欢迎来到麦多课文档分享! | 帮助中心 海量文档,免费浏览,给你所需,享你所想!
麦多课文档分享
全部分类
  • 标准规范>
  • 教学课件>
  • 考试资料>
  • 办公文档>
  • 学术论文>
  • 行业资料>
  • 易语言源码>
  • ImageVerifierCode 换一换
    首页 麦多课文档分享 > 资源分类 > PDF文档下载
    分享到微信 分享到微博 分享到QQ空间

    ETSI ETR 324-1996 Universal Personal Telecommunication (UPT) Authentication Alogarithm for Phase 1 Requirements Specification《全球个人通信(UPT) 第1阶段的认证算法 要求规范》.pdf

    • 资源ID:731780       资源大小:181.67KB        全文页数:9页
    • 资源格式: PDF        下载积分:10000积分
    快捷下载 游客一键下载
    账号登录下载
    微信登录下载
    二维码
    微信扫一扫登录
    下载资源需要10000积分(如需开发票,请勿充值!)
    邮箱/手机:
    温馨提示:
    如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
    如需开发票,请勿充值!如填写123,账号就是123,密码也是123。
    支付方式: 支付宝扫码支付    微信扫码支付   
    验证码:   换一换

    加入VIP,交流精品资源
     
    账号:
    密码:
    验证码:   换一换
      忘记密码?
        
    友情提示
    2、PDF文件下载后,可能会被浏览器默认打开,此种情况可以点击浏览器菜单,保存网页到桌面,就可以正常下载了。
    3、本站不支持迅雷下载,请使用电脑自带的IE浏览器,或者360浏览器、谷歌浏览器下载即可。
    4、本站资源下载后的文档和图纸-无水印,预览文档经过压缩,下载后原文更清晰。
    5、试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。

    ETSI ETR 324-1996 Universal Personal Telecommunication (UPT) Authentication Alogarithm for Phase 1 Requirements Specification《全球个人通信(UPT) 第1阶段的认证算法 要求规范》.pdf

    1、STD-ETSI ETR 32q-ENGL L99b 3400855 0157740 289 ETSI TEct CA REPORT ETR 324 December 1996 Source: ETSI TGNA Reference: DTWNA-007012 ICs: 33.020 Key words: UPT, security Universal Personal Telecommunication (UPT); Authentication algorithm for Phase 1 ; Requirements specification ETSI European Telecomm

    2、unications Standards Institute ETSI Secretariat Postal address: F-O6921 Sophia Antipolis CEDEX - FRANCE Office address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE X.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariata etsi.fr Tel.: +33 4 92 94 42 O0 - Fax: +33 4 93 6

    3、5 47 16 Copyright Notificatlon: No pari may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in ali media. Q European Telecommunications Standards institute 1996. All rights reserved. _ _ STD.ETS1 ETR 324-ENGL L99b 3400855 O

    4、L5994L 115 Page 2 ETR 324: December 1996 Whilst every care has been taken in the preparation and publication of this document, errors in content, typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to “ETSI Editing and Committee Support Dept.“ at the add

    5、ress shown on the title page. Page 3 ETR 324: December 1996 STD-ETSI ETR 32V-ENGL 377b 3400855 0157942 051 Contents Foreword . 5 Scope 7 References 7 Algorithm parametets 7 Strength . 7 Algorithm confidentiality 7 Algorithm distribution . 7 Dimensioning constraints 8 Acceptance criteria 8 Algorithm

    6、presentation 8 History 9 STD-ETSI ETR 32Li-ENGL L77b 3LiU855 01577Li3 T7 = Page 4 ETR 324: December 1996 Blank page Foreword This ETSI Technical Report (ETR) has been produced by the Network Aspects (NA) Technical Committee of the European Telecommunications Standards Institute (ETSI). ETRs are info

    7、rmative documents resulting from ETSI studies which are not appropriate for European Telecommunication Standard (ETS) or Interim European Telecommunication Standard (I-ETS) status. An ETR may be used to publish material which is either of an informative nature, relating to the use or the application

    8、 of ETSs or I-ETSs, or which is immature and not yet suitable for formal adoption as an ETS or an I-ETS. This ETR was prepared in 1992. - - STD-ETSI ETR 324-ENGL 199b m 3400855 0159945 BbO m Page 6 ETR 324: December 1996 Blank page - - - STD-ETSI ETR 32Li-ENGL 177b 3400855 O15774b 7T7 Page 7 ETR 324

    9、: December 1996 1 Scope This ETSI Technical Report (ETR) provides a requirements specification on the Universal Personal Telecommunication (UPT) authentication algorithm for Phase 1. The algorithm is a secret-keyed one-way function, and is to be used for the non-interactive authentication of the UPT

    10、 users for Phase 1 , using the procedures defined in ETS 300 391 -1 111. Although it is primarily intended for Phase 1, the algorithm is specified in such a way that it should also be possible to use it in an interactive way in Phase 2. 2 References This ETR incorporates by dated or undated referenc

    11、e, provisions from other publications. These references are cited at the appropriate places in the text and the publications are listed below. For dated references subsequent amendments to, or revisions of, any of these publications apply to this ETR only when incorporated in it by amendment or revi

    12、sion. For undated references the latest edition of the publication referred to applies. ETS 300 391 -1 : “Universal Personal Telecommunication (UPT); Specification of the security architecture for UPT phase 1; Part 1: Specification“. 3 Algorithm parameters The algorithm parameters are as follows: -

    13、Input: 64 bits labelled XO to X63; - Output: 32 bits labelled YO to Y31; - Key: 128 bits labelled KO to K127. The input will be a non-repeating number generated by the UPT device (counter). The mapping from the counter value into the bits XO to X63 is described in ETS 300 391-1 l. When the UPT devic

    14、e is a DTMF generator, the output value is to be converted into a Dual Tone Multi-Frequency (DTMF) signal for transmission across the network. The mapping from the bits YO to Y31 into the DTMF characters is described in ETS 300 391-1 l. 4 Strength For any set of inputs, it shall bexomputationally un

    15、feasible to use the knowledge of the corresponding outputs under an unknown key to deduce the key, or to deduce the output corresponding to any additional input value. 5 Algorithm confidentiality The algorithm specification will be kept confidential (.e. not published). The algorithm will be made av

    16、ailable to the service providers and to those who need to know how to implement the standard, but will not be published as part of this ETR, or be publicly available. 6 Algorithm distribution An algorithm custodian, appointed by ETSI, will be entrusted with the algorithm distribution. Anyone receivi

    17、ng a copy of the algorithm specification will have to sign a non disclosure and restricted usage undertaking. Page a STD-ETSI ETR 32Li-ENGL 377b 3i00855 0357747 b33 ETR 324: December 1996 7 Dimensioning constraints A software oriented solution is preferred, with the following constraints: SPEED: 100

    18、 milliseconds maximum (inputloutput non included) on a 6 805 family of microprocessors, e.g. the Motorola SC21 series, with a 4 MHz clock; ROM: 1 O00 bytes maximum (if possible 500 bytes); RAM: 64 bytes. It should be feasible to implement the algorithm in a smart card. 8 Acceptance criteria The desi

    19、gn and the evaluation work will be done under the control of the ETSVSAGE group, which is responsible for the final approval of the algorithm. 9 Algorithm presentation ETSVSAGE will produce two documents: 1) the algorithm specification, which will be kept secret and will consist of: - a word mathema

    20、tical description of the algorithm; - conformance test vectors; - PascallC sample implementations; - dimensioning/performance estimates; 2) a final report to Network Aspects Technical Committee containing some dimensioninglperformance estimates. STD*ETSI ETR 324-ENGL L77b B 3400855 OL57748 57T B December 1996 Page 9 First Edition ETR 324: December 1996 History ISBN 2-7437-1 149-3 Dpt lgal : Decembre 1996


    注意事项

    本文(ETSI ETR 324-1996 Universal Personal Telecommunication (UPT) Authentication Alogarithm for Phase 1 Requirements Specification《全球个人通信(UPT) 第1阶段的认证算法 要求规范》.pdf)为本站会员(towelfact221)主动上传,麦多课文档分享仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文档分享(点击联系客服),我们立即给予删除!




    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - 网站客服 - 联系我们

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1 

    收起
    展开