1、NOTICE OF ADOPTION ADOPTION NOTICE 1 2 October 1990 for 13 April 1990 ANSI/AIIM MS46-1990 Non-Government Standard, ANSI/AIIM MS46-1990, adopted on 2 October 1990 is approved for use by all Department of Defense (DoD) activities. The Association for Information and Image Management (AIIM) , Committee
2、 C7, prepared this non-Government standard. The American National Standards Institute (ANSI) and AIIM have both furnished clearances required by existing regulations. The Naval Publications and Forms Center (NPFC) , Standardization Documents Order Desk, Bldg 4D, 700 Robbins Ave, Philadelphia PA 1911
3、1-5094 stocks this non-Government standard for issue to DoD activities only. All other users must order copies from: Association for Information and Image Management 1100 Wayne Avenue, Suite 1100 Silver Spring, MD 20910 Telephone (301) 587-8202 Title of Standard: Test Procedure for Duplicating 35mm
4、Diazo Microfilm Aperture Cards Date of Specific Issue Adopted: 13 April 1990 Releasing Non-Government Standards Body: AIIM NOTES: When reaffirmation, revision, or cancellation of this non-Government standard is applicable, AIIM shall inform the military coordinating activity of the specific action a
5、nd request their participation. Contractual application of this non-Government Standard should include the following statement: “Use of this non-Government Standard is subject to all requirements and limitations of MIL-M-9868D9 Microfilming of Engineering Documents, 35mm Requirements For.“ Custodian
6、s : Air Force - 16 Army - CR Navy - AS DLA - DH Military Coordinating Activity Air Force - 16 (Project No. EDRS-0144) Review Activities: Air Force - 11, 14, 18, 19 Army - AR, AT, MI, SC Navy - SA, SH, TD DLA - CS, ES, GS, IS AREA EDRS DISTRIBUTION STATEMENT A. Approved for public release; distributi
7、on is un1 imi ted. AIIM 1996 Addendum ANSI/AIIM MS46-1990 Test Procedure for Duplicating 35 mxn Diazo Microfilm Aperture Cards Approved as an addendum to an American National Standard: February 16,1996 Purpose The purpose of this addendum is to provide updated information for ANSUAIIM MS46-I 990, Te
8、st Procedure for Duplicating 35 mm Diazo Microfilm Aperture Cards. Clauses that include changes are the Foreword (Clause O), References (Clause 2), and Definitions (Clause 3). Please note that although no new definitions have been added to Definitions (Clause 3), the introductory paragraph has been
9、modified. Refer to ANSIIAIiM MS46- 1990 for information not updated in this addendum. Foreword - new Standards Board Suggestions for improvement of this Standard Recommended Practice are welcome. They should be sent to the Chair of the AIM Standards Board, Association for Information and Image Manag
10、ement International, 1100 Wayne Avenue, Suite 1 100, Silver Spring, MD 20910-5603. The AIIM Standards Board had the following members at the time it approved this - addendum: Name of Representative Judy Kilpatrick, Chair Jewel M. Drass John C. Gale Tom Heltzel Bruce A. Hoiroyd James Meyer Roy Pierce
11、 Charles A. Plesums Fernando L. Podio Shahzad S. Qazi Michael L. Thomas Stephen Urban oimanizationRewese nted Association for information and Image Management International Bell & Howell information Workstation Consultant Eastman Kodak Company Interleaf Xerox Corporation USAA National institute of S
12、tandards and Technology Eastman Kodak Company MSTC, Inc. Delta Information Systems Group Foreword - new committee This standard was originally approved by the Aim Committee C7 in 1990. C7 has since been combined with C11 and C4 to form C23, Micrographics Technologies. C23 had the following members a
13、t the time it approved this addendum: Name of Rewesentative Avedon, Don M., Chair Anderson, Carl J. Badal, Michael J. Bagg, Thomas C. Bramey, Richard Breslawski, Robert Case, Scott E. Cruse, Lany Dorfman, Harold H. Erickson, Eric Frey, Henry C . Fujinuma, Tony Gass, W. Camden Gershbock, Richard Jone
14、s, Virginia A. Kurokawa, Masanobu Lundquist, Carl D. Maultsby, Theresa Memtt, Tucker Neale, William Nye, Wayne Olson, Thomas G. Orlof, Walter A. Riess, Hanley L. Robinson. Mark C. Snyder, James E. Stuck, Steve M. Oreanhation ReDresented Avedon Associates, Inc. 3M Baal Associates National Institute o
15、f Standards and Technology Microseal Corporation Eastman Kodak Company Boeing Computer Services University of California Dorfinan Associates Genealogical Society of Utah AT&T Bell Labs Canon USA Deere & Company information Intemational VA Jones Associates Fuji Photo Film USA City of Los Angeles DATA
16、bank, inc. Merritt Imaging Company Inc. First Image Management Company Anacomp, Inc. 3M Department of the Army NYC Transit Authority Plymouth Co. Registry of Deeds AT&T Genealogical Society of Utah Assocktion for Inionnation and Inumo *Mgli.nt 1 100 Wayne Avenue Suite 1 100 Silver Spring, Maryland 2
17、0910-5603 Telephone 30 1-587-8202 1 AIIM MSLib 90 iOL23Y8 0500786 87T NOTE: The years within the text of MS46- 1990 may be out- of-date. Check the reference section within this addendum for updated years. 2 References All standards are subject to revision. When the following documents are superseded
18、 by an approved revision, that revision may apply. 2.1 Referenced American National Standards ANSIISO 5.2-1991BvAPM IT2.19-1994, American National Standard for photography -Density measurements pari 2 - Geometric conditions for transmission density (Replaces ANSI PH-2-19-1986). ANSI/IMMSSI -1991, Am
19、erican National Standard for micrographics - IS0 resolution test chart No. 2 - Description and use (Replaces ANSIISO 3334-1 989). 2.3 Other Referenced Publications ANSI/AIM TR2-1992, Technical report for information and image management - Glossary of imaging technology. 3 Definitions Definitions wit
20、hin ANSUAIIM MS46 apply to tem that appear in that standard. Other tem are defined in ANWHIM TR2, Technical Report For Information And Image Management - Glossary of imaging technology. 2 Approved As April 13, 1990 Asmxiatiow Bor ImfomaPiom and Imago Management 1 100 Wayne Avenue, Suite 1 1 O0 Silve
21、r Spring, Maryland 2091 Q Telephone 301 /587-8202 (. AIIM MS4b 70 m 2575512 00b877L 7 m This standard ANSIIAIIM MS46-1990 Standard for Information and Image Management - Test Procedure for Duplicating 35 rnrn Diazo Microfilm Aperture Cards describes 7. a test Association for Information and Image Ma
22、nagement procedure for intimate contact and even exposure when contact printing on a duplicate card. /- AIIM MS4b 70 W 2575532 00b772 7 Table of Contents Foreword. . i 1 Scope . 1 2 References 1 2.1 Referenced American National Standards . 1 2.2 Other Referenced Publications 1 3 Definitions . 1 4 Te
23、st Aperture Cards 1 4.1 General 1 4.2 Uniform Illumination Test Card. 1 4.3 Resolution Test Card 1 5 Test Procedure . 1 5.1 Illumination,. 1 5.2 Resolution . 1 6 Evaluation . 1 6.1 Illumination., 1 6.2 Resolution . 2 6.3 Recording of Results 2 B . Figures Figure 1 Illumination-Density Patch Placemen
24、t 2 Figure 2 Resolution Target Placement . 2 Figure 3 Recording Sheet 3 Foreword (This foreword is not part of American National Standard B for Information and Image Management-Test Procedure for Duplicating 35 mm Diazo Microfilm Aperture Cards, ANSI/AIIM MS46-1990.) This document describes how to m
25、ake test cards, the procedures for testing, and the way to evaluate test findings for intimate contact and even exposure when contact print- ing on a copy card. Any suggestions for improving this stan- dard should be sent to the Chairman, AIIM Standards Board, Association for Information and Image M
26、anage- ment, 1100 Wayne Avenue, Suite 1100, Silver Spring, Maryland 20910. This standard was developed under the auspices of the AIIM Standards Board which approved it as an AIM standard. The Standards Board had the follow- ing members at the time it processed and approved this standard. Marilyn Cou
27、rtot, Chair Joseph Comiskey Don Klosterboer E. Brien Lewis Alan S. Linden Wesley Micket 0 Dale O. Rupp George Thoma Herbert J. White II I Thomas E. Berney The AIIM C7 Engineering Standards Committee had the following members at the time it prepared and approved this standard. Organization Representa
28、tive 3M Company City of Los Angeles City of New York Color Microimaging Corporation Deere & Company Digital Equipment Corporation Eastman Kodak Company H. L. Riess Associates IBM Corporation IMTEC Information Systems Information International, Inc. 3M Company 3M Company NCR Micrographic Systems Nort
29、hern Micrographics Pacific COM Corporation Raytheon Company TRW University of Michigan U.S. Department of Defense Individuals Barton A. Benshoof, Carl Lundquist Harold H. Dorfman Jeffry D. Fry W.C. Gass Robert Marshall Robert Breslawski Hanley Rias Joseph Comiskey Michael J. Badal Richard Gershbock
30、James Hollinger Dale O. Rupp Cecilia Colombetti Paul Vaiana Joseph Tracy Mark C. Robinson Ronald Kinney Nancy Elkington George Biach Ted Hodur Lester O. Kruger Chair American National Standard for Information and Image Management- Test Procedure for Duplicating 35 mm Diazo Microfilm Aperture Cards,
31、ANSI/AIIM MS46-1990 The patches shall be numbered from one through nine according to Figure 1. The test target layout shall be filmed at 30:l using varying exposure/illumination steps. The film frame in which al nine patches have a den- sity of 0.30 to 0.40 shall be used as the uniform illumina- tio
32、n test card. 1 Scope 4.3 Resolution Test Card This standard describes a test procedure for intimate contact and even exposure when contact printing on a duplicate card. It only deals with direct imaging diazo film duplication. The two test cards described may be produced by the user. All measurement
33、s are made in visual diffuse transmission density units. 2 References All standards are subject to revision. When the following documents are superseded by an approved revision, that revision may apply. 2.1 Referenced American National Standards ANSI PH2.19-1986. American National Standard for Photo
34、graphy-Density Measurements-Geometric Con- ditions for Transmission Density. ANSVIS0 3334-1989. American National Standard for Microcopying-IS0 Test Chart No. 2-Description and Use in Photographic Documentary Reproduction. 2.2 Other Referenced Publications AIIM TR2-1980. Information and Image Manage
35、ment Technical Report-Glossary of Micrographics. 3 Definitions Terms and phrases used in this document can be found in AIIM TR2-1980, Glossary of Micrographics. 4 Test Aperture Cards 4.1 General. The test aperture cards shall be silver gelatin originals. 4.2 Uniform Illumination Test Card. The test
36、target layout shail consist of nine patches of approximately 25 percent reflectance material. They shall be positioned in accordance with Figure 1. The gray patches shall be at least 150 mm (6 inches) square. These test cards are available from MIM. The test card shall consist of five NBS 1010 Resol
37、u- tion Test Charts on a white background and spaced as shown in Figure 2. The filmed image at 1:30 shall have a background density of 1.00 to 1.20. The resolution targets shall resolve at least 4.5 line pairs per millimeter. The targets shall be numbered from one to five and the resoIution of each
38、target recorded. 5 Test Procedure 5.1 Numination (1) Position the uniform illumination test card in the duplicator so that the silver emuIsion of the test card is in direct contact with the sensitive surface of the duplicate microfilm card. (2) Expose a duplicate card at each exposure setting. Measu
39、re the density of the center patch on each of the diazo duplicates and select the card whose center patch most closely measures to the density of the original test card, (0.30 to 0.40) as the optimum setting. (3) At the optimum setting, expose three diazo cards and record the density of each of the
40、patches. 5.2 Resolution (1) Position the resolution test card in the duplicator so that the silver gelatin emulsion of the test card is in direct contact with the sensitive surface of the duplicate card. (2) At the optimum setting, expose three diazo cards and record the resolution of each resolutio
41、n target. 6 EvaIuation 6.1 Numination. When tested in accordance with section 5.1 (3), readings exceeding 0.10 density variation from the corresponding patch on the test card indicates the need for duplicator adjustment or service. 1 -. AIIM MS4b 70 m 2575532 0068774 2 W 6.2 Resolution. Compare the
42、resolution readings on the duplicator with the corresponding targets on the test card, A loss of more than one pattern indicates a need for duplicator adjustment or service. 6.3 Recording of Results. A blank evaluation recording sheet (see Figure 3) may be duplicated and used to record results. 129.
43、5 mm (5.1 in.) 129.5 mm (5.1 in.) 129.5 mm 480.1 mm 480.1 mm (18.9 in.) (18.9 in.) (5.1 in.) - -7 w- z 1219.2 mm (48 in.) Figure 1. Illumination - Density Patch Placement Figure 2. Resolution Target Placement +* 480.1 mm 480.1 mm 129.5 mm (18.9 in.) (18.9 in.) (5.1 in.) - w4 = 1219.2 mm (48 in.) RES
44、OLUTION READINGS Test Card I 2 Duplicate Card I 2 3 s- - AIIM MSq6 90 M 2595512 0068776 6 M ANSIIAIIM MW6-1990 by Association for Information and Image Management 1100 Wayne Avenue, Suite 1100 Silver Spring, MD 20910 Tel: 301 15874202 Fa: 301 1587-271 1 ISBN-0-8925-200-6 Printed in the United States of America -+ - - -
