IEC 61547-2009 Equipment for general lighting purposes - EMC immunity requirements《一般照明用设备.电磁兼容性(EMC)抗扰度要求》.pdf

《IEC 61547-2009 Equipment for general lighting purposes - EMC immunity requirements《一般照明用设备.电磁兼容性(EMC)抗扰度要求》.pdf》由会员分享，可在线阅读，更多相关《IEC 61547-2009 Equipment for general lighting purposes - EMC immunity requirements《一般照明用设备.电磁兼容性(EMC)抗扰度要求》.pdf（34页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 61547Edition 2.0 2009-06INTERNATIONAL STANDARD NORME INTERNATIONALEEquipment for general lighting purposes EMC immunity requirements quipements pour lclairage usage gnral Exigences concernant limmunit CEM IEC61547:2009 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2009 IEC, Geneva, Switzerl

2、and All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country o

3、f the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, auc

4、une partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le

5、copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office 3, rue de Varemb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch Abo

6、ut the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant revie

7、w by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Catalogue of IEC publications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,). It als

8、o gives information on projects, withdrawn and replaced publications. IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published details twice a month all new publications released. Available on-line and also by email. Electropedia: www.electropedi

9、a.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary online. Customer Service Centre: www.iec.c

10、h/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 A propos de la CEI La Commission Electrotechnique Internationale (CEI) es

11、t la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous poss

12、dez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm Le Catalogue en-ligne de la CEI vous permet deffectuer des recherches en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Il donn

13、e aussi des informations sur les projets et les publications retires ou remplaces. Just Published CEI: www.iec.ch/online_news/justpub Restez inform sur les nouvelles publications de la CEI. Just Published dtaille deux fois par mois les nouvelles publications parues. Disponible en-ligne et aussi par

14、email. Electropedia: www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 20 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotech

15、nique International en ligne. Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions, visitez le FAQ du Service clients ou contactez-nous: Email: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 91

16、9 03 00 IEC 61547Edition 2.0 2009-06INTERNATIONAL STANDARD NORME INTERNATIONALEEquipment for general lighting purposes EMC immunity requirements quipements pour lclairage usage gnral Exigences concernant limmunit CEM INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONAL

17、E PICS 29.020; 29.140; 33.100.10 PRICE CODECODE PRIXISBN 2-8318-1047-7 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale 2 61547 IEC:2009 CONTENTS FOREWORD.4 1 Scope.6 2 Normative references .6 3 Terms and definitions

18、.7 4 Performance criteria .8 5 Test specifications9 5.1 General .9 5.2 Electrostatic discharges 9 5.3 Radio-frequency electromagnetic fields .10 5.4 Power frequency magnetic fields .10 5.5 Fast transients 10 5.6 Injected currents (radio-frequency common mode) 11 5.7 Surges 12 5.8 Voltage dips and sh

19、ort interruptions 12 5.9 Voltage fluctuations.13 6 Application of test specifications.13 6.1 General .13 6.2 Non-electronic lighting equipment13 6.3 Electronic lighting equipment.13 6.3.1 General .13 6.3.2 Self-ballasted lamps 13 6.3.3 Independent auxiliaries14 6.3.4 Luminaires.14 7 Conditions durin

20、g testing 14 8 Assessment of conformity.15 Figure 1 Examples of ports 8 Table 1 Electrostatic discharges Test levels at enclosure port.10 Table 2 Radio-frequency electromagnetic fields Test levels at enclosure port .10 Table 3 Power frequency magnetic fields Test levels at enclosure port .10 Table 4

21、 Fast transients Test levels at ports for signal and control lines .10 Table 5 Fast transients Test levels at input and output d.c. power ports11 Table 6 Fast transients Test levels at input and output a.c. power ports11 Table 7 Radio-frequency common mode Test levels at ports for signal and control

22、 lines11 Table 8 Radio-frequency common mode Test levels at input and output d.c. power ports .11 Table 9 Radio-frequency common mode Test levels at input and output a.c. power ports .12 Table 10 Surges Test levels at input a.c. power ports .12 Table 11 Voltage dips Test levels at input a.c. power p

23、orts .12 Table 12 Voltage short interruptions Test levels at input a.c. power ports .13 Table 13 Application of tests for self-ballasted lamps.13 61547 IEC:2009 3 Table 14 Application of tests for independent auxiliaries 14 Table 15 Application of tests for luminaires14 4 61547 IEC:2009 INTERNATIONA

24、L ELECTROTECHNICAL COMMISSION _ EQUIPMENT FOR GENERAL LIGHTING PURPOSES EMC IMMUNITY REQUIREMENTS FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object

25、of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications

26、(PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising

27、with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as

28、 nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in

29、 that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Commi

30、ttees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking p

31、rocedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or

32、agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use

33、of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that so

34、me of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 61547 has been prepared by IEC technical committee 34: Lamps and related equipment. This second edition cancels

35、and replaces the first edition, published in 1995, and its Amendment 1 (2000). It constitutes a technical revision The main reason for this revision is to update the dates of the references to the basic standards which also required some editorial changes in the tables. Other changes are: 1 Scope: c

36、learly excludes multimedia equipment with lamps (e.g. TV); 3.2 Enclosure port: removal of the ”earth port” in Figure 1 as in the generic EMC standards; the note below Figure 1 in the first edition relates to a requirement and moved to the main text under 5.1 General; 5.6 Injected currents: update of

37、 the names of the example CDNs; 5.7 Surges: test only at the peak of the mains voltage by deleting the requirement to test at zero crossings; 5.8 Voltage dips and interruptions: clarifying that the voltage level changes at the zero crossing; 61547 IEC:2009 5 6.3.2 Independent auxiliaries: Table 14 h

38、as been simplified because most independent auxiliaries have identical performance criteria; 6.3.3 Luminaires: Table 15 has been simplified because most luminaires have identical performance criteria; correcting the error in the injected current column by changing the B into A for luminaires with el

39、ectronic ballast for discharge lamps; additionally, the requirements for emergency luminaires operating in high risk task areas are updated to meet the levels specified in IEC 60598-2-22; 7 Conditions during testing: the ”under consideration” for the operating conditions for starting devices has bee

40、n deleted; the supply voltage and frequency during the test are clearly stated; shortening the immunity test for equipment incorporating a regulating control by testing at one light output level (50 % 10 %) instead of testing at three light output levels which are difficult to adjust and do not prov

41、ide extra protection. The text of this standard is based on the following documents: FDIS Report on voting 34/127/FDIS 34/130/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in a

42、ccordance with the ISO/IEC Directives, Part 2. This standard is to be read in conjunction with the relevant basic and/or product standard(s). The committee has decided that the contents of this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “h

43、ttp:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. 6 61547 IEC:2009 EQUIPMENT FOR GENERAL LIGHTING PURPOSES EMC IMMUNITY REQUIREMENTS 1 Scope This International Standard for e

44、lectromagnetic immunity requirements applies to lighting equipment which is within the scope of IEC technical committee 34, such as lamps, auxiliaries and luminaires, intended either for connecting to a low voltage electricity supply or for battery operation. Excluded from the scope of this standard

45、 is equipment for which the immunity requirements are formulated in other IEC or CISPR standards such as: lighting equipment for use in transport vehicles; entertainment lighting control equipment for professional purposes; lighting devices built into other equipment such as: scale illumination or i

46、ndicators; photocopiers; slide and overhead projectors; multimedia equipment. However, in multi-function equipment where the lighting part operates independently from other parts, the electromagnetic immunity requirements of this standard apply to the lighting part. The requirements of this standard

47、 are based on the requirements for domestic, commercial and light-industrial environments as given in IEC 61000-6-1, but modified to lighting engineering practice. It can be expected that lighting equipment complying with the requirements of this standard will operate satisfactorily in other environ

48、ments. In some special cases, measures have to be taken to provide higher immunity. It is impracticable to deal with all these possibilities. Such requirements may be established by contractual agreement between supplier and purchaser. 2 Normative references The following referenced documents are in

49、dispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60050-161, International Electrotechnical Vocabulary Chapter 161: Electromagnetic Compatibility IEC 60050-845, International Electrote