1、M I L-A-2 2 I6 5 (WEPI AMENDMENT-5 15 MAY 1961 SUPERS ED I NO AM EN D ME NT -4 I MARCH 1961 MILITARY SPECIFICATION AMPLIFIER, COMPASS, SERVO (TYPE MF-1 COMPASS) This mendment forms a part of Military Specifloation MIL-A-22165(Aer) of 15 August 1959, and has been approved by the Bureau of Naval Weapo
2、ns, Department of the Navy. By this amendment basic MIL-A-22165(Aer) is changed to read MIL-A-22165(Wep). . Page 3: indicators and a vernier calibrated in 0.1 degree“. Paragraph 3.5 DeSiRn and Constmotion.- Revime third sentence to read: “The cam compensator shall have visual compensated and uncompe
3、nsated Page 4: of this paragraph: Paragraph 3.12 Dial Markln4.- Add the following sentence and table to the end “The dimensions of the dial markings shall be as follows: Numerals, Letters loo Graduations 5“ Graduations lo Graduations Compensated Dial Uncompensated Dial Height or Length Wide Height o
4、r Length Width Inch Inoh f.002 Inch Inch f.002 .O70 .o12 0070 .o12 .125 .125 .O78 . O10 .O06 .O06 O94 .O94 .O62 . O10 .o06 .O06 Numerals “O“ and “1“ Graduations 6th Graduation All others . Vernier Inch Inch f .O02 Height or Length Wide .O62 .O60 .O60 O46 .o12 .o10 .O06 .O06 Page 5: Delete Figure 1 a
5、nd substitute neu Figure 1 attached. Page 7: Add paragraph 4.3.2: Authorization.- Requests for authorization for Qualification Tests shall be addressed to the Bureau of Naval Weapons, Department of the Navy, Washington 25, D. C., the qualifying agenog. . Provided by IHSNot for ResaleNo reproduction
6、or networking permitted without license from IHS-,-,-. - MIL-A-22165 (5) 66 m 7777906 0130802 O m . I_- I * - MIL-A-22165(Wep I AMENDMENT- 5 “O“ t.000 4.562-.005 DIA. L- 5.500“Oo5 DIA. Figure 1 Compensated and Unowipensated Dials and Vernier c Provided by IHSNot for ResaleNo reproduction or networki
7、ng permitted without license from IHS-,-,-MIL-A-22L65 (5) 66 W 7777706 OL3003 2 MIL-A-22165( Wep 1 AMENDMENT- 5 “k; _+10“in two places. change the value “18.8 3 4“ to “188 2 40“. Under Resistance (Ohms) opposite Pin Designations “J2004-32 to 52004-33 (m EI my)“ - Page 11: Paragraph 4.7.3 Dielectric
8、StrenRth.- Add the following as the last sentence: Insulation breakdown shall be defined as an alternating current leakage impedanoe of less than 200,000 ohms, or a leakage ourrent or 2.5 milliamperes. Page 12: Paragraph 4.7.5.3 Latitude Correction VoltaRe ReRu1ation.- In the first and last sentence
9、s, change the voltage value from “9.0 volts do“ to 9.5 volts do“. Page 14: read: not change more than 10 mv from the preceding null voltage reading.“ Page 14: read: not change more than 50 mv from the preceding null voltage reading. Paragraph 4.7.6.7.1.1 (Type I Only) Seotion c.- Change 8econd sente
10、nce to Eaah successive null voltage reading between J2OO4-Zl to 52004-22 shall Paragraph 4.7.6.7.1.2 (Type II Only) Seotion (01.- Change second sentenoe to “Each successive null voltage reading between J2004-35nto 52004-34 shall Page 15: “600 milllvoltsn to 5 volts . Paragraph 4.7.6.7.k.2 (Type II O
11、nly).- In seotlon (a) change the voltage Page 15: “600 millivoltsn to 5 volts“. Page 15: read: millivolts .“ Paragraph 9.7.6.7.5.2 (Type II Only).- In section (a) change the voltage Paragraph 4.7.6.7.6.1 (Type I Only).- In section (c) Eevise last sentence to “The voltage from 52004-Zl to 52004-22 sh
12、all not be greater than 10 Page 17: the figures “5.6 fl.4n to “6.3 f 2.1“. Paragraph 4.7.9.1 Fast Sgnchronizat1on.- In bath seotions (a) and (b) change Page 17: “At the end of the 4 hour period and uith the temperature maintained at 71 C (160F), the ampllrier shall be subjected to and meet the requi
13、rements of the following sections. Paragraph 4.7.13 HiRh Temperature Operation.- Revise fourth sentence to read: (a) Section 4.7.6.4 (b) Seotlon 4.7.6.5 (cl Section 4.7l6.6 (d) Section 4.7.6.7.1 Null, except as follows: Section 4.7.6.7.1.1 (Type I Only) - The null voltages in each part shall be (a)
14、20 mv, (b) 25 mv, and (0) 40 mv . Section 4.7.6.7.1.2 (Type II Only) - The null voltages in each part shall be , (a) 80 mv, (b) 90 mv, and (cl 160 mv . (e) Section 4.7.6.7.2 Sensitivity, Phase and Limits, exaept as follows: Section 4.7.6.7.2.1 (Type I Only) - The voltage in part (a) shall be .660 i
15、.l3 at a phase of 7 i 4 degrees. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-b MIL-A-22165 (5) 66 3939306 0130804 4 m I MIL-A-22165( WOP) AMENDMENT- 5 Section 4.7.6.7.2.2 (Type II hlg) - The voltaga in part (a) shall be 5.9 i .9 at a phase of 20
16、f 6 degrees. (i) Section 4.7.6.7.3, gxoept as follows: Section 4.7.6.7.3.1 (Type I Only) - The voltage in part (a) shall be :660 f Seotion 4.7.6.7.3.2 (TYPO II Only1 - The voltage in part (a) shall be 5.9 f (g) Section 4.7.8.1 (h) .I3 at a phase of -173 f 4 degrees. .9 at a phase of -200 I6 degrees.
17、 Section 4.7.8.2.1 - (Except in part (a) the 8em0 repeater nitoryn dial pointer shall move to zero degrees f 1.0 degree. - (Except in parts (a) and (b) the repeater autosp 180 degrees f 70 degrees. (j) Section 4.7.10“ Paragraph 4.7.l.4 Low Temperature Operation.- Revise fifth sentence to read: Page
18、17: “At the end of the 4 hour period and with the temperature maintained at -54“ C (-65OF), the amplifier ehall be subjected to and meet the requirements of the following sect ions : (a) Section 4.7.6.4 (b) Section 4.7.6.5 (cl Section 4.7.6.6 (d) Section 4.7.6.7.1 Null, except as follows: Section 4.
19、7.6.7.1.1 (Type I Only) - The null voltages in each part shall be Section 4.7.6.7.1.2 (Type II Only) - The null voltages in each part shall be (e) Section 4.7.6.7.2 Sensitivity, Phase and Llmits, except as follows: Section 4.7.6.7.2.1 (Type I Only) - The voltage in part (a) shall be .660 f .l3 at a
20、phase of 7 f 4 degrees. Section 4.7.6.7.2.2 (Type II Onlyl - The voltage in part (a) shall be 5.9 f .9 at a phase of 20 f 6 degrees. (i) Section 4.7.6.7.3, except as follows: Section 4.7.6.7.3.1 (Type I Only) - The voltage in part (a) shall be .660 f Seotion 4.7.6.7.3.2 (Type II Only) - The voltage
21、in part (a) shall be 5.9 f (a) 20 mv, (bl 25 mv, and (c) 40 mv . (a) 80 mv, Ib) 90 mv, and (cl 160 mv . .i3 at a phase of -173 f 4 degrees. .9 at a phase of -200 k 6 d egrees. , 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-HIL-A-22165( Yep) AHEN
22、DMENT- 5 (6) Section 4.7.8.1 (h) Section 4.7.8.2.1 - (Except In part (c) the servo repeater autosyn dial pointer shal move to zero degree8 f 1.0 degree). - (Except In parts (a) and (b) the repeater autosyn 180 degrees f 70 degrees). (j) Section h.7.10“ Paragraph 4.7.15 High Temperature Exposure.- Re
23、vise sixth sentence to read Page 18: the same as the change for Paregraph 4.7.13 (above). Page 18: the same as the change for Paragraph 4.7.14 (above). Paragraph 4.7.16 Low Temperature Exposure.- Revise third sentence to read Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
