ISO 13399-1 CORR 2-2011 Cutting tool data representation and exchange - Part 1 Overview fundamental principles and general information model Technical Corrigend.pdf

《ISO 13399-1 CORR 2-2011 Cutting tool data representation and exchange - Part 1 Overview fundamental principles and general information model Technical Corrigend.pdf》由会员分享，可在线阅读，更多相关《ISO 13399-1 CORR 2-2011 Cutting tool data representation and exchange - Part 1 Overview fundamental principles and general information model Technical Corrigend.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、ICS 25.100.01; 35.240.50 Ref. No. ISO 13399-1:2006/Cor.2:2011(E) ISO 2011 All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 13399-1:2006 TECHNICAL CORRIGENDUM 2 Published 2011-03-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATIONCutti

2、ng tool data representation and exchange Part 1: Overview, fundamental principles and general information model TECHNICAL CORRIGENDUM 2 Reprsentation et change des donnes relatives aux outils coupants Partie 1: Vue densemble, principes fondamentaux et modle gnral dinformations RECTIFICATIF TECHNIQUE

3、 2 Technical Corrigendum 2 to ISO 13399-1:2006 was prepared by Technical Committee ISO/TC 29, Small tools. Page viii, Introduction Add the following at the end of the Introduction: Since the content of those dictionaries evolves according to industrial innovations and constant improvement of technol

4、ogy in cutting tools, a Maintenance Agency has been established for the purposes of: correcting errors in the entries of existing classes and properties; adding new properties to existing classes; adding new classes and their properties; managing the status of those properties and classes; migrating

5、 the dictionary to subsequent editions of ISO 13399 (all parts). Ref. No. ISO 13399-1:2006/Cor.2:2011(E) 2 ISO 2011 All rights reservedThe secretariat of this Maintenance Agency has been assigned to Union de Normalisation de la Mcanique F-92038 Paris La Dfense CEDEX France by the ISO Technical Manag

6、ement Board. The website of the Maintenance Agency is available at: http:/www.unm.fr/en/general/iso13399/default.htm. The reference dictionaries are available in the form of EXPRESS files on the website of the Maintenance Agency. These files are considered complementary to this International Standar

7、d; they can be freely downloaded and used for cutting tool data representation and exchange. The following permission notice and disclaimer shall be included in all copies of this EXPRESS schema (“the Schema“), and derivations of the Schema: ISO 2011 All rights reserved Permission is hereby granted,

8、 free of charge in perpetuity, to any person obtaining a copy of the Schema, to use, copy, modify, merge and distribute free of charge, copies of the Schema for the purposes of developing, implementing, installing and using software based on the Schema, and to permit persons to whom the Schema is fu

9、rnished to do so, subject to the following conditions: THE SCHEMA IS PROVIDED “AS IS“, WITHOUT WARRANTY OF ANY KIND, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT. IN NO EVENT SHALL ISO, OR ANY OTHER LICE

10、NSOR THAT GRANTS THE RIGHT UNDER THE ABOVE PERMISSION TO USE THE SCHEMA, BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SCHEMA OR THE USE OR OTHER DEALINGS IN THE SCHEMA. In addition, any modified copy of the Schema shall include the following notice: THIS SCHEMA HAS BEEN MODIFIED FROM THE SCHEMA DEFINED IN ISO 13399, AND SHOULD NOT BE INTERPRETED AS COMPLYING WITH THAT INTERNATIONAL STANDARD.