UL 510-2005 UL Standard for Safety Polyvinyl Chloride Polyethylene and Rubber Insulating Tape (Eighth Edition Reprint with Revisions Through and Including July 09 2013)《聚氯乙烯、聚乙烯和橡胶.pdf
《UL 510-2005 UL Standard for Safety Polyvinyl Chloride Polyethylene and Rubber Insulating Tape (Eighth Edition Reprint with Revisions Through and Including July 09 2013)《聚氯乙烯、聚乙烯和橡胶.pdf》由会员分享,可在线阅读,更多相关《UL 510-2005 UL Standard for Safety Polyvinyl Chloride Polyethylene and Rubber Insulating Tape (Eighth Edition Reprint with Revisions Through and Including July 09 2013)《聚氯乙烯、聚乙烯和橡胶.pdf(30页珍藏版)》请在麦多课文档分享上搜索。
1、UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL UL 510 Polyvinyl Chloride, Polyethylene, and Rubber Insulating TapeUL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM ULUL COPYRIGHTED MATER
2、IAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL UL Standard for Safety for Polyvinyl Chloride, Polyethylene, and Rubber Insulating Tape, UL 510 Eighth Edition, Dated February 10, 2005 Summary of Topics These revisions to UL 510 include an Amendment of Dielectri
3、c Strength for Silicone Materials. Text that has been changed in any manner or impacted by ULs electronic publishing system is marked with a vertical line in the margin. Changes in requirements are marked with a vertical line in the margin and are followed by an effective date note indicating the da
4、te of publication or the date on which the changed requirement becomes effective. The new and revised requirements are substantially in accordance with Proposal(s) on this subject dated September 12, 2012 and April 2, 2013. All rights reserved. No part of this publication may be reproduced, stored i
5、n a retrieval system, or transmitted in any form by any means, electronic, mechanical photocopying, recording, or otherwise without prior permission of UL. UL provides this Standard as is without warranty of any kind, either expressed or implied, including but not limited to, the implied warranties
6、of merchantability or tness for any purpose. In no event will UL be liable for any special, incidental, consequential, indirect or similar damages, including loss of prots, lost savings, loss of data, or any other damages arising out of the use of or the inability to use this Standard, even if UL or
7、 an authorized UL representative has been advised of the possibility of such damage. In no event shall ULs liability for any damage ever exceed the price paid for this Standard, regardless of the form of the claim. Users of the electronic versions of ULs Standards for Safety agree to defend, indemni
8、fy, and hold UL harmless from and against any loss, expense, liability, damage, claim, or judgment (including reasonable attorneys fees) resulting from any error or deviation introduced while purchaser is storing an electronic Standard on the purchasers computer system. The requirements in this Stan
9、dard are now in effect, except for those paragraphs, sections, tables, gures, and/or other elements of the Standard having future effective dates as indicated in the note following the affected item. The prior text for requirements that have been revised and that have a future effective date are loc
10、ated after the Standard, and are preceded by a SUPERSEDED REQUIREMENTS notice. JULY 9, 2013 UL 510 tr1UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL JULY 9, 2013 UL 510 tr2 No Text on This PageUL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURT
11、HER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL FEBRUARY 10, 2005 (Title Page Reprinted: July 9, 2013) 1 UL 510 Standard for Polyvinyl Chloride, Polyethylene and Rubber Insulating Tape The rst, second, third, fourth, fth, and sixth editions were titled Electrical Insulating Tape. First E
12、dition March, 1954 Second Edition February, 1971 Third Edition June, 1971 Fourth Edition August, 1976 Fifth Edition January, 1982 Sixth Edition October, 1986 Seventh Edition June, 1994 Eighth Edition February 10, 2005 This UL Standard for Safety consists of the Eighth Edition including revisions thr
13、ough July 9, 2013. The Department of Defense (DoD) has adopted UL 510 on October 10, 1979. The publication of revised pages or a new edition of this Standard will not invalidate the DoD adoption. Comments or proposals for revisions on any part of the Standard may be submitted to UL at any time. Prop
14、osals should be submitted via a Proposal Request in ULs On-Line Collaborative Standards Development System (CSDS) at http:/. ULs Standards for Safety are copyrighted by UL. Neither a printed nor electronic copy of a Standard should be altered in any way. All of ULs Standards and all copyrights, owne
15、rships, and rights regarding those Standards shall remain the sole and exclusive property of UL. COPYRIGHT 2013 UNDERWRITERS LABORATORIES INC.UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL APRIL 30, 2008 POLYVINYL CHLORIDE, POLYETHYLENE, AN
16、D RUBBER INSULATING TAPE - UL 510 2 No Text on This PageUL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL CONTENTS INTRODUCTION 1 Scope .4 2 Components 4 3 Units of Measurement .4 4 Referenced Publications .5 ALL TAPES 5 General 5 6 Flame Test
17、 .6 7 Sunlight Resistance Test .10 THERMOPLASTIC TAPE 8 Thickness .10 9 Physical Properties Tests .11 10 Dielectric Breakdown Test .11 11 Test for Adhesion Strength .11 12 Moisture Absorption Test 12 13 Exposure to Heat Test 12 14 Exposure to Cold Test .14 15 Deformation Test .14 16 Storage Test .16
18、 17 Test for Indirect Measurement of Conductor Corrosion 16 RUBBER TAPE 18 Compound 16A 19 Thickness 16A 20 Separator .16A 20.1 Material, position, and coverage 16A 20.2 Sticking and unraveling tendency .16A 21 Physical Properties Tests .16A 22 Storage Test 16B 23 Dielectric Breakdown Test .17 MARKI
19、NGS 24 General 18 APPENDIX A Standards for ComponentsA1 JULY 9, 2013 POLYVINYL CHLORIDE, POLYETHYLENE, AND RUBBER INSULATING TAPE - UL 510 3UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION OR DISTRIBUTION WITHOUT PERMISSION FROM UL INTRODUCTION 1 Scope 1.1 This Standard covers thermop
20、lastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code ANSI/NFPA 70. It is intended that rubber tape on a joint or splice be mechanically protec
21、ted by a covering such as friction tape. Thermoplastic tape is acceptable without the additional mechanical protection. 1.2 The characteristic constituent of the thermoplastic tape covered in this Standard is either PVC (polyvinyl chloride or a copolymer of vinyl chloride and vinyl acetate), or PE (
22、thermoplastic polyethylene). For the characteristic constituent(s) of rubber tape, see 18.1. 2 Components 2.1 Except as indicated in 2.2, a component of a product covered by this standard shall comply with the requirements for that component. See Appendix A for a list of standards covering component
23、s used in the products covered by this standard. 2.2 A component is not required to comply with a specic requirement that: a) Involves a feature or characteristic not required in the application of the component in the product covered by this standard, or b) Is superseded by a requirement in this st
24、andard. 2.3 A component shall be used in accordance with its rating established for the intended conditions of use. 2.4 Specic components are incomplete in construction features or restricted in performance capabilities. Such components are intended for use only under limited conditions, such as cer
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- UL5102005ULSTANDARDFORSAFETYPOLYVINYLCHLORIDEPOLYETHYLENEANDRUBBERINSULATINGTAPEEIGHTHEDITIONREPRINTWITHREVISIONSTHROUGHANDINCLUDINGJULY092013
![提示](http://www.mydoc123.com/images/bang_tan.gif)
链接地址:http://www.mydoc123.com/p-1068280.html