ISO 8583-3-2003 Financial transaction card originated messages - Interchange message specifications - Part 3 Maintenance procedures for messages data elements a.pdf

《ISO 8583-3-2003 Financial transaction card originated messages - Interchange message specifications - Part 3 Maintenance procedures for messages data elements a.pdf》由会员分享，可在线阅读，更多相关《ISO 8583-3-2003 Financial transaction card originated messages - Interchange message specifications - Part 3 Maintenance procedures for messages data elements a.pdf（16页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference number ISO 8583-3:2003(E) ISO 2003INTERNATIONAL STANDARD ISO 8583-3 Second edition 2003-05-01 Financial transaction card originated messages Interchange message specifications Part 3: Maintenance procedures for messages, data elements and code values Messages initis par cartes de transact

2、ion financire Spcifications dchange de messages Partie 3: Procdures de maintenance pour messages, lments de donnes et valeurs de code ISO 8583-3:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but sha

3、ll not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area.

4、 Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by

5、ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electron

6、ic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org

7、Web www.iso.org Published in Switzerland ii ISO 2003 All rights reservedISO 8583-3:2003(E) ISO 2003 All rights reserved iiiContents Page Foreword iv 1 Scope 1 2 Normative references . 1 3 Terms and definitions. 1 4 Application procedures 1 4.1 Application procedure for changes to ISO 8583-1 1 4.2 Cr

8、iteria for approval of an application for changes to ISO 8583-1 2 5 Appeal process . 2 5.1 Appeal bodies 2 5.2 Information to be provided. 3 6 Balloting process 3 7 Sponsoring authority 3 7.1 Eligibility to become a sponsoring authority. 3 7.2 Responsibilities. 3 8 Registration and maintenance manag

9、ement group (RMMG) . 4 8.1 Constitution . 4 8.2 Responsibilities. 4 8.3 Voting procedures 5 9 Maintenance Agency 5 9.1 Appointment 5 9.2 Resignation 5 9.3 Responsibilities. 6 10 Publication of changes to ISO 8583-1. 6 Annex A (normative) Information to be provided for changes to ISO 8583-1 7 ISO 858

10、3-3:2003(E) iv ISO 2003 All rights reservedForeword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member

11、 body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Elect

12、rotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopte

13、d by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent

14、 rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 8583-3 was prepared by Technical Committee ISO/TC 68, Banking, securities and other financial services, Subcommittee SC 6, Retail financial services. This second edition cancels and replaces the first editi

15、on (ISO 8583-3:1998), which has been technically revised. ISO 8583 consists of the following parts, under the general title Financial transaction card originated messages Interchange message specifications: Part 1: Messages, data elements and code values Part 2: Application and registration procedur

16、es for Institution Identifier Codes (IIC) Part 3: Maintenance procedures for messages, data elements and code values INTERNATIONAL STANDARD ISO 8583-3:2003(E) ISO 2003 All rights reserved 1Financial transaction card originated messages Interchange message specifications Part 3: Maintenance procedure

17、s for messages, data elements and code values 1 Scope This part of ISO 8583 establishes the role of the maintenance agency (MA) and specifies the procedures for adding messages and data elements to ISO 8583-1 and to codes listed in Annex A of ISO 8583-1. The responsibilities of the MA relate to all

18、message type identifiers and classes, data elements and sub- elements, dataset identifiers and codes within ISO 8583-1, with the exception of Institution Identification Codes. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated

19、references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 8583-1, Financial transaction card originated messages Interchange message specifications Part 1: Messages, data elements and code values ISO 8583

20、-2, Financial transaction card originated messages Interchange message specifications Part 2: Application and registration procedures for Institution Identification Codes (IIC) 3 Terms and definitions For the purposes of this document, the following terms and definitions given in ISO 8583-1 and the

21、following apply. 3.1 sponsoring authority entity that submits requests for changes to ISO 8583 (all parts) to the RMMG 4 Application procedures 4.1 Application procedure for changes to ISO 8583-1 An applicant shall apply to the appropriate sponsoring authority to request approval of a new message ty

22、pe identifier or class, data element or sub-element, dataset identifier or code value by providing the information specified in Annex A. ISO 8583-3:2003(E) 2 ISO 2003 All rights reservedAn applicant shall also provide the information specified below: a) date of request; b) name of the applicant; c)

23、address for correspondence (name, address, telephone, email address and fax/telex numbers, etc. of the applicant); d) date of implementation (indicate if special conditions of urgency apply). 4.2 Criteria for approval of an application for changes to ISO 8583-1 Any changes approved by the RMMG shall

24、 be uniquely identified within a specific edition of the International Standard so as to allow backwards compatibility with existing implementations of the same version. Backwards compatibility within a given version of the International Standard is of utmost importance. There shall be no confusion

25、as to existing message type identifiers or classes, data elements or sub-elements, dataset identifiers or code values introduced by a proposed change. The use of bit maps allows for the proper validation and acceptance or rejection of messages by implementations of ISO 8583 (all parts) for functions

26、 that are supported and allows unsupported data elements and message types to be ignored. An application for a change to the International Standard shall be approved by the RMMG when the following conditions exist: a) the requested message type identifier or class, data element or sub-element, datas

27、et identifier or code does not duplicate a message type identifier or class, data element or sub-element, dataset identifier or code value already included in the International Standard; b) the requested message type identifier or class, data element or sub-element, dataset identifier or code value

28、is intended for use within an implementation of ISO 8583-1 and is to be included in it; c) the request does not concern the change in meaning or deletion of an existing message type identifier or class, data element or sub-element, dataset identifier or code value (this can only be done by a revisio

29、n of ISO 8583-1); d) the request does not concern the change in meaning or deletion of an existing data element condition code (this can only be done by a revision of ISO 8583-1); e) the request is not for the reassignment of an existing message type identifier or class, data element or sub-element,

30、 dataset identifier or code value (this can only be done by a revision of ISO 8583-1); f) the request is consistent with existing relevant International Standard, including those published by other ISO technical committees; g) the information provided in the application is complete. 5 Appeal process

31、 5.1 Appeal bodies Where an application has been rejected by the RMMG, the applicant may appeal to ISO through the secretariat of ISO/TC 68/SC 6. Applicants may submit, for appeal, applications that have been rejected by ISO/TC 68/SC 6 to the ISO Central Secretariat. ISO 8583-3:2003(E) ISO 2003 All

32、rights reserved 35.2 Information to be provided Where an application for a new message type identifier or class, data element or sub-element, dataset identifier or code value has been rejected, the following information shall be provided by the applicant to the relevant appeal body in support of the

33、 appeal: a) statement for which rejection is disputed and why the applicant believes that the rejected application fulfils the criteria for acceptance; b) statement of special circumstances whereby a specific requirement of the rejected application can be met. 6 Balloting process Where an applicatio

34、n for a new message type identifier or class, data element or sub-element or dataset identifier has been submitted and approved by the RMMG, it shall be necessary to create an amendment to ISO 8583-1 that documents the changes. The amendment (e.g. technical changes to the document) shall be balloted

35、 to ISO members using the most expeditious ISO amendment procedure. If the change is only for a new code value for an existing data element documented in Annex A of ISO 8583-1, the RMMG can approve the request with no need for an ISO ballot. 7 Sponsoring authority 7.1 Eligibility to become a sponsor

36、ing authority The following bodies may act as a sponsoring authority in processing applications for a new message type identifier or class, data element or sub-element, dataset identifier or code value: a) any national member body of ISO (or agent appointed to act for its national member body); b) I

37、SO/TC 68/SC 6. 7.2 Responsibilities The responsibilities of a sponsoring authority shall be: a) to fully comply with the procedures for applications described in this part of ISO 8583 for new message type identifiers or classes, data elements or sub-elements, dataset IDs or code values and to ensure

38、 that the applicant uses ISO 8583-1; b) to process, within 30 days of receipt of the request, applications for new message type identifiers or classes, data elements or sub-elements, dataset IDs or code values from within their countries or areas of responsibility; c) to notify the applicant in writ

39、ing, within 30 days of receipt of the application, as to the disposition of their application; d) to forward to the MA those sponsored requests for new message type identifiers or classes, data elements or sub-elements, dataset IDs or code values that shall be used for the purposes described in this

40、 part of ISO 8583 and that meet the approval criteria in 4.2; e) to respond to general enquiries covering this part of ISO 8583. ISO 8583-3:2003(E) 4 ISO 2003 All rights reserved8 Registration and maintenance management group (RMMG) 8.1 Constitution In order to effectively manage the contents of ISO

41、 8583-1, TC 68/SC 6 has established an RMMG, which is empowered to act on its behalf. The following chart shows the relationship of the RMMG to ISO TC68/SC6, the registration authority that handles IICs as defined in ISO 8583-2 and the maintenance agency as defined in this part of ISO 8583. Figure 1

42、 Relationship of maintenance bodies The RMMG shall be made up of: a) a representative of the MA, who shall be a non-voting member of the RMMG and shall be expected to attend all meetings; b) the convener; c) the secretary. In addition, each member of ISO/TC 68/SC 6 is entitled to nominate one delega

43、te and one alternate to the RMMG. The alternate may attend all meetings, but is entitled to vote only in the absence of the principal delegate. 8.2 Responsibilities The responsibilities of the RMMG shall be: a) to act on all applications forwarded from the MA; ISO 8583-3:2003(E) ISO 2003 All rights

44、reserved 5b) to respond to all requests for guidance from the MA; c) to approve the report from the MA; d) to review annually the register of the codes of Annex A of ISO 8583-1; e) to report its activities to each meeting of ISO/TC 68/SC 6; f) to establish in the normal course of work, additional ru

45、les for the practical application of the principles for adding new message type identifiers or classes, data elements or sub-elements, dataset IDs or code values within this part of ISO 8583. 8.3 Voting procedures All requests will be dealt with by the RMMG who may use a postal or electronic ballot

46、or voting at a meeting to authorize requests. a) If the request is only for new code values for an existing data element documented in Annex A of ISO 8583-1, the approval by a majority of the voting members of the RMMG is all that is required. b) If the request is for more than ten consecutive code

47、values for an existing data element documented in Annex A of ISO 8583-1, the unanimous approval of the RMMG (with at least five members voting) is required. c) If the request is for new message type identifiers or classes, data elements or sub-elements, or dataset identifiers, the unanimous approval

48、 of the RMMG (with at least five members voting) is required. When a postal or electronic ballot fails to reach a decision, it shall be referred to a meeting. 9 Maintenance agency 9.1 Appointment One of the members of ISO/TC 68/SC 6, or any approved body, shall be appointed to act as the MA under le

49、gal agreement with ISO in accordance with Annex H of the ISO/TC 68 Directives. The current address of the MA of ISO 8583-1 is: AFNOR ISO 8583-1 Maintenance Agency 11 avenue Francis de Pressens 93571 Saint-Denis La Plaine Cedex FRANCE 9.2 Resignation If a MA finds it necessary to resign, six months notice shall be given to the ISO Central Secretariat and to the secretariat of ISO/TC 68/SC 6. The secretariat of ISO/TC 68/SC 6 shall notify the RMMG and initiate a search for a new MA. If a new MA cannot be found withi