UFC 4-510-01 CHANGE 4-2011 DESIGN MEDICAL MILITARY FACILITIES.pdf

《UFC 4-510-01 CHANGE 4-2011 DESIGN MEDICAL MILITARY FACILITIES.pdf》由会员分享，可在线阅读，更多相关《UFC 4-510-01 CHANGE 4-2011 DESIGN MEDICAL MILITARY FACILITIES.pdf（419页珍藏版）》请在麦多课文档分享上搜索。

1、UFC 4-510-01 18 February 2009 Change 4, August 2011 UNIFIED FACILITIES CRITERIA (UFC) DESIGN: MEDICAL MILITARY FACILITIES APPROVED FOR PUBLIC RELEASE; DISTRIBUTION UNLIMITED Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-UFC 4-510-01 18 February 200

2、9 Change 4, August 2011 UNIFIED FACILITIES CRITERIA (UFC) MEDICAL MILITARY FACILITIES Any copyrighted material included in this UFC is identified at its point of use. Use of the copyrighted material apart from this UFC must have the permission of the copyright holder. TRICARE MANAGEMENT ACTIVITY / P

3、ORTFOLIO PLANNING AND MANAGEMENT DIVISION (Preparing Activity) U.S. ARMY CORPS OF ENGINEERS NAVAL FACILITIES ENGINEERING COMMAND AIR FORCE CIVIL ENGINEER SUPPORT AGENCY Record of Changes (changes are indicated by 1 . /1/) Change No. Date Location 1 April 13, 2009 Added missing portion of Appendix A

4、2 July 8, 2009 Revised headings of last 2 columns in Appendix A 3 November 19, 2009 Replaced Figure 2-3 4 August 1, 2011 Chapter 4 Is now titled “Civil and Structural Design“ to reflect the actual content of the chapter. Clarifies noise and vibration criteria, and added a reference to UFC 3-450-01,

5、Noise and Vibration Control. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 Change No. Date Location 4 August 1, 2011 Chapter 5 Identifies the seismic performance and occupancy category level Empha

6、sizes that during planning and programming, the Using Military Department must: Identify post-earthquake or other emergency status for essential or critical facilities. Determine water and sewage on-site storage capacity for post-earthquake or other emergency conditions. 4 August 1, 2011 Chapter 8 I

7、ncorporates system design considerations to control and prevent waterborne pathogens, in addition to Legionella. Includes criteria to allow copper-silver ion or chlorine dioxide secondary water treatment system for Ambulatory Care Facilities, in addition to hospitals Introduces design criteria for c

8、arbon dioxide systems. Establishes criteria to protect underground medical gas lines by encasement. Includes criteria to allow use of semi-instantaneous water heaters to encourage energy and water conservation 4 August 1, 2011 Chapter 9 Clarifies and updates the list of critical care spaces. Adopts

9、NFPA99 requirements for wet procedure locations. Identifies emergency power requirements and mandates dual primary sources of power for Ambulatory Care Centers. Updates emergency generator set, fuel storage and starting equipment requirements. Mandates sound electrical engineering practices frequent

10、ly overlooked in Design Build contracts. Introduces a new (second) alternate power source configuration. 4 August 1, 2011 Chapter 11 Is updated to reflect DoD policy change October 31, 2008 regarding compliance with Architectural Barriers Act Accessibility Standard for DoD Facilities. Incorporates a

11、pplicable criteria from Appendix D. Appendix D has otherwise been deleted. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 Change No. Date Location 4 August 1, 2011 Chapter 20 Provides an enabling t

12、ool for facilities projects within the Military Health System (MHS) to more effectively achieve current requirements This is a republication of Military Handbook 1191 (2002) as a Unified Facilities Criteria document. Provided by IHSNot for ResaleNo reproduction or networking permitted without licens

13、e from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 FOREWORD The Unified Facilities Criteria (UFC) system is prescribed by MIL-STD 3007 and provides planning, design, construction, sustainment, restoration, and modernization criteria, and applies to the Military Departments, the Defen

14、se Agencies, and the DoD Field Activities in accordance with USD(AT the design of each facility must be a collaborative partnership. Specific responsibilities are addressed in various sections of this UFC. 1 - 4.1 Responsible Office. The Office of the Assistant Secretary of Defense (Health Affairs),

15、 OASD(HA), TMA/ PPMD is responsible for the general administrative management of this entire document, and has responsibility for the contents and development of criteria in collaboration with TMA/PPMD (See below). 1-4.2 Healthcare Facilities Steering Committee (HFSC). The HFSC acts as the clearance

16、 body for the technical contents of this document. This Committee is composed of members of TMA, the using Military Departments, and the Services design agents actively involved in the planning, programming, design, and Provided by IHSNot for ResaleNo reproduction or networking permitted without lic

17、ense from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 3 construction of facilities. All proposed UFC-4-510-01 criteria updates and changes may be formally submitted to the Committee for evaluation. DD Form 1426 is provided for this purpose at the end of this UFC-4-510-01. 1 - 4.3 Wai

18、vers. TMA/ PPMD has the final authority to waive UFC-4-510-01 policy, procedures, or criteria including any deviations. Requests for project specific waivers to any portion of this document must be submitted in writing by the Design Agent, with full particulars and justification, and must be fully c

19、oordinated with the using Military Department. 1-4.4 Design/Construction Agents. Title 10, Section 2851 and DoD Directive 4270.5 assigns Design/Construction Agents, for certain geographical locations, responsibility for the execution of projects from receipt of a Design Authorization from TMA/PPMD t

20、hrough the completion of construction. Design/Construction Agents are: a. The U. S. Army Corps of Engineers (USACE). The Headquarters, USACE, Defense Agencies and Support For Others Branch (CEMP- MD) is the primary USACE point of contact with TMA and is responsible for all program management issues.

21、 The USACE Medical Facilities Mandatory Center of Expertise and Standardization, Huntsville Engineering and Support Center (CEHNC-MX) is USACEs technical expert for medical design, with responsibility for concept design oversight, medical technical review of final designs, and medical design guidanc

22、e, criteria, and standards. b. The Naval Facilities Engineering Command (NAVFAC). The NAVFAC Medical Facilities Design Office (MFDO) is the Navys point of contact with TMA and technical expert for medical design and NAVFACs final decision making authority regarding technical guidance, criteria, and

23、standards on all medical projects from initiation of project to beneficial occupancy of the building. c. The Air Force Civil Engineers (AF/A7CC). Air Force Civil Engineering Construction and Engineering Division is the primary point of contact with TMA in the United Kingdom. 1-5 REFERENCED DOCUMENTS

24、. The DoD Directives, Instructions, and selected technical data, publications and standards (latest or most current editions) are referenced in the text by basic designation only and form a part of these criteria to the extent required by these references. Where references are made to MIL-HDBK-1190

25、(reference 1e), those referenced sections shall become an integral portion of this guidance. 1-6 PREDESIGN CONSIDERATIONS. Using Service shall fund and, in coordination with TMA/PPMD, prepare a Project Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

26、UFC 4-510-01 18 February 2009 Change 4, August 2011 4 Planning Package prior to the start of design. This package shall include the following documents and information, provided to TMA/PPMD by the Using Service in accordance with the DoD Medical Military Construction Timeline, Figure 2-1: 1-6.1 DD F

27、orm 1391. Describes the scope, cost, type of construction and rationale for the project. 1-6.2 Project Narrative. Summarizes the sizing decision process, siting, construction scenario, significant planning information and results. 1-6.3 Economic Analysis (EA). The Using Service will provide an econo

28、mic analysis as supporting justification of DOD medical projects with a cost over $2 million as required by DoD Instruction 7041.3 and in accordance with guidance developed by TMA/PPMD. The Economic Analysis compares mission-based alternatives and identifies the most cost-effective capital investmen

29、t. 1-6.4 Program for Design (PFD). Use the TMA/PPMD approved Program for Design (PFD) to allocate space assigned to a proposed facility. Modifications must be approved by TMA/PPMD. Include the estimated number of parking spaces as part of the Space Program. 1 - 6.5 Equipment Planning. The Using Serv

30、ice is responsible for preparing an equipment list for installed medical and dental equipment, and the associated budgeting, to support this requirement (MILCON) based on the Space and Equipment Planning System (SEPS). Equipment in Logistical category Codes E and F may be altered by the using Milita

31、ry Department if funding source requirements are not exceeded. Any increase in the funding for category Codes E and F equipment over the programmed amount of the project requires TMA/PPMD approval. 1-6.6 Project Book (PB). The PB summarizes existing site conditions and utilities, including the follo

32、wing minimum information. a. Completed site survey (Example format is provided in Figure 1-1), area maps, location maps, site location, site description (to include grades, gates, etc), style of architecture, construction season limitations, seismic, wind and snow considerations, SOFA, host country

33、agreements, soil and foundation conditions, utility conditions (water, sewer, power, steam, electrical capacities and location), and site restrictions (airfield, AICUZ potential helipad approach/departure zone obstructions, floodland, rights-of-way, etc.), site security restrictions, the National Ca

34、pital Planning Commission (NCPC). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 5 b. Utility availability, including water, sewage, storm drainage, electrical power, existing fuel sources, central

35、 heat or chilled water systems, including the tap-in locations. Also include the available capacities, power service characteristics and locations, electrical distribution, water and wastewater considerations. c. Environmental impact requirements, archaeological and historical considerations, explos

36、ive ordinance locations, contaminated soil (fuel, asbestos, etc.), coastal zone considerations, wetlands and watershed considerations, threatened and endangered species considerations, water quality, air quality, asbestos contamination, protection of natural resources information, and any other Envi

37、ronmental Protection Agency (EPA) or Occupational Safety and Health Administration (OSHA) considerations necessary which might impact the MILCON project. d. Force Protection/Security requirements including contingency considerations and statement by installation commander of designee identifying app

38、ropriate threat security level wherever minimal requirements are exceeded. e. Contingency mode concept of operation where applicable. f. Fire protection considerations, such as accessibility and water supply. g. Communications Information or data systems, telephone and signal interface requirements

39、for fire, police, etc., telephone switch capacities and line availability for MILCON project, Energy and Utility Monitoring and Control System (EMCS, UMCS) interface, master antenna, cable TV and closed circuit availability, computer interface, telecommunications and all other similar or useful info

40、rmation. (THE NEED TO ASSESS AND ADDRESS THE INFRASTUCTURE FOR THE VARIOUS DIGITAL RADIOGRAPHY TECHNOLOGIES SHOULD BE ADDRESSED ALSO.) 1-6.7 Addition-Alteration Facility Information. For these projects, information is provided on the type and characteristics of existing construction, size of facilit

41、y, condition of utilities and services, existence of significant known code or safety issues, and descriptions of previous alterations or additions of significance. 1-7 DESIGN CONSIDERATIONS. 1-7.1 Economic Feasibility. Project designs must be functional, aesthetically pleasing, and cost effective t

42、o acquire, maintain, and operate. The goal of every design is to provide the most functional, life-cycle cost-effective, maintainable, design possible within the available funds. 1-7.1.1 Cost estimates during design for building systems and casework shall be based on Figure 1-2. Logistical responsib

43、ility is explained in Section 15 and in the glossary. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-UFC 4-510-01 18 February 2009 Change 4, August 2011 6 1-7.2 Planning Procedures for the National Capital Region (NCR). Planning for all facilities i

44、n the NCR shall comply with MIL-HDBK-1190 (reference 1e) and OMB Circular A-11 (reference 3r). Master plans for facilities in the NCR shall be submitted to the National Capital Planning Commission (NCPC) or the Commission of Fine Arts (CFA), or both, as required by the policies issued by the Commiss

45、ions. The NCR is defined as the District of Columbia; Prince Georges and Montgomery Counties in Maryland; Arlington, Fairfax, Loudoun and Prince William Counties in Virginia; and all cities and towns within the outer boundaries of the foregoing counties. 1-7.3 Future Expansion. Incorporate considera

46、tions for future expansion into all designs. Consider both external and internal expansion of vital functions such as ancillary and utility services. Building siting, vehicular access, structural systems, departmental adjacencies, functional layouts within departments, and utility type and source al

47、l play major roles in developing an economically expandable design. Provision for future vertical expansion is authorized when approved by TMA/PPMD. 1-7.4 Construction Quality. Facilities shall be designed and constructed to provide a well-built and enduring product at the lowest practicable life cy

48、cle cost. Specific criteria for individual spaces are set forth in Appendix A. Materials used in design and construction of overseas projects shall be in character with materials, techniques, and methodologies used for similar structures in that country unless, in the opinion of TMA/ PPMD, the Desig

49、n Agent and the using Military Department, U.S. standards should prevail. 1-7.5 Environmental Quality. Congressional and administrative guidance for general policies regarding environmental quality is provided in MIL-HDBK-1190 (reference 1e). Additionally, comply with all Service specific requirements for envir