETS 300 387:1994, Private Telecommunication Network (PTN); Method for the specification of basic and supplementary services ITU-T Rec. I.112:

28、1993, Vocabulary of terms for ISDNs ITU-T Rec. I.210:1993, Principles of telecommunication services supported by an ISDN and the means to describe them ITU-T Rec. Z.100:1999, Specification and Description Language 4 Terms and definitions For the purposes of this document, the following terms and def

29、initions apply. 4.1 External definitions This International Standard uses the following terms defined in other documents: Basic Service (ISO/IEC 11574) Call, Basic call (ISO/IEC 11582) Call independent signalling connection (ISO/IEC 11582) Call Independent (ISO/IEC 11582) Call Related (ISO/IEC 11582

30、) Private Integrated services Network eXchange (PINX) (ISO/IEC 11579-1) Private Integrated Services Network (PISN) (ISO/IEC 11579-1) Service (ITU-T Rec. I.112) Signalling (ITU-T Rec. I.112) Supplementary Service (ITU-T Rec. I.210) User (ISO/IEC 11574) 4.2 Other definitions 4.2.1 Co-operating User Th

31、e user who receives a Make Call Request and who shall set up a new Requested Call to the Destination User. 4.2.2 Destination User The called user of the Requested Call i.e. the user to whom the Co-operating User shall establish a Requested Call. 4.2.3 Make Call Request A request from the Requesting

32、User for a new call (i.e. Requested Call) between a Co-operating User and a Destination User. ISO/IEC 20113:2004(E) ISO/IEC 2004 All rights reserved 34.2.4 Original Call The call between the Requesting User and the Co-operating User. The Original Call can be either a Basic call or a call independent

33、 signalling connection and is correlated with the Requested Call. 4.2.5 Requested Call The call between the Co-operating User and the Destination User that is established by the Co-operating User due to a Make Call Request from the Requesting User. The Requested Call can either be a Basic call (with

34、 a specific Basic Service) or a call independent signalling connection and is correlated with the Original Call. 4.2.6 Requesting User The User who sends a Make Call Request to the Co-operating User with the request to establish a specific Requested Call to the Destination User. 5 Acronyms ANF Addit

35、ional Network Feature FE Functional Entity ISDN Integrated Services Digital Network MCR Make Call Request PINX Private Integrated services Network eXchange PISN Private Integrated Services Network SDL Specification and Description Language SS Supplementary Service 6 SS-MCR stage 1 specification 6.1

36、Description 6.1.1 General description The supplementary service MCR enables a Requesting User to request a Co-operating User to establish a new Requested Call to a Destination User. This new Requested Call between the Co-operating User and the Destination User can either be a Basic call or a call in

37、dependent signalling connection. The new Requested Call shall be correlated to the Original Call between the Requesting User and the Co-operating User. 6.1.2 Qualifications on applicability to telecommunication services This supplementary service is applicable to all basic telecommunication services

38、. 6.2 Procedures 6.2.1 Provision / withdrawal SS-MCR may be provided or withdrawn after pre-arrangement with the service provider or may be generally available to all users. ISO/IEC 20113:2004(E) 4 ISO/IEC 2004 All rights reserved6.2.2 Normal procedures 6.2.2.1 Activation, deactivation and interroga

39、tion Not applicable. 6.2.2.2 Invocation and operation A Requesting User may use SS-MCR to request the set up of a new Requested Call between a Co-operating User and a Destination User. NOTE The Requesting User and the Destination User can be the same user (e.g. Requesting/Destination User is a Messa

40、ge Centre) To invoke SS-MCR the Requesting User may use, if available, an existing signalling connection (either call- related or call-independent) with the Co-operating User, otherwise the Requesting User shall establish a call independent signalling connection to the Co-operating User in order to

41、convey the following information: address information of the Destination User (e.g. Party Number); optionally, number information of the Co-operating User (e.g. Party Number); optionally, number information of the Requesting User (e.g. Party Number); an indication for a Basic Service, if a Basic cal

42、l is requested, otherwise an indication for a call independent signalling connection; a correlation ID for the Original Call and the Requested Call; an indication whether to retain the Original Call after successful establishment of the Requested Call. If the entity serving the Co-operating User sup

43、ports SS-MCR, this entity may check whether the Requesting User is allowed to invoke SS-MCR and if a call independent signalling connection or a Basic call with the indicated Bearer Service can be established. Afterwards, the Co-operating User may be informed about the SS-MCR request. The Requested

44、Call shall be either a Basic call with the requested Basic Service or a call independent signalling connection, due to the received request. Additionally the following information shall be sent to the Destination User: address information of the Requesting User and Co-operating User (i.e. Party Numb

45、er of the Requesting User) if received; a correlation ID for the Original Call and the Requested Call. If the Requested Call is successfully established, an appropriate indication shall be sent to the Requesting User. The Original Call shall be retained or cleared immediately after successful establ

46、ishment of the Requested Call dependent on the corresponding indication received in the initial Make Call Request from the Requesting User. The Co-operating User is responsible for clearing of the Requested Call. In case of retention of the Original Call the Requesting User is responsible for cleari

47、ng of the Original Call to the Co-operating User. 6.2.3 Exceptional procedures 6.2.3.1 Activation, deactivation and interrogation Not applicable. ISO/IEC 20113:2004(E) ISO/IEC 2004 All rights reserved 56.2.3.2 Invocation and operation If the entity serving the Co-operating User does not support SS-M

48、CR or if the validation of the request from the Requesting user fails or a call independent signalling connection or a Basic call with the indicated Basic Service cannot be established, an appropriate error indication shall be sent to the Requesting User. The Requesting User is responsible for clear

49、ing of the Original Call. If the Co-operating User is busy when SS-MCR is invoked, an appropriate error indication shall be sent to the Requesting User. The Requesting User is responsible for clearing the Original Call. 6.3 Interactions with other Supplementary Services / Additional Network Features Interactions with other supplementary services and ANFs for which PISN standards were available at the time of publication of this International Standard a