IEEE C37 11-2014 en Requirements for Electrical Control for AC High-Voltage ( 1000 V) Circuit Breakers《AC高压( 1000 V)断路器的电气控制要求》.pdf

《IEEE C37 11-2014 en Requirements for Electrical Control for AC High-Voltage ( 1000 V) Circuit Breakers《AC高压( 1000 V)断路器的电气控制要求》.pdf》由会员分享，可在线阅读，更多相关《IEEE C37 11-2014 en Requirements for Electrical Control for AC High-Voltage ( 1000 V) Circuit Breakers《AC高压( 1000 V)断路器的电气控制要求》.pdf（30页珍藏版）》请在麦多课文档分享上搜索。

1、 IEEE Standard Requirements for Electrical Control for AC High-Voltage (1000 V) Circuit Breakers Sponsored by the Switchgear Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std C37.11-2014 (Revision of IEEE Std C37.11-1997) IEEE Std C37.11-2014 (Revision o

2、f IEEE Std C37.11-1997) IEEE Standard Requirements for Electrical Control for AC High-Voltage (1000 V) Circuit Breakers Sponsor Switchgear Committee of the IEEE Power and Energy Society Approved 10 December 2014 IEEE-SA Standards Board Abstract: Standard requirements for all types of electrical cont

3、rol circuits for ac high-voltage circuit breakers rated above 1000 V are given. This standard is applicable for any type of power- operated mechanism and for both ac and dc control power. Only basic control elements of the circuit breaker, including reclosing where required, are included in this sta

4、ndard. Devices or circuits for protective relaying, special interlocking, etc., are not included. Keywords: ac high-voltage circuit breakers, alarm circuits, auxiliary contacts, auxiliary switch, closing, control schemes, electrical control, grounding, heater circuits, IEEE C37.11, metal-clad switch

5、gear, metal-enclosed switchgear, motor circuits, opening, re-closing, tripping The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2015 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 19 Febru

6、ary 2015. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: result

7、s; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services

8、related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards avail

9、able, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent

10、 judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUEN

11、TIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT

12、OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard

13、 is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official

14、position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered

15、 the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advi

16、ce pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and que

17、stions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For t

18、he same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 H

19、oes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard

20、 are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved st

21、andards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the

22、 promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non

23、-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1

24、978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any ti

25、me by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every I

26、EEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to

27、check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/stand

28、ards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL:

29、http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no pos

30、ition is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.iee

31、e.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to

32、applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of

33、Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of an

34、y patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2015 IEEE. All rights reserved. vi Participants At the time this IEEE standard was completed, the HVCB Electrical Con

35、trols Working Group had the following membership: John C. Webb, Chair Mike Crawford, Vice Chair Michael Anderson Mauricio Aristizabal Robert Barnett W.J. (Bill) Bergman Stan Billings Arben Bufi Eldridge Byron Gilbert Carmona Patrick Di Lillo Douglas J. Edwards Hua Ying Liu Russell Long Anthony Ricci

36、uti Michael Skidmore Wes Wadsworth Jiong Zhang Xi Zhu The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. William Ackerman Roy Alexander Mauricio Aristizabal Ficheux Arnaud Robert Barnett David Bassett

37、 George Becker Seth Benson W.J. (Bill) Bergman Stan Billings Wallace Binder Anne Bosma Steven Brown Ted Burse William Byrd Eldridge Byron Paul Cardinal Stephen Cary Steven Chen Chih Chow Ray Davis Gary Donner Randall Dotson Denis Dufournet Edgar Dullni Douglas J. Edwards Ronald Esco Frank Gerleve Do

38、uglas Giraud Mietek Glinkowski Edwin Goodwin James Graham Randall Groves Ajit Gwal Timothy Hayden Gary Heuston Philip Hopkinson Todd Irwin John Kay Gael Kennedy Yuri Khersonsky James Kinney Joseph L. Koepfinger Boris Kogan Jim Kulchisky Saumen Kundu George Kyle Chung-Yiu Lam John Leach Hua Ying Liu

39、Li Liu Albert Livshitz Greg Luri William McBride T. David Mills Daleep Mohla Georges Montillet Jerry Murphy Jeffrey Nelson Michael Newman Joe Nims T. W. Olsen Lorraine Padden Richard Paes Mirko Palazzo Christopher Petrola Iulian Profir Anthony Ricciuti Michael Roberts Charles Rogers Thomas Rozek Ste

40、ven Sano Roderick Sauls Bartien Sayogo Robert Seitz Hamid Sharifnia Devki Sharma Sushil Shinde John Shullaw Michael Sigmon James Smith Jerry Smith Gary Stoedter Ryan Stone Paul Sullivan James Swank David Tepen Malcolm Thaden Joe Uchiyama Eric Udren John Vergis Ilia Voloh William Walter John C. Webb

41、Kenneth White Kenneth White Larry Yonce Jian Yu Xi Zhu Copyright 2015 IEEE. All rights reserved. vii When the IEEE-SA Standards Board approved this standard on 10 December 2014, it had the following membership: John Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstanti

42、nos Karachalios, Secretary Peter Balma Farooq Bari Ted Burse Clint Chaplain Stephen Dukes Jean-Phillippe Faure Gary Hoffman Michael Janezic Jeffrey Katz Joseph L. Koepfinger* David J. Law Hung Ling Oleg Logvinov Ted Olsen Glenn Parsons Ron Peterson Adrian Stephens Peter Sutherland Yatin Trivedi Phil

43、 Winston Don Wright Yu Yuan *Member Emeritus Also included are the following nonvoting IEEE-SA Standards Board liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Michelle Turner IEEE-SA Content Production and Management Erin Spiewak IEEE-SA Technical Program Operations