VA 10 44 13-2011 FIRE EXTINGUISHER CABINETS.pdf

《VA 10 44 13-2011 FIRE EXTINGUISHER CABINETS.pdf》由会员分享，可在线阅读，更多相关《VA 10 44 13-2011 FIRE EXTINGUISHER CABINETS.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、11-11 10 44 13 - 1 SECTION 10 44 13 FIRE EXTINGUISHER CABINETS SPEC WRITER NOTE: 1. Delete between /-/ If not applicable to project. Also delete any other item or paragraph not applicable in the section and renumber the paragraphs. 2. Use fully recessed cabinets. Do not allow projection of doors and

2、 frames into corridor areas other than frame flange thickness. 3. Insure details show cabinet recessed in wall with no penetration of fire rating when applicable. 4. Insure detail shows elevation of cabinet with glazing. PART 1 - GENERAL 1.1 DESCRIPTION This section covers recessed fire extinguisher

3、 cabinets. 1.2 RELATED WORK A. Acrylic glazing: Section 08 80 00, GLAZING. B. Field Painting: Section 09 91 00, PAINTING. 1.3 SUBMITTALS A. Submit in accordance with Section 01 33 23, SHOP DRAWINGS, PRODUCT DATA, AND SAMPLES. B. Manufacturers Literature and Data: Fire extinguisher cabinet including

4、installation instruction and rough opening required. 1.4 APPLICATION PUBLICATIONS A. The publications listed below form a part of this specification to the extent referenced. The publications are referenced in the text by the basic designation only. B. American Society of Testing and Materials (ASTM

5、): D4802-10 . Poly (Methyl Methacrylate) Acrylic Plastic Sheet PART 2 - PRODUCTS 2.1 FIRE EXTINGUISHER CABINET Recessed type with flat trim of size and design shown. 2.2 FABRICATION A. Form body of cabinet from 0.9 mm (0.0359 inch) thick sheet steel. B. Fabricate door and trim from 1.2 mm (0.0478 in

6、ch) thick sheet steel with all face joints fully welded and ground smooth. 1. Glaze doors with 6 mm (1/4 inch) thick ASTM D4802, clear acrylic sheet, Category B-1, Finish 1. 2. Design doors to open 180 degrees. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from

7、 IHS-,-,-11-11 10 44 13 - 2 3. Provide continuous hinge, pull handle, and adjustable roller catch. 2.3 FINISH A. Finish interior of cabinet body with baked-on semigloss white enamel. B. Finish door, frame with manufacturers standard baked-on prime coat suitable for field painting. PART 3 - EXECUTION

8、 A. Install fire extinguisher cabinets in prepared openings and secure in accordance with manufacturers instructions. B. Install cabinet so that bottom of cabinet is 975 mm (39 inches) above finished floor. - - - E N D - - - Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-