BS EN 50121-3-2-2006 铁路设施.电磁兼容性.机车车辆.仪表.pdf

《BS EN 50121-3-2-2006 铁路设施.电磁兼容性.机车车辆.仪表.pdf》由会员分享，可在线阅读，更多相关《BS EN 50121-3-2-2006 铁路设施.电磁兼容性.机车车辆.仪表.pdf（24页珍藏版）》请在麦多课文档分享上搜索。

1、This European Standard applies to emission and immunity aspects of EMC for electrical and electronicapparatus intended for use on railway rolling stock. EN 50121-3-2 applies for the integration ofapparatus on rolling stock.The frequency range considered is from d.c. to 400 GHz. No measurements need

2、to be performed atfrequencies where no requirement is specified.The application of tests shall depend on the particular apparatus, its configuration, its ports, itstechnology and its operating conditions.This standard takes into account the internal environment of the railway rolling stock and the e

3、xternalenvironment of the railway, and interference to the apparatus from equipment such as hand-held radiotransmitters.If a port is intended to transmit or receive for the purpose of radio communication (intentional radiators,e.g. transponder systems), then the emission and immunity limits in this

4、standard at thecommunication frequency do not apply.This standard does not apply to transient emissions when starting or stopping the apparatus.The objective of this standard is to define limits and test methods for electromagnetic emissions andimmunity test requirements in relation to conducted and

5、 radiated disturbances.These limits and tests represent essential electromagnetic compatibility requirements.Emission requirements have been selected so as to ensure that disturbances generated by theapparatus operated normally on railway rolling stock do not exceed a level which could prevent other

6、apparatus from operating as intended.Likewise, the immunity requirements have been selected so as to ensure an adequate level ofimmunity for rolling stock apparatus.The levels do not however cover extreme cases which may occur with an extremely low probability ofoccurrence in any location. Specific requirements which deviate from this standard shall be specified.Test requirements are specified for each port considered.These specific provisions are to be used in conjunction with the general provisions in EN 50121-1.