1、INCH-POUNDMIL-A-22262B(SH)AMENDMENT 221 March 1996SUPERSEDINGAMENDMENT 1 30 SEPTEMBER 1994MILITARY SPECIFICATIONABRASIVE BLASTING MEDIASHIP HULL BLAST CLEANINGThis amendment forms a part of MIL-A-22262B(SH), dated 5 April 1993, and isapproved for use by the Naval Sea Systems Command, Department of t
2、he Navy andis available for use by all Departments and Agencies of the Department of Defense.PAGE 32.1.2, Lines 22-30 Delete and Substitute:STATE OF CALIFORNIA DEPARTMENT OF HEALTH SERVICESCalifornia Administrative Code, Title 22, Division 4, Chapter 30, Minimum Standardsfor Management of Hazardous
3、and Extremely Hazardous Waste, Section 66261.24,Persistent and Bioaccumulative Toxic Substance, pages 660.3-660.5, Register 95. No. 25; 6-23-95.“(Application for copies should be addressed to the State of California EnvironmentalProtection Agency Department of Toxic Substances Control, Region 2, Off
4、ice of ExternalAffairs, 700 Heinz Avenue, Berkeley, CA 94710.)”California Administrative Code, Title 17, Subchapter 6, Section 92530 (CaliforniaTest Method 371-A)“(Application for copies should be addressed to the California EnvironmentalProtection Agency Air Resources Board, Compliance Division, 20
5、20 L Street, Sacramento,CA 95816.)”AMSC N/A FSC 5350DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.1 of 3Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-A-22262B(SH)AMENDMENT 2 PAGE 43.2, Line 4: Delete after “me
6、dia“ and substitute “equal or exceed 0.1 percent by weight of thematerial“.PAGE 5* 3.4.7, Line 2 and 3: Delete: “of the abrasive shall be 1.0 percent“ and substitute: “shall notexceed 1.0 percent“PAGE 63.4.12.1: Delete and substitute Parts of TABLE II:Delete:“Cobalt and/or its compounds -0.80 Maximu
7、m“Nickel and/or its compounds -0.10 Maximum“Add:“Cobalt (carcinogenic forms) and/or its carcinogenic compounds- 0.09 maximum“Nickel (carcinogenic forms) and/or its carcinogenic compounds- 0.09 maximum“PAGE 8* 3.4.12.3.2, 1st sentence: Delete “as specified in 4.6“.3.4.12.3.2, Line 8: Delete “0.005“ a
8、nd substitute “equal or exceed 0.1“.Line 14: Delete after “shall not“ to include the remainder of the sentence and substitute“equal or exceed 0.1 percent by weight of the abrasive media unless specifically stated lower inthis document (see 6.3).“3.4.14: Add after last sentence: “When feasible, a war
9、ning label conforming to 29 CFR1910.1200 (OSHA Hazard Communication Standard) shall be affixed to each package.“PAGE 144.5.11.2(b), Line 1: Delete “Freon“ and substitute “A nonozone depleting solvent“4.5.11.2(e), Line 1: Delete “Freon“ and substitute “A nonozone depleting solvent“4.5.11.3(b), Line 1
10、: Delete “Freon“ and substitute “A nonozone depleting solvent“2 of 3Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-A-22262B(SH)AMENDMENT 2 PAGE 16* 4.6: Delete in its entirety.PAGE 186.8, Line 4: Delete “and Naval Medical Command Reports“.PAGE 2
11、1* 30.1(a): Delete paragraph 30.1(a).* 30.1(d): Delete paragraph 30.1(b)The margins of this amendment are marked with an asterisk or vertical lines to indicate wherechanges (additions, modifications, corrections, deletions) from the previous amendment weremade. This was done as a convenience only an
12、d the Government assumes no liability whatsoeverfor any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate therequirements of this document based on the entire content irrespective of the marginal notationsand relationship to the last previous amendment.Preparing activity:Navy - SH(Project 5350-N039)3 of 3Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
